青稞的光合特性及光破坏防御机制

通过气体交换、荧光猝灭动力学以及反射光谱等技术研究了两个青稞(Hordeum vulgare L.)品种的光合特性及激发能分配。结果表明, 青稞的光饱和点1 000 μmol m^-2 s^-1左右。在0~500 mmol m^-2 s^-1的光强范围里, 青稞叶片的光呼吸(Pr)随着光强升高而增加; 光强超过500 mmol m^-2 s^-1以后, 光呼吸变化不明显。光呼吸占总光合的比例(P_r/P_m)随光强增强下降。随着光强增强, 光系统II开放反应中心转化效率(F_v′/F_m′), 光系统II实际光化学量子效率(Φ_PSII), 光化学猝灭系数(qP)不断降低而青稞叶片的非光化学猝灭(NPQ)持续升高, 说明越来越多的光能以热的形式耗散掉。光谱分析表明△PRI随着青稞叶片暴露于光下的时间迅速增大。因此, 光呼吸不是青稞主要的光破坏防御机制, 依赖叶黄素循环的热耗散可能是田间青稞耗散过剩光能的主要途径。     

Comparative assessment of five methods of determining sap flow in peach trees

Five different methods of determining sap flow (SF), three based on heat pulse (compensation heat pulse, New Zealand—cHP–NZ; compensation heat pulse, Greenspan/Australia—cHP–G (South oriented), and cHP–G–EW (East and West oriented, average); non-compensation heat pulse, Ariel/Israel—ncHP), one based on stem heat balance (Dynamax/USA—SHB), and another based on heat dissipation (Granier/France—HD) were compared in an experiment performed on peach trees in Northeast Spain. Two irrigation treatments (drip-irrigated) were applied: a control and a stress treatment, the latter consisting of withholding water from day 190 to 199. Between 1 and 3 different systems were installed in some trees of both, the control and stress treatments. All the techniques reflected the evolution of water stress in the stressed trees with a very similar tendency and in agreement with the evolution of predawn water potential (Ψp). Ψp correlated well with sap flow (SF) determined with all the systems (r² > 0.65) in the stress treatment, indicating that all the SF techniques detected changes in tree water status. The cHP–NZ system was the first to detect a SF reduction through the outer xylem vessels, as a response to water withholding. In control trees, daily SF rates provided by the three heat pulse and heat balance methods were well correlated with ETo and somewhat less with global radiation; all regressions improved on an hourly basis. Daily pattern and magnitude of mean SF rates monitored by the three heat pulse systems were quite similar in control trees. This was reflected by high regression coefficients when compared with each other. Higher SF rates recorded by ncHP methods in comparison with cHP–G and cHP–NZ might be attributed to technical limitations and to different sensor orientation. In an accompanying experiment, substantial differences between East and West location of the cHP–G sensors were observed, but when taking the mean value of those daily SF rates, differences between ncHP and cHP–G–EW were lower. Mean monthly crop coefficients, calculated by using SF data computed with ncHP method and soil evaporation as determined with microlysimeters, were 0.64 in July and 0.67 in August. SF systems can be used to detect plant water stress related to control, and might be useful for irrigation scheduling based on plant water status. The SF techniques analysed showed potential to better determine actual plant water necessities than other traditional methods, but a preceding calibration is needed.     

Mode-Superposition Method for Passive Energy Dissipation Structures

The methods of equivalent linearization of different energy dissipation devices are different in analyzing passive energy dissipation structure including different type of energy dissipation device by using of mode-superposition response spectrum method based on equivalent linearization, which results in the differences in computing accuracy and cost in dynamic analysis. For structures separately installed different energy dissipation devices, authors utilize relatively uncoupled mode-superposition method and complex mode-superposition method for contrast analysis, and probe into the suitability of the two methods in the dynamic analysis of passive energy dissipation structure. Numerical results show that complex mode-superposition method could be better for structure with viscous dampers in order to guarantee accuracy, and relatively uncoupled mode-superposition method is recommended for structure with viscoelastic, metallic or frictional ones.     

小麦和土壤中环丙唑醇残留消解动态及膳食摄入评估

为评价环丙唑醇在小麦生产上应用的安全性,通过建立乙腈提取、氮磷检测器检测方法对小麦籽粒、植株和土壤样品中环丙唑醇的残留量进行检测,研究了小麦籽粒、植株和土壤中环丙唑醇的残留及其消解动态,并对小麦中的残留量进行风险评估。结果表明,环丙唑醇在小麦籽粒、植株及土壤空白样品中的添加回收率为79.2%~95.6%,相对标准偏差为1.9%~10.0%,最小检出量为8.2×10?12 g,在小麦籽粒、植株及土壤中的最低检测浓度均为0.05 mg·kg?1,乙腈提取、氮磷检测器检测方法重现性好,准确度、精密度高,可满足环丙唑醇在小麦上的残留分析要求。2010年和2011年,河南省、黑龙江省和江苏省3地环丙唑醇在小麦植株和土壤中的消解半衰期分别为3.0~5.5 d、18.1~34.5 d;不同施药次数、施药量及采样间隔,环丙唑醇在小麦籽粒中的最终残留量均≤0.415 mg·kg?1。采收间隔期为14 d和21 d时,不同施药次数、施药剂量和采收间隔期,环丙唑醇在小麦植株、小麦籽粒和土壤中的残留量差异均不显著;采收间隔期为7 d,有效成分108 g?hm-2施药2次与有效成分162 g?hm-2施药3次时小麦植株、小麦籽粒和土壤中的残留量之间均存在显著性差异。普通人群环丙唑醇的国家估算每日摄入量为0.000 109 9 mg,占日允许摄入量的0.5%左右,按本试验方式进行施药,通常不会对一般人群健康产生不可接受的风险。     

低功耗经济型区域墒情实时监测系统

灌区墒情实时监测是现代灌区灌溉管理中的必要部分和基础工作。该文设计了一种利用微功耗处理器的墒情监测仪,仅用2节1号干电池供电,结合GPRS(general packet radio service)数据传输至网络服务器处理分析,从而实现了区域分布式的墒情监测。本系统设计装载4层土壤水分/温度传感器和1层水势传感器,根据灌溉管理需要布设在作物根区不同深度;利用微处理器和设计电路进行土壤墒情等参数的采集、存储、传输和控制,每小时采集1次数据、每日将数据发送至网络服务器。通过在灌区不同区域典型作物生育期内实际运行1 a结果表明,该系统采用干电池或锂离子电池供电,体积小而便于在田间布设,不影响农田耕作,方便经济;监测数据能够及时传送至网络服务器以进行结果处理和灌溉管理。该文同时也对系统特点进行了总结,并指出对该系统进一步改进和研发方向。     

缺钾对水稻不同品种光合和能量耗散的影响

试验测定了钾敏感型(二九丰)和钾钝感型(原丰早)两个水稻品种在缺钾处理41.d后其剑叶的生长、光合光响应曲线、叶绿素荧光参数光响应曲线和暗弛豫动力学曲线。结果表明,缺钾降低了水稻剑叶的光合作用,显著抑制了生长。但是缺钾条件下导致两个水稻品种净光合速率(Pn)下降的主导因子并不相同。在缺钾条件下,原丰早(YFZ)剑叶的Pn随气孔导度(Gs)和胞间CO2浓度(Ci)的下降而下降,但叶绿素荧光参数和叶绿素含量几乎没有变化,说明其Pn下降主要归于气孔的限制。缺钾处理41.d后,二九丰(EJF)在低光强下[500mol/(m2.s)],Pn随Gs和Ci下降,但在更强的光强下,Pn和Gs继续下降,而Ci开始上升,并在1200mol/(m2.s)处超越了对照,说明此时主导因子不单受气孔限制,还受非气孔因子限制;它的光饱和点从1200mol/(m2.s)下降到大约500mol/(m2.s);同时,其荧光参数Fv/Fm、ФPSII、qP和ETR随光强上升而迅速下降,而L(PFD)、E和PP迅速增加,NPQ在1200mol/(m2.s)光强下上升,但是在高光强下却迅速降低,甚至低于对照,而且Fm、Fv/Fm下降,Fo上升,均说明缺钾处理可能使光合机构受到了伤害,发生了光抑制。对非光化学猝灭的分析得到其中间组分qNm可能起了更大的能量耗散作用,部分激发能从PSⅡ转移到PSⅠ,降低了PSⅡ耗散能量的压力。以上结果表明,两品种对钾敏感性不同极可能也与缺钾条件下光保护能力的差异有关。     

Optimization of Energy Dissipation Braces in Frame Structures

In this paper, the complex method of the nonlinear programming is used to optimize the parameters of energy dissipation bracing in energy dissipation braced frame. This method is realized with computer program and proved to be efficient. A 6-story reinforced concrete frame is used as a demonstrative example.     

Removal of static electricity on polyimide film surface by O2 or Ar cold plasma etching

Cold plasma of O₂ or Ar was irradiated on hydrophobic Kapton surface to attenuate or remove the electrostatic potential. A measurement on charge dissipation speed clarifies the obscure effect of plasma. These consequences reveal that O₂ plasma etching is more effective than Ar plasma. After 30 days, the dissipation speed of accumulated charge on initially etched sample has not changed under summar season.     

氟氯氰菊酯在茶叶中的残留动态研究

采用田间小区试验方法研究了氟氯氰菊酯在茶叶中的残留动态和最终残留量。残留动态试验结果表明，在本地特有的自然环境条件下，氟氯氰菊酯在茶叶中的消解速度很快，其半衰期为1.88d。最终残留量的测定结果表明，按照推荐使用剂量和推荐安全间隔期，氟氯氰菊酯在茶叶中无残留。     

Reduced metribuzin pollution with phosphatidylcholine-clay formulations

BACKGROUND: Metribuzin is a widely used herbicide that has been identified as a groundwater contaminant. In this study, slow‐release formulations of metribuzin were designed by encapsulating the active ingredient in phosphatidylcholine (PC) vesicles and adsorbing the vesicles onto montmorillonite. RESULTS: The maximum active ingredient content in the slow‐release formulations was 246 g kg^?1. Infrared spectroscopy results revealed that the hydrophobic interactions between metribuzin and the alkyl chains on PC were necessary for encapsulation. In addition, water bridges connecting the herbicide and the PC headgroup enhanced the solubility of metribuzin in PC. Adsorption experiments in soils were performed to evaluate the relationship between sorption and leaching. Funnel experiments in a sandy soil revealed that the herbicide was not irreversibly retained in the formulation matrix. In soil column experiments, PC–clay formulations enhanced herbicide accumulation and biological activity in the top soil layer relative to a commercial formulation. PC–clay formulations also reduced the dissipation of metribuzin by a factor of 1.6–2.5. CONCLUSIONS: A reduction in the recommended dose of metribuzin can be achieved by employing PC–clay formulations, which reduces the environmental risk associated with herbicide applications. Moreover, PC and montmorillonite are non‐toxic and do not negatively affect the environment. Copyright © 2010 Society of Chemical Industry