云南野生动物肇事危害情况及对策探讨

云南被誉为"动物王国",自然条件优越,适于各种野生动物生息繁衍。随着保护力度的加大,其野生动物的数量猛增,与人的冲突日显突出,肇事危害频繁,损失严重。针对云南野生动物肇事危害的原因和特点,提出多渠道、综合治理的对策建议。     

水泥砼路面改造前的病害处理

本文介绍的是在破损的水泥混凝土路面上进行沥青混凝土路面铺筑时,旧路面的处理方法和施工工艺。     

Hygrothermal effect of bamboo by dynamic mechanical analysis

Dynamic properties of bamboo, Phyllostachys pubescens, with moisture content (MC) ranging from −130 to 130°C, were studied by dynamic mechanical analysis (DMA). The results showed that the hygrothermal effect on dynamic mechanical properties was negative. The storage modulus decreases with increasing temperature and MC, and glass transition temperature decreases with increasing MC. The glass transition temperature and tan delta of bamboo were 30.5°C, 0.02 and 10.61°C, 0.04, when MC was 10% and 34%, respectively. __________ Translated from Journal of Nanjing Forestry University (Natural Sciences Edition), 2006, 30(1): 65–68 [译自: 南京林业大学学报(自然科学版), 2006, 30(1): 65–68]     

Tensile strength of softwood butt end joints. Part 1: Effect of grain angle on adhesive bond strength

To study the effect of grain angle on the adhesive bond strength in wood, three-part Norway spruce wood specimens were bonded and tested in tension. The two axially orientated outer parts of the specimens were joined with the middle part by means of three adhesives typically used for load-bearing constructions, i.e. one-component polyurethane (PUR), melamine-urea-formaldehyde (MUF) and phenol-resorcinol-formaldehyde (PRF). The grain angle of the middle part was varied from 0° (end grain to end grain) to 90° (flat grain to end grain) in incremental steps of 10°. In general, PRF- and MUF-bonded samples exhibited highest tensile strength at end grain to end grain orientation of the three parts, while specimens bonded with PUR showed only 25% of the strength measured for PRF and MUF, respectively. At high grain angles (90°) all specimens showed similar strength values in the range of 30% of maximum strength of MUF- and PRF-bonded specimens. To explain the changing strength levels at different grain angle a composite failure criterion was applied.     

城市绿化树木栽植与管理方式的几点反思——对2003年冬北京大雪造成"树灾"的调查

2003年11月6日北京大雪对城市绿化树木造成了罕见的伤害。本文在对树木受灾情况进行调查的基础上,综合分析了树木受灾的主要因素,探讨了目前树木栽植、管理方式等与树木受灾的关系,并提出了改进建议。     

原料表面碱液处理对稻草碎料板力学性能的影响

在实验室条件下探索了稻草原料表面碱液处理对稻草碎料板力学性能的影响.试验表明,处理后的稻草碎料板的内结合强度比处理前有大幅度提高,弯曲弹性模量和静曲强度比处理前则有所下降,但都达到了相关的国家标准;2h吸水厚度膨胀率升高,超过国家标准.因此稻草表面碱液处理提高了稻草原料表面润湿性和胶合强度,但对稻草碎料板的力学性能有影响.     

日本龟蜡蚧在枣树上的发生与危害

１９９６年８月￣１９９７年６月，在陕西大荔县八鱼乡西营村和蒲支县平路庙乡直杜村调查了日本龟蜡蚧在枣树上的分布与危害。结果表明，单叶幼虫数随枣树受害程度的增加而增加，单果重随枣树爱害程度的增加而减少，越冬雌虫的危害造成每股的抽吊数减少，吊长显著变短，每吊的刺树数减少，幼虫和雌成虫在树冠上的分布是阳面（南面）大于阴面（北面），其中树冠中部虫量分布的最多。     

海南岛柚木的木材性质

１１—１３龄柚木２０株，１７—１９龄７株，取自海南岛尖峰岭，用以研究木材比重及纤维长度的某些特性及测定标准物理力学性质。以胸高圆盘加权平均数为单元，比重０．４６６—０．５８８，平均０．５１６：纤维长度０．８７８—１．２３０ｍｍ，平均１．０６３ｍｍ。生长轮宽度与比重及纤维长度之间表现弱的负相关。第１轮和第９轮的材性存在显著的相关关系。材性在标地间的差异不显著，标地内株间的差异很显著。径向变异：髓心附近几轮的纤维长度和比重均增长很快，第８轮以后，前者增长缓慢，后者多起伏。轴向变异：１．心部系列（髓心向外６生长轮）第１轮纤维长度的轴向变异很小，其外几轮的纤维长度缓慢向上减轻或有起伏；基部各生长轮的比重很大，向上急剧减小至１．３ｍ高度，此后各生长轮的变化不一致。２．边部系列（树皮向内６生长轮）纤维长度和比重均很快向上减小。讨论了影响纤维长度轴向变异的主要因素。提出标准物理力学性质的试验结果。