基于准静态同轴探头模型的土壤复介电测量方法

末端开路同轴探头法测量土壤复介电值用于表征土壤含水率具有准确、快捷的优点。针对目前土壤介电同轴探头集总测量模型没有充分考虑探头的参数以及土壤体积对测量结果影响等问题，基于电磁场理论，对末端开路同轴探头建立了准静态数学模型，适用于土壤的复介电常数准确测量。通过全波软件仿真和模型计算结果对比，以无水乙醇介电实测值和理论值对比，验证模型的准确性。采用本文介电测量模型对不同含水率的黄绵土进行测量计算，复介电常数实部与实测土壤含水率二阶多项式拟合决定系数大于0.965，表明本文所提土壤介电测量方法适用于土壤复介电常数和含水率的测量。     

Effects of Large Saddle Panels on the Biomechanics of the Equine Back During Rising Trot: Preliminary Results

The saddle panels, directly in contact with the horse's back, are likely an important element to optimize the fitting of the saddle, the comfort of the horse, and subsequently, the pain management in dorsalgic horses. The aim of this study was to better understand the effect of the saddle panels on the horse's back, by evaluating a prototype saddle (comfort panels: CP) compared to a standard saddle (STD). The horse's back movements were measured using inertial measurement units (IMUs) fixed at the levels of thoracic vertebrae T6, T12, T16 (under the saddle) and lumbar vertebrae L2 and L5. The centers of mass (COMs) of the horse and the rider and limb's protraction-retraction angles, pressure between saddle and horse's back, and force on the stirrups were measured using respectively 2D motion capture, pressure mat and force sensors in the stirrup leather. Three horses were trotted at the rising trot (sitting: left diagonal-rider seated; standing: right diagonal-rider standing) by the same rider. To compare saddles, linear mixed-effects regression models were used. The estimated means (SE) were calculated. During sitting phase, pressure in the cranial and middle areas of the saddle significantly increased for CP compared to STD (+0.9 (0.2) kPa and +1.0 (0.1) kPa, respectively) whereas caudal pressure decreased (−1.8 (0.4) kPa). Concurrently, the range of motion of angles T12-T16 and T16-L2 under the saddle significantly increased (+1.8 (0.2)° and +2.3 (0.3)°, respectively). The results showed that modifications of the panels' shape not only affect the pressure distribution but also the kinematics of the thoracic and lumbar regions of the equine back.     

叶轮出口边对双蜗壳泵压力脉动的影响

泵的叶轮扫掠蜗壳隔舌时产生的压力脉动是引起船用泵振动噪声的原因之一.为尽可能弱化这一影响,分别设计了叶片出口边与前后盖板基本面垂直和倾斜的2种不同形式叶轮,将其配置在相同的双蜗壳中,通过数值计算与样机试验相结合的手段,对蜗壳内9个不同位置的压力脉动情况进行对比分析.结果表明:出口边倾斜的叶轮相比于出口边垂直的叶轮可明显改善蜗壳内次脉动的“驼峰”现象,且可以进一步降低隔舌处主波动的压力峰值;对蜗壳内2个隔舌稍前的位置,出口边倾斜的叶轮反而会使得该点的压力系数幅值明显增大,且该点主波动的周期数发生改变;2种叶轮出口边的不同形式对蜗壳出口位置的压力脉动的影响基本相同;采用出口边倾斜叶轮对改善因叶轮与隔舌间的液流压力脉动是可行的.     

基于模糊建模的混炼胶粘度测量

提出了一种在线测量混炼胶粘度的新方法．该方法以模糊建模技术为基础，综合考虑混炼过程各因素对胶料粘度的影响，建立起胶料粘度的在线测量模型．在模糊建模中，采用T-S模型描述胶料粘度变化的非线性过程，提出了一种基于相似性判别的模糊聚类算法以自动确定合适的聚类组数目，并用实数编码的遗传算法优化全局参数，从而获得了规则简化的、具有较高精度的模糊模型．根据此方法，设计了测量装置，并进行了现场试验．试验结果表明模糊模型输出与实验室测量值基本一致，平均误差较低且最大误差未超过1门尼．该方法较大地提高了橡胶混炼的生产效率，为粘度最优控制奠定了基础．     

Evaluation of a combined penetrometer for simultaneous measurement of penetration resistance and soil water content

A combined penetrometer is an appropriate tool to measure the soil cone resistance and the water‐content profile. As a relatively new technique, a combined capacitance‐penetrometer for the simultaneous measurement of cone index and soil water content was developed at the Department of Agricultural Engineering of Bonn University in 2002. The objective of this study was the evaluation of the effectiveness and applicability of the innovated penetrometer with a focus on three aspects: (1) A capacitance sensor with two electrode configurations was calibrated for silt loam, sandy loam, and sand. The calibration results show that both electrode configurations have sufficient water‐content sensitivity, but soil‐specific calibrations seem necessary. (2) Under laboratory conditions, the dynamic resolution and response of the capacitance‐penetrometer were validated, and its radius of influence was determined. (3) The field measurement results demonstrate that this measurement technique can be used to improve the interpretation quality of soil cone index data.     

负刚度的工作原理及应用初探

This paper deals with the vibration isolation principle of a system with a negative stiffness spring and the energy analysis for this system.As an application of the method, an example of vibration systems with equal frequencies is given. It shows that th     

钻头磨损在线监测研究

本文研究了钻头磨损对钻削过程中振动加速度信号的动态特性的影响。发现加速度信号中敏感频率分量随着钻头磨损的增加呈明显的“碟形”规律变化。我们提出用敏感频率分量的自功率谱值(PSD)作为特征量。建立了特征量与钻孔数之间的状态空间方程;提出了钻头磨损在线自适应监测方法。该方法打破了故障诊断和状态识别中设置“阈值”的传统做法;另辟蹊径。     

步进电机扭矩测量试验台系统的设计

专用电机扭矩测量仪器精度高，但价格昂贵，操作复杂，长时间使用会出现误差。步进电机扭矩测量试验台系统采用单相交流电机作负载，使用标准扭矩仪对该系统进行标定来对待测调速电机进行扭矩测量。为此，介绍了一种电机扭矩测量系统的构成与工作原理。该系统以单片机为核心，组成扭矩测量与显示系统，可以较好地实现电机扭矩在线测量，具有较好的经济效益。     

振动深松鼠道犁的试验分析

石河子及周围垦区的土壤粘重且呈盐碱性,由于犁底层的存在,土质很难得到改善。而深松作业则是打破犁底层的主要农业技术措施之一。为此,论述了IZSS-600-3型振动深松鼠道犁的构造和工作原理,分析了试验因素对试验指标的影响,为机具今后在农业生产中的应用和推广提供了依据和参考。     

微波电路电测及其计算方法

从实际工程的角度出发，对电路电测方法进行了论述。在微通信工程中，需要获得障碍物的位置和高度，最合理的天线高度组合和障碍物绕射损耗等参数，为此论述了微波电路电测方法及技术要求。在大庆－秦皇岛输油管道通信工程中采用了Ａ，Ｂ测试法进行测试，得到高度－损耗曲线。这种曲线给出相对自由空间接收电平与收，发天线高度之间的关系。在测试所得的高度－损耗曲线与断面图相结合的基础上，由绕射损耗计算公式推出了几种常见障碍