首页 | 本学科首页   官方微博 | 高级检索  
     检索      


Yield of bolting winter beet (Beta vulgaris L.) as affected by plant density,genotype and environment
Institution:1. School of Medicine (Emeritus), University of California, Irvine, CA, USA;2. McConnell Brain Imaging Center, Montreal Neurological Institute, Montreal, Canada;3. Douglas Mental Health University Institute, Department of Psychiatry, McGill University, Montreal, Canada;4. Universidad Autónoma de Madrid-Fundación CIEN/Fundación Reina Sofía, Spain;5. Department of Neurosurgery, University of New Mexico, Albuquerque, NM, USA;6. MRC Centre for Cognitive Ageing and Cognitive Epidemiology and Department of Psychology, University of Edinburgh, UK;1. Universidade de Lisboa, Instituto Superior de Agronomia, Unidade de Investigação de Química Ambiental (UIQA), Tapada da Ajuda, 1349-017 Lisboa, Portugal;2. Universidade de Lisboa, Instituto Superior Técnico, Centro de Petrologia e Geoquímica Instituto Superior Técnico (CEPGIST), Av. Rovisco Pais, 1049-001 Lisboa, Portugal;3. Universidade de Lisboa, Instituto Superior Técnico, Av. Rovisco Pais, 1049-001 Lisboa, Portugal
Abstract:Winter beet roots and shoots might be a favorable substrate for biogas production in Central Europe. However, detailed information about the attainable yield of this crop is lacking. Thus, the impact of plant density, genotype and environmental conditions on total dry matter yield of winter beet crops that bolt after winter was investigated. A significant increase of the dry matter yield (esp. shoot) was expected by harvesting the 1st shoot after flowering in June followed by a final harvest of the whole plant in July. In 2009/10, 2010/11 and 2011/12, three series of field trials with (i) 3 target plant densities (148, 246, 370 thousand plants ha?1) and (ii) 3 different sugar beet genotypes were conducted at Göttingen (Lower Saxony, GER) and Kiel (Schleswig-Holstein, GER); (iii), additional field trials with 5 different sugar beet genotypes cultivated at 2 target plant densities (148, 246 thousand plants ha?1) were conducted in 2011/12, to investigate the relation between maximum taproot diameter and the shoot and taproot yield of bolting winter beet. The total dry matter yield considerably varied between 4 and 23 t ha?1. It was predominantly affected by the environment and to a substantially lower extent by plant density. Increasing plant densities increased the total dry matter yield, resulting in a significantly higher total dry matter yield at plant densities ≥300,000 plants ha?1 compared with lower plant densities. Genotypic differences in total dry matter yield were negligibly small. Pruning in June substantially increased the total dry matter yield in July by ca. 8 t ha?1 only in one out of three environments.Final yield in June (without pruning) and July (pruning in June) was positively related with cumulated temperature and global radiation, but also with taproot dry matter yield before winter. The taproot, shoot (1st, 2nd) and total plant yield were positively correlated with maximum taproot diameter.In conclusion, high dry matter yields close to yields of established energy crops grown over winter were obtained with winter beet roots and shoots only under very favorable conditions (climate, single plant size). High yields can be achieved after good pre-winter development. However, for sufficient frost tolerance the taproot size of plants must be rather small. Hence, the cultivation of bolting winter beet under Central European climate conditions has to face a severe conflict of goals concerning winter survival and yield formation.
Keywords:Sugar beet  Biomass yield  Pruning  Energy crop  Taproot diameter
本文献已被 ScienceDirect 等数据库收录!
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号