Changes in meat texture of three varieties of squid in the early stage of cold storage

ABSTRACT: The present study examined the changes in texture and protein components during cold storage of different squid varieties. Raw oval squid, Japanese common squid and arrow squid were sliced fresh and the muscles were stored at 4°C for 0, 4, 8, 12, 18, 24, 48 and 120 h. The rheological measurements, protein components and amounts of collagen were examined. The adhesiveness of each squid increased significantly in the early stage of cold storage. In all varieties, penetration decreased at 4 h, which is considered to be rigor mortis, then increased. The amounts of total collagen, 20°C water-soluble collagen and 70°C water-soluble collagen did not change significantly in each variety during cold storage. Sodium dodecylsulfate–polyacrylamide gel electrophoresis (SDS-PAGE) pattern showed that the 580 kDa component gradually disappeared up to 48 h. The correlations between the amounts of 580 kDa component and adhesiveness or firmness were high. Models of fit based on chemical kinetics accurately expressed the behavior of adhesiveness, firmness and penetration showing that 63.2% of adhesiveness changes occurred in 13–19 h and that 63.2% of firmness changes occurred in 18–24 h.     

中药饲料添加剂对法国肉用鹌鹑增重及肉质的影响

用1周龄法国肉用鹌鹑120只,随机分成4组,每组3个重复,每个重复10只.第1～3组为试验组,分别在基础日粮中添加1％的党参、0.5％党参 0,5％黄芪、0.5％党参 0.5％艾叶,第4组为对照组.试验期为2～6周龄,共35d,每7d称重一次.试验结果表明,各试验组的增重与对照组相比,差异均显著(P<0.05);其中第3组效果最好(P<0.01).日粮蛋白质表观代谢率和料肉比,试验组均优于对照组(P<0.05).各组间的肌肉概略养分、pH值和胴体品质,除第1组的屠宰率略高外(P<0.05),其余差异均不显著(P>0.05).嫩度值差异极显著(P<0.01).血清总蛋白质和A/G差异不显著(P>0.05),但血糖含量差异较大(P<0.01).     

一种多尺度纹理主频的检测与分割

介绍了一种对含有多种纹理结构的图像的纹理主频检测——香农小波包分解的纹理主频检测 ,然后利用 Gabor滤波器确定主频 ,最后应用边缘提取实现纹理分割     

浅谈园林植物配置的艺术手法

随着城市的发展，园林植物在景观上的作用越来越重要，文章主要分析园林植物外在的线条、外形、质地、色彩的特性，并归纳了一些处理植物配置与色彩、质地、距离、光影、地形等之间关系的艺术手法。     

Turbiscan Lab分散稳定性分析仪研究异丙甲草胺水乳剂物理稳定性

为获得不同因素对异丙甲草胺水乳剂物理稳定性的影响规律,同时验证Turbiscan Lab分散稳定性分析仪预测和评价水乳剂物理稳定性的可行性,利用Turbiscan Lab分散稳定性分析仪,结合加速试验[(54±2)℃,14d]结果,研究了乳化剂用量、体系pH和电解质离子等对磷酸酯盐稳定的异丙甲草胺水乳剂物理稳定性的影响。结果表明:乳化剂三苯乙烯基苯酚聚氧乙烯醚磷酸酯三乙醇胺盐(SCP)用量为6.0%(质量分数)时,水乳剂稳定性最好;过酸或过碱均会破坏水乳剂的稳定性,pH=9时水乳剂可获得较好的稳定性;Mg2+压缩油水界面双电层,导致水乳剂稳定性下降,且Mg2+添加浓度越大,水乳剂越不稳定。Turbiscan Lab分散稳定性分析仪以多重光散射为技术核心,在不破坏样品的前提下,能够准确测定乳状液中浮油、沉淀和液滴粒径大小的变化情况,与加速试验结果吻合度高,不仅能够缩短试验周期,而且可以分析不稳定现象发生的机理。     

蟠桃新品种‘中蟠桃11号’

‘中蟠桃11号’是以‘红珊瑚’ב91-4-18’(NJN78×奉化蟠桃)杂交,结合胚挽救技术获得的蟠桃新品种。花铃形。单果质量180~200 g,果皮60%以上着鲜红色,果肉橙黄色,肉质为硬溶质。果实风味浓甜,可溶性固形物含量14%,粘核。耐运输。7月中下旬成熟,果实发育期120 d。极丰产,平均产量为38 888 kg·hm-2,     

Evaluation of maternal parent and puroindoline allele on kernel texture in a reciprocal cross between two hard spring wheat cultivars

Kernel texture is an important characteristic for both the milling and the end-use quality of wheat (Triticum aestivum L.). Gene sequence variation and mutations to the two puroindoline genes (Pina and Pinb), located at the Ha locus on chromosome 5DS, account for the majority of variation in wheat kernel texture. Other factors also influence kernel texture, including effects associated with different maternal parent backgrounds. To investigate the effect of two hard puroindoline alleles in different maternal backgrounds, a population of 228 recombinant inbred lines (RILs) derived from a reciprocal cross between two wheat cultivars ID377s (Pina-D1b/Pinb-D1a) and Klasic (Pina-D1a/Pinb-D1b) were examined in two succeeding generations (F₇ & F₈). Kernel texture was determined using the Single Kernel Characterization System (SKCS) and the RIL puroindoline haplotype was identified by the sequence-specific PCR amplification of each gene. Analysis of variance identified a significant (P 0.001) effect of the maternal parent and puroindoline mutation on kernel texture. RILs containing the Pina-D1b mutation were significantly harder than lines containing the Pinb-D1b mutation. RILs which had Klasic as the maternal parent were significantly harder than those which had ID377s as the maternal parent. When the maternal parent and puroindoline allele were analyzed in combination, RILs derived from Klasic as the maternal parent and the Pina-D1b allele were significantly harder (P 0.001) than those containing the same allele but ID377s as the maternal parent. The same occurred for RILs containing the Pinb-D1b allele, lines with Klasic as the maternal parent were harder than lines with ID377s as the maternal parent. These results corroborate the harder phenotype of the Pina-D1b allele and indicate a significant maternally-inherited contribution to kernel texture variation.     

The effect of lupins as compared with peas and oats on the yield of the subsequent winter barley crop

New high yielding early maturing cultivars of lupins have been introduced in north-west Europe as grain protein crops in crop rotations. This paper reports on a comparative study of lupins with peas and oats, and of their effect on yield of subsequent winter barley crops. These crops were given five levels of N under irrigated and non-irrigated conditions on sand and loam. Under rain fed conditions the grain yield of pea, oat and lupin varied between 24–36, 34–53 and 18–37 hkg DM ha⁻¹, respectively. Supplemental irrigation raised grain yield of oat to 50–60 hkg DM ha⁻¹, while grain yield in pea was not affected and grain yield in lupin in most cases decreased due to gray mould attack and excessive vegetative growth in the indeterminate lupin variety. Under rain fed conditions, the grain nitrogen content of pea, oat and lupin varied between 137–172, 61–80 and 189–226 kg N ha⁻¹, respectively, and was significantly higher in lupin as compared with pea. On sandy soil, similar low-root densities were found for pea, oat and lupin below 30 cm depth. On sand, at final harvest the residual soil-N of lupin and pea, as measured in a subsequent winter barley crop not supplied with N fertilizer, was 15 and 8–10 kg N ha⁻¹ higher than in winter barley following oat, respectively. The nature of the probably more N-root residues of lupin is discussed. On loam, the residual N of lupin and pea was similar, 18–27 kg N ha⁻¹. On sand, under rain fed conditions preceding lupin and pea as compared with oat, increased the barley grain yield at zero N-application 77 and 49%, respectively; the effect of lupin was significantly higher than that of pea until the highest N-level 120 kg N-application ha⁻¹. On loam under rain fed conditions preceding lupin and pea increased the barley grain yield at zero N-application by 36 and 62%, respectively, as compared with oat; at N-application>60 kg N ha⁻¹ the grain yield was similar after all three crops. For both soil types the same level of effect was found under irrigated conditions. Conclusions: Supplemental irrigation might result in lower grain yield in lupin due to gray mould attack and excessive growth if indeterminate lupin varieties are used. Grain nitrogen yield of lupin is significantly higher than that of pea. On sand, the effect of lupin on the subsequent winter barley grain yield is significantly higher than that of pea, probably due to greater N-root nitrogen residues. On loam, lupin and pea have similar effects on the subsequent winter barley crop.     

Inheritance of firmness in raw cucumber (Cucumis sativus L.) fruit

Summary Inheritance of raw cucumber fruit texture (Magness-Taylor Fruit Pressure Tester firmness) was investigated over a 4-year period from 1971–1974. Results from 2 separate but related experiments suggested that firmness was quantitatively inherited with sufficient additive effects to permit gain from selection. In a selection study within 4 F₂ populations derived from crosses between firm (Chipper and Gy3) and soft (Mincu and Green F) fruit type cultivars, variation among and within F₃ and F₄ families was significant but overall family means were not significantly higher than the high parent in any of the 4 crosses. Narrow sense heritability estimates for fruit texture were 0.80 in the Mincu × Chipper population and 0.77 in the Green F × Chipper, Mincu × Gy3, and Gy3 × Green F crosses. In a separate experiment, generation means analysis was used to assess the mode of gene action in 2 crosses: Green F × Chipper, and Gy3 × Green F. Additive genetic effects accounted for 98.8% and 99.3% of the total genetic variation within each cross, respectively.Scientific Journal Series Paper No. 9794.     

Construction and Realization Method for 3 -D Digital City

This paper studies the key technology in the 3 - D digital city construction, and puts forward a new method to construct and realize the 3 - D digital city. The authors discuss the dates gathering and disposal from the collection of 3 - D topograph dates, the construction and ingress of 3 - D model, the gathering and disposal of texture dates. Subsequently, to solve the problem of that the 3 - D topograph dates are greater than the 2 - D topograph, the bulk-dates optimization of 3 - D digital city is realized through the choose of appropriate DEM of linenumbers and column numbers, the 3 - D model modeling specification, the using of nodes replace, the optimization of LOD modeling. The successful operation result of Chongqing Hi-tech Development Zone 3 - D digital city project illustrates that, this system can realistic mimic status in quo of the Chongqing Hi-tech Development Zone, the system operates smoothly, and its effect is also well.