ACQ防腐剂处理杉木小径材的研究

对利用ACQ木材防腐剂处理杉木小径材的研究结果表明,使用浓度为0.5%的ACQ对杉木小径材进行真空加压浸渍处理,可以达到较好的防腐处理效果。随着ACQ浸渍深度及保持量的增加,对试件的静曲强度和弹性模量没有明显影响,而握钉力则有下降的趋势。     

低毒防腐剂百菌清及铜制剂对木材尺寸稳定及力学性能的影响

百菌清（CTL）、氨浴季铵铜（ACQ）、氨溶柠檬酸铜（ACC）处理马尾松（Pinus massoniana)、毛白杨（Populus tomentosa)后对木材尺寸稳定性及MOE／MOR的影响本文进行了研究。结果表明，除剂量11．48kg/m^3的百菌清处理的毛白杨外，以上防腐剂处理试材后吸水至饱和时的尺寸稳定性与对照相比有不同程度的增加，幅度为3．9％－28．05；各处理对抗弯弹性模量（MOE）影响幅度不大，其中对于马尾松，MOE差异不明显，对于毛白杨，各处理对MOE稍有增加（百菌清乳剂处理除外），幅度6．3％－8．1之间。各制剂处理马尾松、毛白杨后对抗弯强度（MOR）影响不明显。     

杉木间伐材ACQ防腐与综合强化复合改性研究

在将ACQ与UF树脂调制成相容的复合改性剂对杉木间伐材进行复合改性研究的基础上,深入探索复合改性的机理与综合效果.对浸渍材与表面密实化处理相结合的优化工艺,当弦向压缩率为20%时各项力学性能指标均比素材增加51%以上;进行浸渍处理与ACQ或UF单独处理材经煮沸和抗水、酸、碱抽提的抗流失性对比试验及防腐试验,表明前者比后者有所提高;并采用铜离子跟踪法进行X-射线荧光光谱仪定量分析,测定了浸渍材复合改性剂的含量和分布情况,确认了一次性浸渍优化工艺参数的较佳效果.     

季铵铜防腐木中有效成分的流失性试验

以季铵铜防腐剂处理南方松为原材料,参照美国AWPA E11-06标准,分析不同pH值、不同温度的水环境对季铵铜防腐木中有效成分流失率的影响。结果表明:铜和DDAC的总流失率在pH 9时的碱性环境明显小于其在酸性环境下的流失率,在pH 3时,分别达到最大值40.80%和44.43%;随着温度从室温(10℃)升高到30、50℃,铜和DDAC的流失率均明显增大;在14 d的流失时间里,铜和DDAC的流失率呈现出随时间递减的规律,并且DDAC比铜更容易流失到环境中。     

Fixation Property of Copper Triazole Wood Preservatives

According to AWPA E11-2006 standard,copper fixation rates of several copper-based formulations,such as ammoniacal copper,amine copper,and ammoniacal-ethanolamine copper,as well as alkaline copper quaternary(ACQ),were tested and compared in this paper.And the fixation rates of tebuconazole(TEB) and propiconazole(PPZ) in several formulations,such as copper azole,emulsified type and solvent type,were also compared.The determination of copper content in the leachate was analyzed by atomic absorption spectrom...     

速生意大利杨木防腐与强化复合改性

采用氨溶烷基铜铵(ACQ)防腐剂与脲醛树脂(UF)调制成的相溶复合改性剂,对速生意大利杨木进行一次性真空浸渍处理,使处理材力学性能提高并达到强防腐等级.优化工艺参数为:浸渍压力0.6 MPa、加压2 h、ACQ与UF的体积比为4∶1.处理后主要力学性能指标均提高22.46%以上.对浸渍材进行表面密实化优化工艺处理(压缩率为20%),各项力学性能指标均比素材提高52%以上.对浸渍材与ACQ处理材抗水、酸、碱抽提的抗流失性进行对比试验,前者比后者固着率提高0.84%以上.应用X射-线荧光光谱仪的Cu2+跟踪法,定量分析了浸渍材复合改性剂的含量分布和改性效果.     

季铵铜防腐木中有效成分总流失率的动力学分析

以季铵铜防腐剂处理的南方松为试材,参照美国AWPA E11-06标准,分析10、30和50℃3种温度条件下防腐木中有效成分的总流失率,并基于时间-温度叠加原理,运用阿伦尼乌斯方程,进行总流失率的动力学分析.结果表明:3种温度条件下铜和DDAC的流失趋势是一致的.根据铜和DDAC总流失率,得出防腐木表面的活化能为Ea=54.59 kJ/moL,相关系数R2达到0.98以上,拟合性较好,由此证明可以用动力学分析方法预测ACQ防腐材中铜和DDAC在10～50℃温度范围内总流失率变化.     

防腐后处理工艺对竹集成材耐久性的影响

以两种水载铜基防腐剂季铵铜和铜唑对竹集成材进行防腐处理,分析了不同药剂和载药量对竹集成材耐腐性能的影响,以及不同干燥温度对处理材抗流失性能的影响,以筛选适宜的竹集成材防腐后处理工艺,显著提高处理材的耐久性.结果表明,经防腐处理后,竹集成材的耐腐性能大幅度提高,当季铵铜载药量≥2.6 kg/m3或铜唑载药量≥1.3 kg/m3时,竹集成材可以达到强耐腐等级;处理材的铜固着率随着载药量的增加而提高,不同干燥温度对铜的抗流失性能影响不显著.总体上看,防腐后处理工艺能够满足提高竹集成材耐久性能的要求,但其防腐剂的抗流失性能有待提高.     

Leaching characteristics of homologues of benzalkonium chloride from wood treated with ammoniacal copper quaternary wood preservative

In Japan, ammoniacal copper quaternary wood preservatives type-1 (ACQ-1), which contains copper and benzalkonium chloride as its active ingredients, is among the most widely used wood preservatives in the pressure treatment of wood. Benzalkonium chloride (BAC) in commercial ACQ-1 products mainly comprises C12 and C14 homologues. In the present study, the leaching characteristics of these BAC homologues were investigated using the heartwood and sapwood portions of Japanese cedar, Japanese larch, and Sakhalin fir treated with ACQ-1 and 1% monoethanolamine (MEA) solution containing equimolar amounts of homologues. Distilled water (DW) and artificial seawater (SW) were used as leaching media. Consequently, it was observed that the leaching rate of the C12 homologue tended to be higher than that of the C14 homologue in DW. The leaching of C12 homologues was accelerated by using SW, resulting in a significantly higher leaching rate than the C14 homologue using SW. It was thought that the difference in the hydrophobicities based on alkyl chain lengths resulted in these phenomena. However, when the heartwood portion of Japanese larch was treated with the homologues in MEA, the leaching rate of the C14 homologue was significantly higher than that of the C12 homologue.     

ACQ和CuAz防腐剂处理对竹材力学性能的影响

采用水溶性防腐剂季铵铜(Ammoniacal Copper Quaternary,即ACQ)和铜唑(Copper Triazole,即CuAz)对竹材进行处理,比较药剂处理前后竹材静曲强度(MOR)和抗弯弹性模量(MOE)的变化情况。SAS分析结果表明,ACQ处理前后对MOE的影响不显著,药剂的处理浓度对MOE的影响也不显著;经CuAz处理的试材,处理前后MOE差别在0.05水平显著,但是不同的药剂浓度对MOE的影响不显著。ACQ和CuAz处理对MOR影响不显著。