Vertical profiles of environmental factors within tropical rainforest, Lambir Hills National Park, Sarawak, Malaysia

Environmental factors, such as global solar radiation, wind speed, air temperature, humidity, and CO₂ concentration, were measured above and within the canopy of a tropical rainforest in Lambir Hills National Park, Sarawak, Malaysia. Few data concerning the environment of this forest have been reported. Intensive observations were carried out in 1998, 1999, and 2000 with the following results: (1) The fraction of global solar radiation reaching the upper layer of the canopy varied with global solar radiation above the canopy. Even though the global solar radiation above the canopy fluctuated, the fraction of that reaching the lower canopy and the ground was constantly approximately 5%. (2) The fraction of wind speed reaching each layer of the canopy increased with wind speed above the canopy. Little wind was usually present at the lower canopy. (3) The daytime air temperature at the canopy top was higher than that near the ground. The maximum difference between the air temperature at the canopy top and that at the ground was about 5°C, and the diurnal temperature ranges at the canopy top and those at the ground were about 8°C and about 5°C, respectively. The highest daytime water vapor pressure occurred within the canopy and particularly near the ground. Vertical gradients of water vapor pressure during the day were steep, probably because of high transpiration. (4) In the 1998 observation the minimum and the maximum CO₂ concentrations were 360 ppm in the day and 450 ppm at night, while in the 2000 observation the minimum and the maximum CO₂ concentrations were 350 ppm in the day and 540 ppm at night. The higher CO₂ concentration in the daytime and the lower concentration at night observed during the 1998 observation period were probably due to reduced photosynthesis and soil respiration caused by exceptional dry conditions during the observation period.     

Development of wooden portal frame structures with improved columns

In Japan, the lifetime cycle of most housing lasts around 20–30 years. A governing factor in this respect is poor durability due to old-fashioned use of the house. As a solution of this problem, houses can be built with a skeleton structure that allows free partition of spaces by future owners. To develop the skeleton structure effectively, multistory frames with spans of 6 to 10 m are required. For this reason, attention has been focused on the behavior of multistory timber frame structures. In this article, two types of wooden portal frame structures are proposed. Both structures have improved vertical columns with short horizontal members glued in. The aim of this study was to investigate structurally effective solutions with these types of columns. The first type of the new structure changed the location of the moment-transmitting ductile connection with the improved columns. The second type of structure used an extended panel zone. Nine portal frame specimens were tested. The stiffness values were improved by around 1.7 and 3.5 times when compared with the control, and the strength was improved by around 1.25 and 1.45 times.     

Spatially distributed morphological characteristics of macropores in forest soils of Hitachi Ohta Experimental Watershed, Japan

Morphological characteristics of macropores in forest soil profiles were investigated at Hitachi Ohta Experimental Watershed in Japan. Nine individual profiles at different locations (various spatial scales in a catchment) and twenty profiles at one site (a small spatial scale) were excavated to the bedrock to investigate density, origin, diameter, direction, and gradient of macropores. Macropore densities in a soil profile ranged from 3.5 to 29.1 per m and from 5.4 to 75.1 per m², respectively. Subsurface erosion, root channels, and interactions between subsurface erosion and root channels accounted for 36.9, 36.5, and 19.0%, of the described macropores. The mean macropore diameter in organic-rich soil layer (17–20 mm) was larger than in the B horizon (11–14 mm) at both spatial scales. The dominant gradients of all macropores in the organic-rich soil layer and B horizon were at negative oblique angles. Approximately 90% of the macropores in the organic-rich soil layer and approximately 80% of the macropores in the B horizon fell within the range between −50 and 50 degree planar direction. Subsurface flow and root systems are believed to play important roles in determining the morphological characteristics of macropores. These characteristics appear to have variable influences in different soil horizons rather than at different spatial scales. A part of this paper was presented at the 103th (1992) and 105th (1994) Annual Meetings of Japanese Forestry Society.     

Acoustic emission monitoring during partial compression to detect early stages of decay

Summary The acoustic emissions (AEs) under partially compression were monitored with two softwood and one hardwood specimens in very eary stages of decay by a brown- and a white-rot fungus. Even slightly decayed specimens emitted AEs immediately after beginning of loading, typically when partial compression stress was applied to brown-rotted wood with the flat-headed attachment. With sound specimens of three wood species, only a few AEs were generated until the load reached at the proportional limit. These results suggest that AE monitoring will be one of the feasible means to detect the incipient stages of decay in a field test.The authors thank the Weyerhaeuser Research Grants Program for its aid in this investigation     

Estimating the production and mortality of fine roots in a Japanese cedar (Cryptomeria japonica D. Don) plantation using a minirhizotron technique

Fine roots are a key component of forested ecosystems, but available information is still limited. This study examined the production and mortality of fine roots less than 1 mm in diameter in a Japanese cedar (Cryptomeria japonica D. Don) plantation located on the Kanto Plain in central Japan. We used a minirhizotron technique in combination with soil coring, and collected data for 1 year (May 2002–May 2003). Fine root production and mortality were determined from changes in the lengths of individual fine roots on minirhizotron tubes. Both fine root production and mortality rates were greater in the upper soil than in lower soil levels. Both rates were seasonal, with higher values in summer than in winter; this trend was more pronounced in upper soil levels. These results suggest that environmental conditions, such as temperature or soil properties, affect the production and mortality rates of fine roots. Fine root production and mortality occurred simultaneously, and their rates were similar, which may have led to unclear seasonal changes in fine root standing crop estimates. Soil coring indicated that the fine root biomass of this stand was about 120 g m⁻², of which 40% was from Japanese cedar. The estimated rates of dry matter production and mortality of total fine roots, including understory plants, were both approximately 300 g m⁻² year⁻¹.     

Estimation of stiffness and strength in timber knee joints with adhesive and verification by experiment

The use of adhesive joints is gradually increasing, especially those with glued-in steel rods (GIRs). There are, however, some problems with the design methods when used for moment-transmitting applications. In this article, design methods for GIRs and cross-lapped glued joints (CLJs) are proposed. For CLJs, we made a hypothesis that both rotational deformation of CLJ and stress of the glue line occurred with bending and shearing deformation of the timber. Using this hypothesis and Kelvin’s theorem, a mechanical model of CLJ is proposed. For GIRs, the axial stress component of the rod and the lateral stress component of the rod were taken into account using the theory of a beam on an elastic foundation. From the comparisons between calculations and experimental results, it was recognized that the stiffness and strength of CLJs and GIRs could be predicted precisely using our proposed models.     

Mechanical and ecophysiological significance of the form of a young Acer rufinerve tree: vertical gradient in branch mechanical properties

Most tree biomechanics models assume uniformity of mechanical properties within a tree, and only a few studies have focused on differences in mechanical status among branches. We examined mechanical properties of 49 branches of two 10-year-old trees of Acer rufinerve Sieb. et Zucc. For each branch, bending moment due to its own fresh mass, elastic modulus, section modulus and flexural stiffness were obtained. Elastic modulus of the branch was correlated with the density and thickness of the fiber cell wall and decreased with crown depth, indicating that branches at lower positions were more elastic than branches at upper positions. Compared to lower branches, upper branches were less inclined, possessed thicker growth rings, more long shoots and were subject to smaller stresses. The leaf arrangement in the upper branches might be effective in transmitting more light to the lower branches. In contrast, the lower branches were more inclined toward the horizontal and subject to greater stresses than the upper branches. Lower branch inclinations were attributed to smaller dry matter investment in diameter growth. Upper and lower branch inclinations were slightly greater and smaller, respectively, than those predicted by beam theory. The alleviation in inclination of the lower branches is probably caused by negative gravitropic responses such as tension wood formation or upward shoot elongation, or both. The horizontal display of leaves in the lower branches would be effective in light interception. The reduction in cost of the lower branches can be adaptive because they have a shorter life expectancy than the upper branches. The results showed that an adaptive tree form is realized by a vertical gradient in branch mechanical properties.     

Separation of sardine oil without heating from surimi waste and its effect on lipid metabolism in rats

Sardine oil was obtained by centrifugation of surimi wastewater without heating or chemical refining. This oil (CE) showed light yellow color and the peroxide value was less than 1.0 meq/kg. The main lipid class of CE was triacylglycerol (TG) (>99%). These features indicate that CE can be directly used as food materials without further purification. Commercial sardine oil (CO) is usually prepared via some kind of refining process with high temperature (250 degrees C) and chemical treatment. The comparative study on the physiological effects of these sardine oils (CE and CO) revealed that the dietary sardine oils were more effective in reducing abdominal fat pads, plasma total cholesterol, and TG levels of rats than was a soybean oil diet (control). Furthermore, these effects were greater in CE than CO, although there was little difference in the fatty acid composition of both oils. Although the main lipid class of CE was TG (>99%), CE was prepared by centrifugation from surimi waste and directly used as dietary fat without further purification. Therefore, CE may contain some kinds of minor components, which could be attributed to the higher physiological activity of CE. To reveal the involvement of the minor compounds in CE, we prepared TG from CE by column chromatography and measured its effect on lipid metabolism of rats. TG from CE also showed the reducing effects on abdominal fad pads and plasma lipid levels. The effect of TG from CE was almost the same as that of original CE, suggesting that the higher nutritional activity of CE than CO may not be due to the minor compounds in CE.     

Isolation and characterization of aminopeptidase (Jc-peptidase) from Japanese cedar pollen (Cryptomeria japonica)

An aminopeptidase, Jc-peptidase, was purified from Japanese cedar pollen by seven steps, including precipitation with ammonium sulfate, ion-exchange chromatography, gel filtration, hydrophobic interaction chromatography on phenyl-agarose, and high-performance liquid chromatography. Purified Jc-peptidease has a molecular weight of 42 kDa and hydrolyzes the synthetic substrates of L-phenylalanyl-4-methylcoumaryl-7-amide (Phe-MCA) with Km = 5 x 10(-5) M, Tyr-MCA with Km = 7 x 10(-4) M, Leu-MCA with Km = 1 x 10(-3) M, and Met-MCA with Km = 1 x 10(-3) M. Other MCA analogues such as Arg-MCA or Glu-MCA failed to serve as its substrates. The activity was inhibited in the presence of phebestin, [(2S,3R)-3-amino-2-hydroxy-4-phenylbutanoyl-L-valyl]-L-phenylalanine, with Ki = 4.7 x 10(-5) M, or bestatin, [(2S,3R)-3-amino-2-hydroxy-4-phenylbutanoyl]-L-leucine, with Ki = 1.1 x 10(-4) M. According to amino acid sequence analysis, the N-terminal amino group seems to be blocked. The physiological function of the aminopeptidase (Jc-peptidase) has not been clarified in vivo.     

Snowcover Components in Northern Japan

Snowcover surveys were carried out in Hokkaido, northern Japan. Snowpack samples were collected using a steel pipe at 80 sites in 1988, 69 sites in 1992, and 66 sites in 1996 and 2000 during the time when the water equivalents of the snowcover are the greatest. Spatial distribution maps of water equivalents and of the concentrations and the accumulated amounts of hydrogen, non-sea-salt sulfate and non-sea-salt calcium ion of the snowcover drawn by Kriging method are discussed. The distribution maps show that water equivalents and the accumulated amounts of hydrogen and non-sea-salt sulfate in all the sample years were largest in the Japan Sea region, as were the ion concentrations of hydrogen and non-sea-salt sulfate. It was estimated this was caused by air pollutants transported from a great distance. The ratio of areas below pH 5.0 increased temporally from 1988 (20%) to 1992, 1996 and 2000 (66–80%). This trend was estimated to be affected by a decline of non-sea-salt calcium concentrations derived from alkaline road dust. In addition, the effect of snowcover components was assessed by comparison between the acid loads of the snowcover and the acid neutralizing capacity of lake water. We found that lakes in the middle of the Japan Sea coast have the potential to be acidified by snowmelt.