Effects of commercial thinning,log position in the stem,and cutting width on the surface quality of cants produced by a chipper-canter

Fifteen stems of jack pine (Pinus banksiana Lamb.) of 3 commercial thinned plots (control, moderate, and intensive thinning) and 15 stems of black spruce (Picea mariana (Mill.) B.S.P), both coming from the Abitibi-Témiscamingue region – Canada, were cross-cut into three 2.4?m length sections: bottom, middle, and top logs. Logs were processed with a chipper-canter at three cutting widths (12.7, 19.1, and 25.4?mm), producing chips and a three-faced cant. The middle section of the cant was used to evaluate surface quality across the grain on each face. Roughness and waviness parameters and depth of torn grain were recorded. Knot characteristics were assessed in the three cant faces. Poorer surface quality was found in the lower part compared to the upper part of the cant for both species. At larger cutting widths, jack pine logs coming from a natural stand showed lower surface quality compared to logs from thinned stands. Black spruce waviness increased with the cutting width and stem height. These results were attributed to the increase of forces and vibration when cutting at larger cutting widths, which was worsened by the presence of bigger, more numerous knots at the control plot and in the top logs. Black spruce had deeper torn grain compared to jack pine. Their differences in knot characteristics resulted in a maximum torn grain depth favored by the presence of more knots rather than by bigger knot size. Other knot characteristics, such as the position of the knots in the cant face, the insertion angle of the branch and the distribution of the knots around the log, should be studied to better understand the relationship between torn grain formation and knottiness.     

Evaluation of two surfacing methods on black spruce wood in relation to gluing performance

Surface quality and gluing performance of black spruce samples prepared by peripheral straight-edge knife planing and sanding were studied. Four wavelengths (1.5, 1.9, 3.1, and 6.5 mm) and four rake angles (15°, 20°, 25°, and 30°) were tested for peripheral planing. Three feed speeds (4, 10.5, and 17 m/min) and three grit size sandpapers (80, 100, and 120) were studied for sanding. The resulting surfaces were glued with an isocyanate adhesive and tested to evaluate their gluing performance (shear strength and percent wood failure). Results revealed that planing with a rake angle of 20° and wavelengths of up to 3.1 mm produced wood surfaces with adequate glueline shear strength. Sanding with 80-grit sandpaper produced the best glueline shear strength, regardless of feed speed. After accelerated aging, the loss of gluing performance was lower for the sanded samples compared with that of planed samples. In general, sanding process produced better wood surfaces for bonding with the adhesive studied.