蜗壳式离心泵外特性仿真与实验研究

为探索不同仿真方法的适用性,对ns=157的单级蜗壳离心泵不同工况的扬程和效率进行定常和非定常计算,并分别分析了定常计算时不同叶片夹角及非定常计算时不同时间步长的影响,通过与实验对比,得到的主要结论有:定常计算仅适用于额定工况外特性仿真,其扬程和效率计算误差分别为4.9%和2.9%,而定常多相位的计算误差分别为7.1%和3.2%;非定常仿真计算时,以4°为时间步长,并间隔20°保存一次计算数据,较好地预测出扬程曲线走势,额定工况扬程和效率计算误差约1.1%和1.8%,但小流量和大流量区间扬程计算误差达到10%左右。因此在水力优化设计时,若只关注高效点位置及其扬程和效率,可采用定常计算,若还关注扬程曲线走势,则应采用非定常计算。     

Experimental investigation on the transport of different fish species in a jet fish pump

A jet fish pump with a throat of ø60 mm was designed to study its performance in the transport of different fish species and the physiological changes in fish thereafter. Experiments were conducted to investigate the fish transport rate and energy required to transport each ton of fish when transporting Carassius auratus, commonly known as the Chinese goldfish, Megalobrama amblycephala, or Wuchang bream, and Ctenopharyngodon idella, the grass carp. Fish were examined for external injuries as well as for several important enzymes and hormones which are indicators of tissue injury and stress. The results showed that the transport rate for all three species of fish rose dramatically with an increase in the primary stream rate. In this experiment, the transport rates of C. auratus, M. amblycephala and C. idella reached 2357 ± 37.2 kg ∙ h⁻¹, 2888 ± 41.6 kg ∙ h⁻¹, and 2060 ± 40.2 kg ∙ h⁻¹, respectively. However, both injury rate and energy required to transport each ton of fish increased no matter whether the primary stream rate was too low or too high. Considering both transport rate and injury rate, the mean primary stream rate of 80 m³ ∙ h⁻¹ was determined to be the optimal operating condition in this experiment. Fish were stressed and most likely some of their organs were damaged. However, most physiological indexes almost fully recovered after several hours.     

菠萝蜜种子淀粉制备香草兰微胶囊的工艺研究

以菠萝蜜种子淀粉为壁材,采用饱和水溶液法制备香草兰精油微胶囊,以包埋产率为指标,采用响应面分析法对微胶囊的包埋条件进行优化探讨。结果表明:5个单因素中,影响最显著的因素为壁芯材比例、包埋温度和包埋时间。响应面优化得到香草兰精油微胶囊的最佳工艺条件为壁芯材比例为7.5∶1;包埋时间72 min;包埋温度54℃,此条件下的包埋产率为(95.46±0.2)%,包埋率为(76.35±0.6)%,载油量为(27.73±0.3)%。试验证明,此条件结果与模型预测值相吻合,此工艺条件可为菠萝蜜种子淀粉包埋香草兰精油微胶囊工艺提供理论依据。     

抗白粉病胡麻种质资源田间鉴定与筛选

白粉病目前已成为影响胡麻产量和质量最常见的病害之一, 种植抗病品种是防控病害最经济环保的有效措施, 然而抗病亲本材料的缺乏已成为制约抗病品种选育的关键因素。为筛选出抗白粉病胡麻材料, 本研究在田间自然感病的条件下, 采用病情指数法对300份国内外胡麻种质资源材料进行了抗白粉病鉴定和评价。结果表明, 所有供试材料均程度不同地感染胡麻白粉病, 无免疫材料, 仅有5份材料为中抗; 其余295份均为感病材料, 其中8份材料中感, 52份材料感病, 235份材料高度感病。本研究可为抗白粉病胡麻品种的培育及相关抗病基因的发掘提供参考。     

Replacement of fish oil in plant‐based diets for Pacific white shrimp,Litopenaeus vannamei,by stearine fish oil and palm oil

Stearine fish oil (SFO) and palm oil (PO) have emerged as promising alternatives for the replacement of fish oil (FO) in aquafeeds. This study evaluated the replacement of FO with alternative oils in practical diets for Litopenaeus vannamei. In a clear brackish water study (14.1 g/L) utilizing shrimp (0.29 ± 0.02 g, initial weight), FO was replaced by SFO at inclusion ratios of 100:0, 75:25, 50:50, 25:75, and 0:100 (FO:SFO) and PO as 90% of FO. After 55 days, no significant differences (p < 0.05) in final weight, growth, or survival of shrimp were observed. A second trial (8 weeks) in low‐salinity water (2.1 g/L) with shrimp (0.92 ± 0.02 g, initial weight) evaluated diets with 100% FO, 100% SFO, 90% PO, 90% soybean oil (SO), or 90% flaxseed oil (FXO) as a replacement for FO and four commercially produced diets with 2% of FO, SO, PO, or FXO. One treatment received half rations of the commercial FO diet, and one treatment was based entirely on natural productivity. Results show that the fatty acid profiles of the tail muscle conformed to the lipids of the feed, and highly unsaturated fatty acids (HUFAs) were preserved. Following 8 weeks of culture, there were no significant differences in production performance.     

品种间大豆脂肪氧化酶活性差异及β-胡萝卜素漂白性研究

为了解东北地区大豆品种间大豆脂肪氧化酶(LOX)活性差异规律,整理适于东北地区种植的大豆种质资源307份(6份半野生品种,17份地方品种及4份国外品种,其余为栽培品种),统一种植,秋季收获后,测定各品种成熟籽粒脂肪氧化酶总活性。分析品种间脂肪氧化酶总活性分布规律、大豆脂肪氧化酶总活性与β-胡萝卜素漂白性之间关系。结果表明,307份大豆品种间脂肪氧化酶总活性差异极显著,平均值为21.68 U·mL~(-1),最小值为2.51 U·mL~(-1),最大值为42.38 U·mL~(-1)。根据脂肪氧化酶总活性差异,通过聚类分析将307份大豆品种分为3类。低活性品种占总量43.65%,脂肪氧化酶总活性平均值为15.25 U·mL~(-1);中等活性品种占总量43.97%,脂肪氧化酶活性平均值为24.64 U·mL~(-1);高活性品种占总量12.38%,脂肪氧化酶总活性平均值为33.87 U·mL~(-1)。脂肪氧化酶总活性与油分含量呈正相关,与蛋白含量呈负相关,与漂白性呈正相关。     

Engineered-airlift pumps for aquaculture applications using multiphase flow analysis

Currently, very few aquaculture operations are employing airlift pump technology for water recirculation, aeration, and waste removal. This is likely due to the poor design and lower efficiency of traditional airlift design, the limited amount of research effort that has been invested in improving performance capabilities of air lift pumps and the general lack of awareness of the industry about the inherent advantages of airlift systems. A new efficient airlift pump is hydrodynamically designed by incorporating the Volume of Fluid (VOF) multi-phase model along with the K-ε turbulence model utilizing Computational Fluid Dynamics (CFD) tools. The pump is designed to offer a substantial reduction in total energy usage as well as an improved quality of the culture products in order to make it attractive to aquaculture industry. In this study, both numerical and experimental investigations were carried out for airlift systems operating under two different submergence ratios of 50% and 90% in a lab setting using 2.54 cm diameter pumps. Also, the performance of a large-scale pumps of 10.16 cm diameters were also tested in an aquaculture raceway to determine its effect on the operation. The numerical results were found to be in agreement with the experiments within ±20% which is considered very reasonable for multiphase flow analysis. The present study was found to present a great tool for modelling the airlift pump performance, and potentially proposing new designs.     

钾肥和硅肥对油用亚麻茎秆抗倒伏特性的影响

为了优化油用亚麻抗倒伏的肥料运筹措施,以‘陇亚11号’和‘定亚23号’为试验材料,通过裂区设计,研究了钾肥（不施钾、52.5 kg K₂O/hm²和105 kg K₂O /hm² 3个水平）和硅肥（不施硅和90 kg SiO₂/hm² 2个水平）用量对油用亚麻茎秆形态学、力学抗倒伏特性及产量的影响。结果表明：‘陇亚11号’的株高、重心高度及茎粗、壁厚、抗折力均显著大于‘定亚23号’,茎秆形态学及力学抗倒伏特性的综合影响下,‘陇亚11号’较‘定亚23号’倒伏率提高21.24%而产量降低9.43%。钾肥显著改善了抗倒的茎秆表观形态学特性,施钾后茎粗、壁厚、茎秆抗折力、抗倒伏指数提高而株高和重心高度降低,千粒重和籽粒产量分别提高7.35%和9.34%。硅肥对茎秆形态学、力学特性及籽粒产量均无主效应,但硅肥与钾肥的互作使茎粗显著增加。抗倒伏指数与茎粗、壁厚呈显著正相关,与株高、重心高度呈显著负相关。品种间的茎秆抗倒伏特性差异较大,施用钾肥显著改善了抗倒的茎秆表观形态学特性,优化了茎秆机械性能,增强了油用亚麻的抗倒伏能力;供钾量较低时,硅肥与钾肥对茎粗的互作正效应明显。     

不同加工处理方式对芝麻油风味的影响研究

以传统作坊式水代法芝麻油、传统作坊式压榨芝麻油、商品芝麻油为研究对象，采用顶空固相微萃取与气质联用技术（HS-SPME-GC/MS）和聚类分析对不同芝麻油挥发性化合物进行了检测和系统对比。结果表明：通过聚类分析，发现水代芝麻油和商品芝麻油的挥发性化合物组成相似程度更高；此外，芝麻油中吡嗪类化合物、含硫杂环化合物和苯系物因不同加工处理方式的差异显示出较大变化，其中3-乙基-2,5-二甲基吡嗪、4-甲基噻唑、愈创木酚等可作为区别三种芝麻油的关键风味物质。     

叶轮出口边对双蜗壳泵压力脉动的影响

泵的叶轮扫掠蜗壳隔舌时产生的压力脉动是引起船用泵振动噪声的原因之一.为尽可能弱化这一影响,分别设计了叶片出口边与前后盖板基本面垂直和倾斜的2种不同形式叶轮,将其配置在相同的双蜗壳中,通过数值计算与样机试验相结合的手段,对蜗壳内9个不同位置的压力脉动情况进行对比分析.结果表明:出口边倾斜的叶轮相比于出口边垂直的叶轮可明显改善蜗壳内次脉动的“驼峰”现象,且可以进一步降低隔舌处主波动的压力峰值;对蜗壳内2个隔舌稍前的位置,出口边倾斜的叶轮反而会使得该点的压力系数幅值明显增大,且该点主波动的周期数发生改变;2种叶轮出口边的不同形式对蜗壳出口位置的压力脉动的影响基本相同;采用出口边倾斜叶轮对改善因叶轮与隔舌间的液流压力脉动是可行的.