Fatigue of structural plywood under cyclic shear through thickness I: fatigue process and failure criterion based on strain energy

The fatigue behavior of plywood specimens under shear through thickness was examined on the basis of strain energy to obtain common empirical equations for the fatigue process and failure criterion under various loading conditions. Specimens were cut from commercial plywood panels of 9-mm thickness. Loading conditions were set as follows: a square waveform at a loading frequency of 0.5 Hz, a triangular waveform at 0.5 Hz, and a triangular waveform at 5.0 Hz. Peak stress applied was determined to be 0.5, 0.7, and 0.9 of static strength, that is, stress levels of 0.5, 0.7, and 0.9. The stress-strain relationships were measured throughout the fatigue test, and the strain energy was obtained at each loading cycle. Loading conditions apparently affected the relationship between stress level and fatigue life. On the other hand, the relationship between mean strain energy per cycle and fatigue life was found to be independent of loading conditions. Mean strain energy per cycle obtained as the fatigue limit was 5.85 kJ/m³ per cycle. Assuming that the accumulation of strain energy is a fatigue indicator, the fatigue process and failure criterion for the plywood specimens under the three loading conditions were commonly expressed by the relationship between cumulative strain energy and loading cycles.     

Heat budget and statistical analysis of the relationship between stream temperature and riparian forest in the Toikanbetsu River basin, northern Japan

Riparian forests greatly influence aquatic ecosystems by providing shade cover, which controls water temperature and limits primary production. We examined the relationship between forest cover and summer stream temperature in northernmost Japan. Heat budget and statistical analyses were employed and the results were compared. Heat budget analysis revealed that the water temperature would decrease almost linearly from 29°C to 25°C with an increase in forested reaches along a 3.2 km stretch of the river. Multiple regression analysis by the stepwise method chose only open channel length as a variable to explain the variation in maximum stream temperature. A sharp increase in stream temperature was noted when riparian forest cover was removed in short lengths, of up to 1.0km; this increasing trend gradually flattened as the length of open stretch increased. Thus, even small openings in the riparian canopy resulted in drastic rises in summer stream temperature. The maximum summer temperatures estimated by the two methods were coincided, and can therefore be accurately estimated by regression analysis. Retrospective analysis based on the regression equation showed that the maximum summer temperature in 1947 was 6°C lower than at present, and that a sharp increase occurred from 1947 to 1960, a period of rapid expansion of agricultural land development in the watershed.     

Effect of loading frequency on fatigue life and dissipated energy of structural plywood under panel shear load

Wood-based panels are subjected to cyclic panel shear load caused by wind and seismic forces in such an application as the sheathing of bearing walls. The fatigue behavior of structural plywood under panel shear load with two different loading frequencies was examined. Pulsating panel shear load with a triangular waveform and loading frequency of 0.5 or 5 Hz was applied to the plywood specimens. Stress−strain hysteresis loops were measured throughout the fatigue tests. Fatigue life was highly dependent on loading frequency at more than 0.5 stress level. The deterioration of mechanical property and damage accumulation in plywood specimen was observed to be slower at higher loading frequency at more than 0.5 stress level. Analyses based on energy loss suggest that panel shear load with higher loading frequency causes less damage to the plywood specimen during one loading cycle at higher stress level, and that the fatigue damage accumulation causing failure might be dependent on stress level although it seems to be unaffected by loading frequency. Based on these results, a new fatigue failure model for plywood specimen was qualitatively developed by combining Weibull’s weakest link model and Daniels’ fiber bundle model.     

Dielectric relaxation due to heterogeneous structure in moist wood

Dielectric properties in three main directions for hinoki wood (Chamaecyparis obtusa) specimens conditioned at various levels of relative humidity were measured in the frequency range from 20 Hz to 10 MHz over the temperature range from −150°C to 20°C. Three relaxations were observed in the specimens conditioned at high levels of relative humidity. The relaxation in the highest frequency range was ascribed to the motions of adsorbed water molecules. The relaxation in the middle frequency range remained unchanged by the ethanol–benzene extraction of specimens. The relaxation location was independent of measuring directions. The relaxation in the lowest frequency range was not detected in the specimens impregnated with methyl methacrylate (MMA). This result suggested that the relaxation was due to electrode polarization. The Cole-Cole circular arc law applied well to two relaxations recognized in the specimens impregnated with MMA. The relaxation magnitude in the middle frequency range was extremely large, and the distribution of relaxation times was very narrow. These characteristics suggested relaxation of the Maxwell-Wagner type resulting from the interfacial polarization in the heterogeneous structure, which included adsorbed water with large electrical conductivity within the insulating cell walls.     

Effects of growth and dietary crude protein level until first insemination on milk production during first lactation in Holstein heifers

To decrease the age at first calving in Holsteins, the effects of average daily body weight gain (ADG) and crude protein (CP) level until first insemination on growth performance and milk production were examined. The MM group had a target ADG of 0.75 kg and received a diet with a CP level of 14%. The HM and HH groups had a target ADG of 1 kg; both these groups received a diet with CP levels 14% and 16%, respectively. The ADG in the HM and HH groups was 1.1 kg, whereas in the MM group it was 0.97 kg (P < 0.01). The HM and HH groups showed no differences in withers height at body weight 350 kg. The ages at first calving in MM, HM and HH groups were 23.1, 21.0 and 21.8 months, respectively. The HM and HH groups had lower milk yield at day 305 than the MM group (P < 0.01). These results suggest that growth performance until first insemination should be maintained at an ADG of 0.97 kg or less with a CP level of approximately 14%, to shorten time until first insemination and prevent the decrease of milk yield.     

Analysis of strigolactones,germination stimulants for striga and orobanche,by high-performance liquid chromatography/tandem mass spectrometry

A simple and rapid analytical method for strigolactones, germination stimulants for the root parasitic weeds witchweed (Striga spp.) and broomrape (Orobanche spp.), has been developed using high-performance liquid chromatography connected to tandem mass spectrometry (LC/MS/MS). The natural strigolactones (strigol, sorgolactone, orobanchol, and alectrol) were clearly separated and identified by LC/MS/MS. As low as 0.1 pg/microL of strigol and 0.5 pg/microL of sorgolactone could be quantified, whereas 1 pg/microL was needed for the quantification of orobanchol (S/N > 10). Using this method, it was found that red clover produces orobanchol and alectrol but not strigol. The roots of red clover seedlings were found to produce 13, 70, 58, and 65 pg of orobanchol/plant 1, 2, 3, and 4 weeks after germination, respectively.     

Improvement of functional properties of egg white protein through phosphorylation by dry-heating in the presence of pyrophosphate

Egg white protein (EWP) was phosphorylated by dry-heating in the presence of pyrophosphate at pH 3.0-7.0 and 85 degrees C for 1 and 5 days, and the functional properties of the phosphorylated EWP (PP-EWP) were investigated. The phosphorylation was accelerated with a decrease of pH from 7.0 to 3.0 and for heating times from 1 to 5 days. The phosphorus content of EWP increased approximately 1.05% by dry-heating at pH 4.0 and 85 degrees C for 5 days in the presence of pyrophosphate, which was higher than that of casein. The electrophoretic mobility of EWP increased with an increase in the phosphorylation level. The surface hydrophobicity of EWP increased by phosphorylation. The heat stability, emulsifying properties, and digestibility of EWP were improved by phosphorylation. The calcium phosphate-solubilizing ability of EWP was enhanced by phosphorylation. A firmer and transparent heat-induced gel of PP-EWP was obtained, and the water-holding capacity of heat-induced PP-EWP gel was higher that that of the control. These results suggest that phosphorylation by dry-heating in the presence of pyrophosphate is a useful method for improving the functional properties of EWP.     

Identification of potent odorants in Chinese jasmine green tea scented with flowers of Jasminum sambac

The odorants in Chinese jasmine green tea scented with jasmine flowers (Jasminum sambac) were separated from the infusion by adsorption to Porapak Q resin. Among the 66 compounds identified by GC and GC/MS, linalool (floral), methyl anthranilate (grape-like), 4-hexanolide (sweet), 4-nonanolide (sweet), (E)-2-hexenyl hexanoate (green), and 4-hydroxy-2,5-dimethyl-3(2H)-furanone (sweet) were extracted as potent odorants by an aroma extract dilution analysis and sensory analysis. The enantiomeric ratios of linalool in jasmine tea and Jasminum sambac were determined by a chiral analysis for the first time in this study: 81.6% ee and 100% ee for the (R)-(-)-configuration, respectively. The jasmine tea flavor could be closely duplicated by a model mixture containing these six compounds on the basis of a sensory analysis. The omission of methyl anthranilate and the replacement of (R)-(-)-linalool by (S)-(+)-linalool led to great changes in the odor of the model. These two compounds were determined to be the key odorants of the jasmine tea flavor.     

Reflection and transmission of visible light by sugi wood: effects of cellular structure and densification

Transmittance and reflectance of visible light by sugi wood (Cryptomeria japonica) were investigated in the longitudinal (L) and tangential (T) directions. Transmittance was the highest in the L direction and reflectance was the highest in the T direction, suggesting that structural anisotropy influences transmittance and reflectance. Intra-ring variations observed with a microspectrometer indicated that T transmittance was higher for latewood than for earlywood, but there was no such trend in for L transmittance in which the highest levels occurred near the annual ring boundaries, on either the earlywood or latewood side, and the lowest at the transition from earlywood to latewood. Dependence of L transmittance on wavelength also showed variations according to the intra-ring position. The increasing of transmittance of earlywood at wavelengths?<?500 nm with increasing wavelength was observed, but this was not confirmed for latewood because of absorption by lignin. These observations supported a previously published finding, which was based on measurements in the radial direction, that the number of internal cell wall reflections, rather than density, determines wood lightness. Indeed, in the L direction, most of the incident light passes through lumens in earlywood and through cell walls in latewood, while it is subjected to numerous internal reflections at the interface between lumens and cell walls. This was further confirmed by the transmittance of earlywood being greatly decreased by radial compression.     

Ontogeny of schooling behavior in the oval squid <Emphasis Type="Italic">Sepioteuthis lessoniana</Emphasis>

In contrast to schooling behavior in fish, which is well documented, the schooling behavior of an evolutionary counterpart, squid, has not been adequately described in the literature. In the current study, we investigated the ontogeny of schooling behavior in the oval squid Sepioteuthis lessoniana reared from hatching to about two months of age. During the two months of development, the distance and angle between nearest-neighbor individuals decreased from 5.3 mantle lengths (ML) to 1.8 ML and from 42.7° to 24.2°, respectively. In addition, the swimming distance of individuals in experimental duration decreased from 530.4 to 79.9 ML, and the relative swimming speed also decreased from 17.1 to 4.6 ML/s during the same period, with increasing synchronized hovering of individuals. These observations clearly suggest that oval squid swim randomly until 20 days after hatching, then form a school 30–60 days after hatching with an inter-individual distance of 2.0 ML. At two months after hatching, oval squid individuals swam in a parallel orientation and formed a belt-shaped arrangement, similar to the adult schooling behavior observed in natural populations.