脉冲式烟雾水雾机热力雾化水剂农药效果分析

针对脉冲式烟雾水雾机在喷施水雾剂农药时常出现滴液、流液或较大雾滴群等雾化不良现象，通过改装6HYW-60S型脉冲式烟雾水雾机，将药液流量设置成可调的测试装置，设定5个油门开度及4个药液流量，测试了脉冲发动机喷药前后的气流速度、温度及各喷药工况下的雾滴粒径分布。结果表明，在最小的油门启动开度到最大的油门工作开度可调范围内，对应的脉冲发动机燃油消耗率变化范围较小（相对变化13.0%），喷管内对应的气流温度与速度也发生同等程度的变化。喷药时，喷管口处的气流温度与速度发生明显变化，由不喷药时约700℃的高温气流下降为75℃左右的雾滴流，相应的气流速度下降了16%左右；油门开度及药液流量对雾滴流温度的影响非常小，但对雾滴流速度的影响非常明显，油门开度增大，雾滴流速度明显增加，药液流量增大，雾滴流速度明显下降。在各油门开度下，对最小药液流量20L/h的雾化效果均不佳，尤其距喷雾出口较近处存在大量的300μm以上的较大雾滴，这些大雾滴极易跌落至地面，无法有效喷施到目标物上；药液流量增大至40L/h及以上时，各油门开度下的雾滴体积中径均较小，同一工况下各位置点的平均值不超过60μm。热力雾化的雾滴粒径分布曲线不是单一峰值的正态分布形态，常会出现不同中心雾滴粒径的雾滴群，且这些雾滴群的中心雾滴粒径基本保持一致。从喷雾出口喷出的雾滴流中，喷管中心轴线上的雾滴细小均匀、雾化充分，中心轴线上方的雾滴一般比中心点处稍大，中心轴线下方雾滴明显增大，且距中心轴线越远的下方，雾滴增大越明显，即雾滴流中较大雾滴群的量逐渐增加。以药液流量60L/h及油门开度90°为最佳雾化工况，在整个喷施区域内均形成了良好的雾化效果。     

车-液耦合响应下液罐车稳定性控制仿真

为了提高液罐车行驶安全性、减少液罐车侧翻、失稳所带来的危害,对于液罐车在转向或换道时车-液耦合动态响应对整车稳定性的影响进行了研究。联合液体纳维斯托克斯和流动控制方程,应用计算流体动力学软件ANSYS/Fluent建立并求解液体晃动模型,通过结合液体晃动模型和三自由度液罐车刚体模型获得液罐车车-液耦合动力学模型,分析有无控制策略情况下,液体晃动对液罐车横向稳定性的影响。仿真结果表明:提出的模糊差动制动控制策略能够有效提高车辆抗侧翻能力,减少罐车运输过程中交通事故的发生,对液罐车运输有指导意义。     

转轮下环间隙对混流式水轮机内部流动特性的影响

水轮机转轮间隙内的泄漏涡、泄漏流等复杂的湍流易影响水轮机的性能与稳定性。为了分析下环间隙对混流式水轮机能量特性和内部流态的影响,该文基于N-S方程和SST湍流模型,考虑了0.6 Qd(Qd为设计流量工况)、0.8 Qd、Qd、1.2 Qd共4种流量工况,对5种下环间隙下的混流式水轮机模型机进行三维全流道数值计算。通过对比不同下环间隙方案对混流式水轮机效率与容积损失的影响,结合不同水轮机内部流场特征,分析下环间隙与水轮机性能的关系。计算结果表明:下环间隙由0.4 mm增大到1.3 mm,机组泄漏量增大,水轮机效率整体呈下降趋势。其中,当机组在小流量0.6 Qd工况运行时,间隙对水轮机能量特性影响最为明显,效率下降了4.1个百分点。当机组在小流量0.6 Qd与0.8 Qd工况运行时,下环间隙增大,间隙内部流场与尾水管内部流场呈现小幅度恶化;当机组在大流量1.2 Qd工况运行时,下环间隙增大,转轮叶片吸力面压力分布以及尾水管内部流场均得到改善。该研究可为混流式水轮机结构设计提供有效参考。     

Assessing the deposition and canopy penetration of nozzles with different spray qualities in an oat (Avena sativa L.) canopy

Consistent spray coverage that is evenly distributed throughout the canopy is necessary to control pest populations that can negatively affect yield. As applicators are switching to Coarser spray quality nozzles to reduce risk and liability of pesticide spray drift, concerns about efficacy loss are growing. Previous research has indicated that small droplets are the most effective at penetrating through crop canopies, but newer nozzle technologies have improved the effectiveness of larger droplet or Coarser sprays. Research was conducted to assess the canopy penetration of nozzles that produce Coarse, Very-Coarse and Extremely-Coarse spray qualities compared to nozzles that produce Fine and Medium spray qualities. Kromekote collectors were positioned in four configurations in an oat (Avena sativa L.) var. ‘Yarran’ (AusWest Seeds, Forbes, NSW, Australia) crop to quantify the coverage and droplet number densities (droplets cm⁻²) across three application carrier volume rates: 50, 75 and 100 L ha⁻¹. Applications were made in the field in 30 cm tall, tillering oats, with collectors arranged in a randomised complete block design with three replications. The entire study was repeated on the following day. Results showed that droplet number densities were inversely related to the droplet size produced by the nozzles, yet coverage was increased more by application volume rate than droplet size. Thus, both spray drift reduction and improved canopy penetration can be achieved with proper nozzle selection and operation parameters for the control of agronomic pests.     

Effects of a high milk intake during the pre‐weaning period on nutrient metabolism and growth rate in Japanese Black cattle

This study aimed to determine the effects of feeding an increased volume of high‐fat milk during the early post‐natal life on metabolite concentrations in the blood, the expression of key genes regulating intermediary metabolism in the skeletal muscles, and the rate of growth of Japanese Black cattle. All calves were fed a high‐fat milk replacer (crude protein, 26%; crude fat, 25.5%; total dissolved nitrogen, 116%). Control calves (n = 4) were nursed with 500 g milk replacer until 3 months of age, whereas calves in the experimental group (n = 4) were nursed with 1800 g milk replacer until 3 months, and then the volume was gradually reduced until 5 months. Body weight was significantly higher in the experimental group than in the control group at 7 months. Plasma glucose concentrations were significantly lower in the experimental group. Expression of glucose‐transporter‐4 messenger RNA (mRNA) was lower, whereas that of glucose transporter 1, cluster of differentiation 36, and carnitine palmitoyltransferase‐1b mRNA was significantly higher in the Longissimus thoracis of the experimental group. Nutritional status during early post‐natal life appears to strongly influence the growth rate and glucose and lipid metabolism in Japanese Black cattle.     

Respond of Stock Trading Volume to Earning Report

Earning report is a main accounting report that transmits earning information to users. It is the core of financial reports system. Earning information is significant to users' decision making. This paper studies the respond of stock trading volume to earning report and draws the curve of trading volume before and after earning report. This paper further does a regression analysis of accidental earning and abnormal return rate, and draws the relation curve of them on the earning report date to prove stock trading volume does have remarkable respond to earning report. This research is significant to either lessen small investors blindness investment and help them make reasonable forecast to markets and regulate the disclosure of listed companies.     

重力式计量包装机的设计与研究

介绍了定量包装机的结构、气缸选型以及料仓容积等参数的计算。该机配以PLC气动控制装置、嵌入式电脑核心的包装机控制仪,具有高精度、高速度及长期工作可靠性好等特点。它可以和自动取袋、封口机配合使用,根据不同物料的料性及工艺要求,进行自动称重包装,从而满足了国内粮食及其初深加工产品计量包装的性能指标要求,并广泛应用于粮食、化工等行业。     

栽培槽大小对日光温室架式栽培番茄生长发育、水肥利用和产量品质的影响

利用封闭式循环供液高架栽培系统,研究了栽培槽大小(横切面宽度×深度:20cm×10cm,20cm×15cm,20cm×20cm)和钵栽(直径12cm×高10cm,基质容积1L)对架式栽培番茄(3穗果摘心)生长发育、水肥利用及产量品质的影响。结果表明:与钵栽相比,槽栽促进番茄植株生长,增加产量,但开花和采收时间延迟,果实品质下降,水肥利用效率降低;随着栽培槽体积的增大,植株生长旺盛,干物质积累量增加,但水肥利用效率降低,果实品质下降,不同大小栽培槽处理间水分利用效率和单株产量差异不显著。综合产量、品质及水肥利用效率等指标,番茄架式栽培槽大小以20cm×10cm为宜。     

现代电子称重技术发展对森林收获计测的影响

回顾森林收获计测技术的发展历史,分析现代电子称量技术的发展应用前景,指出木材及木制品以体积计量计价的局限性和以重量计量计价的优势,认为当前一些木材市场上出现的买卖双方以重量而不是以材积计量计价现象有其历史必然性。基于以重量计量计价更为客观、准确、快捷、高效,并大幅降低成本的优势,其在纸浆等工业原料林经营、林业碳汇贸易等方面具有广泛应用潜力。     

Temporal changes of soil physical quality under two residue management systems

Although crop residue management is known to affect near‐surface soil physical quality, little is known about the temporal variability of these indicators over short time intervals. This study evaluates the temporal changes of nine indicators of soil physical quality. These are organic carbon content, structural stability index, bulk density, macroporosity, air capacity, relative field capacity, plant available water capacity, Dexter's S‐index and saturated hydraulic conductivity. A second set of soil physical indicators, based on the distribution of soil pore volume, was also evaluated. The indicators were determined in three different times during the growing cycle of winter durum wheat cultivated within a long‐term field research carrying out in Southern Italy and comparing two types of crop residue management, that is, burning (B) and soil incorporation (I). Only the bulk density changed over time for both treatments, although the air capacity also changed for the incorporation of wheat residues. Residual effects of the autumnal soil tillage and soil compaction were a common source of variability, irrespective of which treatment was used. Based on the existing guidelines for evaluating the physical quality of these agricultural soils, optimal or near‐optimal values were detected in about half of the cases under consideration. This suggests that both B and I create sufficiently good conditions for crop growth during the crop cycle. The comparison between observed and optimal soil pore distribution function was always poor. The pore volume distributions showed lower densities of small pores and relatively higher densities of large pores than the proposed optimal distribution. This study also suggests that the considered optimal or references curves probably cannot be applied successfully to a wide range of agricultural soils.