| 平均铣削厚度对MDF铣削粉尘粒度分布及表面粗糙度的影响 |
| |
| 引用本文： | 郭晓磊,曹平祥,江应.平均铣削厚度对MDF铣削粉尘粒度分布及表面粗糙度的影响[J].安徽农业科学,2010,38(19):10078-10080,10241. |
| |
| 作者姓名： | 郭晓磊 曹平祥 江应 |
| |
| 作者单位： | 南京林业大学木材工业学院,江苏南京,210037;南京林业大学木材工业学院,江苏南京,210037;南京林业大学木材工业学院,江苏南京,210037 |
| |
| 基金项目： | 国家自然科学基金，江苏省2009年度普通高校研究生科研创新计划，南京林业大学科技创新基金 |
| |
| 摘 要： | 研究了不同平均铣削厚度条件下MDF铣削粉尘粒度分布状态及典型粒度粉尘的形态,并在此基础上测试了MDF铣削表面的粗糙度。结果表明,铣削MDF粉尘粒度分布主要集中在0.5～450.0μm,铣削MDF粉尘颗粒基本上为狭长型纤维状。随着平均铣削厚度的增加,MDF粉尘的平均粒度{D（4,3）,D（3,2）}及中位径D（50）呈逐渐增大的趋势,而铣削速度影响较进给速度影响明显。随着平均铣削厚度的增加,MDF铣削表面质量降低,而铣削速度影响较进给速度影响明显。
|
| 关 键 词： | 粉尘粒度 粗糙度 MDF铣削 |
Effect of Average Chip Thickness on Dust Particle Size and Surface Roughness |
| |
| GUO Xiao-lei et al.Effect of Average Chip Thickness on Dust Particle Size and Surface Roughness[J].Journal of Anhui Agricultural Sciences,2010,38(19):10078-10080,10241. |
| |
| Authors: | GUO Xiao-lei |
| |
| Institution: | GUO Xiao-lei et al(College of Wood Science and Technology,Nanjing Forestry University,Nanjing,Jiangsu 210037) |
| |
| Abstract: | Dust particle size distribution and typical dust morphologies in MDF milling were studied.And the surface roughness and quality were measured.The results showed that dust particle size distribution during MDF milling concentrated in the interval of 0.5-450.0 μm,and the dust particles mainly exhibit fibrous morphology.With the increase of average chip thickness,the average particle size and the middle diameter of dust during MDF milling were also increasing,and the milling speed had a significant effect.With the increase of average chip thickness,the surface quality during MDF milling was decreasing,and the milling speed had a significant effect. |
| |
| Keywords: | Dust particle size Surface roughness Milling of MDF |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
|
