The priority of management factors for reducing the yield gap of summer maize in the north of Huang-Huai-Hai region,China

Understanding yield potential, yield gap and the priority of management factors for reducing the yield gap in current intensive maize production is essential for meeting future food demand with the limited resources. In this study, we conducted field experiments using different planting modes, which were basic productivity(CK), farmer practice(FP), high yield and high efficiency(HH), and super high yield(SH), to estimate the yield gap. Different factorial experiments(fertilizer, planting density, hybrids, and irrigation) were also conducted to evaluate the priority of individual management factors for reducing the yield gap between the different planting modes. We found significant differences between the maize yields of different planting modes. The treatments of CK, FP, HH, and SH achieved 54.26, 58.76, 65.77, and 71.99% of the yield potential, respectively. The yield gaps between three pairs: CK and FP, FP and HH, and HH and SH, were 0.76, 1.23 and 0.85 t ha~(–1), respectively. By further analyzing the priority of management factors for reducing the yield gap between FP and HH, as well as HH and SH, we found that the priorities of the management factors(contribution rates) were plant density(13.29%)fertilizer(11.95%)hybrids(8.19%)irrigation(4%) for FP to HH, and hybrids(8.94%)plant density(4.84%)fertilizer(1.91%) for HH to SH. Therefore, increasing the planting density of FP was the key factor for decreasing the yield gap between FP and HH, while choosing hybrids with density and lodging tolerance was the key factor for decreasing the yield gap between HH and SH.     

不同种植密度对机采辣椒品种性状和产量的影响

为明确不同种植密度对机采辣椒品种性状、产量的影响,以适宜机采的辣椒‘辣研102’为研究对象,设置4个种植密度（P0:38 480株/hm²、P1:51 307株/hm²、P2:76 961株/hm²、P3:102 615株/hm²）,分别于贵阳、遵义两地开展田间小区试验。结果表明,随着种植密度的增加,辣椒株高呈增加趋势,茎粗呈下降趋势。辣椒根部、地上部生物量均在高密植条件下（P3）时达到最小。辣椒的发病率与病情指数均随种植密度的增加而显著提高,高密植处理条件下（P3）达到最大,发病率分别为41.67%（贵阳）、43.33%（遵义）,病情指数分别为31.05%（贵阳）、29.86%（遵义）。过高的种植密度导致单株辣椒光合作用大幅下降:P1、P2、P3处理条件下光合速率分别较P0处理显著降低13.94%、24.73%、29.66%（遵义）;P1、P2、P3处理条件下辣椒叶片蒸腾速率较P0降低10.02%、19.81%、42.12%（贵阳）。辣椒总产量随种植密度增加而显著提高,而商品果产量随种植密度的增加呈先增加后降低的趋势。商品果产量在P1条件下获得最大值,相对于P0、P2、P3贵阳辣椒商品果产量显著提高了16.43%、32.81%、41.67%,遵义提高了20.25%、26.67%、61.02%。综合辣椒生长与商品果产量,贵州机采辣椒‘辣研102’最佳种植密度为51307株/hm²。     

陇南核桃病虫害无公害综合防治策略

针对陇南核桃栽培中病虫害发生问题进行分析论述,提出无公害综合防治策略,对陇南生态环境保护及绿色无公害核桃生产有一定指导意义。     

水稻稀播条件下不同秧龄壮秧技术

以南粳9108为试验材料,研究稀播条件下(18000苗/m₂)不同措施对30、35 d秧龄秧苗素质的影响。结果表明:在18000苗/m₂的播种密度下,多效唑浸种能够有效地促进根系生长,矮化秧苗高度,显著提高秧苗素质,对于培育不同秧龄的壮苗均有促进作用。多效唑浸种浓度在0.5 g/L左右最为适宜。     

Modelling optimal timing and frequency of insecticide sprays for knockdown in preparation for other control measures

A modelling investigation was conducted into optimizing the number of sprays and inter-spray interval to reduce an insect population to a low level, for example, prior to pheromone trapping or the release of sterile males. The model population was age-structured and density-dependent. If spray mortality is 100% for each spray, then the ideal spraying schedule is easily determined from the durations of the various life stages. For spray mortality of less than 100%, a simulation was used to determine optimal spraying schedules. Relative length of the larval period, fertility rate and age to first oviposition were found to be the most important biotic parameters for this determination. Their importance is magnified as spray mortality decreases. The stage targeted by sprays and the percent mortality caused by each spray are also important in determining the required number of sprays. Using medfly (Ceratitis capitata Wiedmann) biotic parameters as an example when the spray targets adults, it appeared that neither the stage at which density-dependent mortality takes effect, nor the form of the adult survivorship curve are important in determining the optimal spray schedule.     

花椒病虫害研究进展

花椒Zanthoxylum bungeanum是一种具有重要经济价值和药用价值的多年生香料和油料树种,国内外学者对花椒的栽培、育种等方面研究较多,而对花椒病虫害防治方面的研究较少。笔者在前人研究的基础上,通过文献分析明确花椒及其病虫害方面的研究,并对已报道的花椒病虫害、防治方法等进行了综述,以期为今后开展花椒病虫害防治相关研究提供理论支持和方向。     

不同行距配比对玉米光合生理指标及茎秆特性的影响

以‘大丰30’为试验材料,在同一密度下（75000株/hm²）设置5种不同行距配比,研究不同行距配比对玉米光合生理指标及茎秆力学特性的影响。结果表明：行距配比为40 cm×80 cm时,棒三叶的叶绿素含量(SPAD)在灌浆期达到峰值;行距配比为30 cm×90 cm时,棒三叶净光合速率在灌浆期最高。大口期开始,行距配比为40 cm×80 cm时,叶面积指数(LAI)最高。单株干物质积累量以40 cm×80 cm最高。各行距配比的茎秆硬皮穿刺强度与茎秆弯曲性能随着节位的下降均呈逐渐增强的趋势,从大到小为 40 cm×80 cm>50 cm×70 cm>30 cm×90 cm>60 cm×60 cm>20 cm×100 cm。穗长、穗粗、千粒重和穗粒数各处理间均有不同变化,行距配比为40 cm×80 cm时产量最高,比等行距60 cm×60 cm增产7.96%。由此可见,行距配比为40 cm×80 cm,有利于大穗型品种‘大丰30’的光合性能和茎秆强度的提高,从而达到抗倒伏增产的目的。     

不同种植密度对3个小豆品种植株形态及产量的影响

采用两因素随机区组设计,以直立型小豆品种冀红20、冀红21和唐红201602为材料,分析6个种植密度对不同小豆品种植株形态特征及产量性状的影响。结果表明,品种和种植密度对小豆形态特征和产量性状的影响较大;底荚高度和第一节间长随着密度的增加而增加,主茎节数、主茎分枝数、单株结荚数、单荚粒数和百粒重随着种植密度的增加而减小,产量随种植密度的增加呈先增加后减少趋势;相同品种不同种植密度间和相同种植密度不同品种间的产量差异极显著（F值分别为49.36、99.35）,品种与种植密度互作对产量的影响差异显著（F=3.91）。种植密度与株高、底荚高度呈极显著正相关,与第一节间长呈正相关,与茎粗、主茎分枝数和主茎节数呈极显著负相关。增加种植密度可增加小豆株高、底荚高度和第一节间长,有效减少主茎分枝数,有利于机械化收获。     

基于Web电子商务平台的食用菌产品共词聚类算法

针对食用菌产品电子商务平台的数据挖掘问题,采用了共词聚类算法进行主题聚类,在密度聚类算法的基础上,使用了移动非密集单元的处理方法实现了共词聚类。该算法克服了传统聚类算法裁剪造成的精度误差,提高了聚类结果的精确度,应用在电子商务平台的效果良好。     

浙江红花油茶高接换冠成活率影响因素研究

为研究浙江红花油茶高接换冠成活率影响因素,解决嫁接成活率低的问题,2013年6月从中国林业科学研究院亚热带林业研究所引进浙江红花油茶优树穗条,在青田县大垟山林场开展浙江红花油茶高接换冠试验,分析砧木林郁闭度、坡位、砧木生长势及接穗保存时间等因素对嫁接成活率的影响。结果表明,林分郁闭度在0.3~0.7之间,随着郁闭度增加嫁接平均成活率提高;郁闭度在0.7~0.9之间,随着郁闭度增加,嫁接成活率降低;当郁闭度为0.7时,嫁接成活率最高为88.8%。山腰的嫁接成活率高达86%,显著高于山顶和山脚。浙江红花油茶砧木生长势越强嫁接成活率越高。接穗于采集当天嫁接效果最好成活率达89.1%,接穗保存1、2、3、4、5、6天嫁接,成活率分别为85.2%、75.2%、51.6%、28.1%、12.2%、9.3%。偏相关分析表明,各因素对嫁接成活率影响由大到小依次为接穗保存时间(-0.97)、郁闭度(0.85)、生长势(0.81)、坡位(-0.65)。