Effect of trehalose supplementation in milk replacer on the incidence of diarrhea and fecal microbiota in preweaned calves

Trehalose, a nonreducing disaccharide consisting of d-glucose with α,α-1,1 linkage, was evaluated as a functional material to improve the gut environment in preweaned calves. In experiment 1, 173 calves were divided into two groups; the trehalose group was fed trehalose at 30 g/animal/d with milk replacer during the suckling period, and the control group was fed nonsupplemented milk replacer. Medication frequency was lower in the trehalose group (P < 0.05). In experiment 2, calves (n = 20) were divided into two groups (control group [n = 10] and trehalose group [n = 10]) based on their body weight and reared under the same feeding regimens as in experiment 1. Fresh feces were collected from individual animals at the beginning of the trial (average age 11 d), 3 wk after trehalose feeding (experimental day 22), and 1 d before weaning, and the fecal score was recorded daily. Fecal samples were analyzed for fermentation parameters and microbiota. The fecal score was significantly lower in the trehalose group than in the control group in the early stage (at an age of 14 to 18 d; P < 0.05) of the suckling period. Calves fed trehalose tended to have a higher proportion of fecal butyrate on day 22 than calves in the control group (P = 0.08). Population sizes of Clostridium spp. were significantly lower (P = 0.036), whereas those of Dialister spp. and Eubacterium spp. tended to be higher in the feces of calves in the trehalose group on day 22 (P = 0.060 and P = 0.083). These observations indicate that trehalose feeding modulated the gut environment and partially contributed to the reduction in medication frequency observed in experiment 1.     

Nutrient starvation affects expression of LC3 family at the feto-maternal interface during murine placentation

LC3 − the mammalian homolog of Atg8 − was found as autophagosome membrane binding protein in mammals and widely used as an autophagosomal marker. LC3A, B and C show different expression patterns in each tissue. The aim of this study was to reveal the differences of expression patterns among LC3 families in mouse placenta under normal condition and nutrient starving condition. LC3A and B were highly expressed in decidual cells. LC3A and B were increased in D14 compared with D12 and D16 in mouse placenta, while LC3C was decreased. Starvation induced increase in LC3B expression specifically. Immunohistochemistry showed different expression patterns among LC3A, B and C. LC3A expression in syncytiotrophoblast was vanished by starvation. The results of real time RT-PCR suggested differences between D12 and D16 in autophagic cascade induced by starvation. Taken together, this study suggests that autophagy could play a role in placental invasion system and that nutrient starvation affects LC3B expression.     

Continuum contraction of tension wood fiber induced by repetitive hygrothermal treatment

Wood Science and Technology - Tension wood, when kiln-dried, is likely to deform hugely, which is probably caused by a gelatinous layer of the gelatinous fiber. To elucidate the mechanism behind...     

Plantation future of bamboo in China

In the past, utilization of bamboo resources in China has been traditionally dominated by direct consumption of local farmers as minor forest products with weak linkage with market. In recent years, the over-supply of grains and rapid degradation of agricultural environment call for alternative crops that can be developed through integrating the environmental plantation with the market demands. Closely associated with forestry and agriculture, bamboo is able to deal with the new challenges which China‘s agriculture is facing. Of 534 documented bamboo species in China, 153 species produce edibleshoots and of which 56 species are recommended for agricultural plantation; 139 species provide timbers and of which 58 species recommended; 116 species can be splited as good strips for weaving and of which 22 species recommended; 88 species are considered as garden bamboos and of which 34 species recommended; 45 species are able to produce paper pulp and of which 18 species recommended.     

Simultaneous measurements of quantum yield and CO2 uptake for the assessment of non-assimilative electron flow in tree leaves

Using attached and detached leaves ofAcer palmatum Thunb. andRhaphiolepsis umbellata Makino, pulse-modulated chlorophyll fluorescence and CO₂ exchange were measured. Quantum yield of photosynthesis was determined from the fluorescence parameter(Fm′−Fs)/Fm′, where (Fm′−Fs) was defined as the difference between steady state chlorophyll fluorescence (Fs) and maximum fluorescence (Fm′) elicited by a saturating light pulse. The rate of electron transport through photosystem II (total electron flow) was calculated from the product of quantum yield andA (PFD), whereA is the rate of absorbed photons as given by leaf absorptance, and PFD is the photon flux density at the leaf surface. The rate of electron transport dependant on CO₂ uptake (assimilative electron flow) was calculated from the gross photosynthetic rate in a leaf. The difference between the rates of total and assimilative electron transport was denoted as the rate of non-assimilative electron transport which depends on photorespiration and oxygen reduction. Available data provided quantitative information on the rate of non-assimilative electron flow in intact leaves. When leaf photosynthesis ofA. palmatum was measured under sunlight, the rates of total and assimilative electron transport were determined to be approximately 900 and 150 μmol equiv. e/mg Chl·h, respectively. The difference (750 μmol equiv. e/mg Chl·h) was attributed to the activity of non-assimilative electron flow. The ratio of total to assimilative electron flow was found to increase gradually with rising in irradiance. The results suggest that non-assimilative electron flow occurred at much higher rate than assimilative electron flow at high irradiance. Implications of the results are briefly discussed in relation to photosynthesis limitation in tree leaves.     

Absolute configuration of new bisaboranoids from Yaku-sugi (Cryptomeria japonica) wood

The absolute configuration of bisabolanoids isolated from Yaku-sugi wood were compared with those of dihydrocarvone and dihydrocarveol isomers based on their¹³C nuclear magnetic resonance data and optical rotations.     

Safety of the tram car for slopes examined by stress analysis of the ground structure

For monorail systems, it is very important to ensure the safety of the ground structure. We developed a tram car for slopes that utilizes the mechanism of the monorail and analyzed the stress of the ground structure that had double rails. First, we divided the ground structure into seven components, and formulated a procedure for calculating the stress of the ground structure. As a result, the stress that acts upon the main rail and the main rail connecting part was near the allowable stress, and each calculated value was within the allowable stress. We measured the stress by running the vehicle, and compared the measured values with the calculated values. As a result, some measured values were larger than the calculated values. However, the ratio of measured value to allowable stress was 90% or less. Finally, we calculated the static loading coefficient for each part, results of which were as follows: main and subrail: 1.1; rail connection part and prop foundation part: 1.0; rail installation part: 1.3. In the recalculations, it became clear that the recalculated values exceeded the allowable stresses. These results suggest that we need to review the ground structure materials.     

Probabilistic evaluation of the final moisture content of kiln-dried lumber using the bootstrap method

This paper presents a probabilistic method of evaluating the final moisture content (MC) of lumber obtained at the end of the kiln-drying process. The final MC data of three different drying tests conducted in past studies were analyzed using the bootstrap method. Target MC was tentatively set below 20 % in the analysis. Two characteristic parameters representing the final MC were estimated with bootstrap confidence intervals. These parameters were the standard deviation (SD) and the percentage of the population that met the MC requirement of less than 20 % (P ₂₀). The histograms of the final MC and the subsequent goodness-of-fit tests revealed that the final MC data of two drying tests did not follow any classical probability distributions, including Normal, Log-Normal, Weibull, and Gamma distributions, thus indicating the need for nonparametric statistics. The uncertainty of the final MC could be evaluated with the estimated SD and P ₂₀. After deriving the relationships between P ₂₀ and the corresponding probability that P ₂₀ is not achieved, we demonstrated how such relationships could provide a kiln operator with information to facilitate better decision-making in optimizing a drying schedule.