| 孔位置度综合量规的设计方法研究 |
| |
| 引用本文： | 梁爱琴 全林斯. 孔位置度综合量规的设计方法研究[J]. 河南农业大学学报, 1995, 29(2): 161-166 |
| |
| 作者姓名： | 梁爱琴 全林斯 |
| |
| 作者单位： | 河南农业大学机电工程学院 |
| |
| 摘 要： | 结合用于ＥＱ－１４０汽车发动机水泵体孔位置度检验的综合量规设计，讨论了孔位置度的检验方法，系统探讨了综合量规的设计步骤及方法，即：检测方法的，总体结构设计，测量要素的尺寸选择，分析与计算确定等可作为设计制造量规的参考。
|
| 关 键 词： | 孔位置度 综合量规 设计 |
Study on the way of Designing the Synthetic Error Gauge for Measuring the Degree of Hole Positions |
| |
| Liang Aiqin Quan Linsi et al. Study on the way of Designing the Synthetic Error Gauge for Measuring the Degree of Hole Positions[J]. Journal of Henan Agricultural University, 1995, 29(2): 161-166 |
| |
| Authors: | Liang Aiqin Quan Linsi et al |
| |
| Abstract: | This paper discussed the was of measuring the degree of hole positions. Combinedwith the design of synthetic error gauge which is used to measure the degree of hole posi-tions of the water pump shell of the EQ-140 car engine,the methods and steps of designingthe synthetic error gauge have been systematized,that is,determing the measuring meth-ods, designing the overall structure,selecting,analysing,caculating and determining thesize of the measured key elements,etc. The way can be used as reference for designingmeasuring tools. |
| |
| Keywords: | degree of hole position synthetic error galuge design |
| 本文献已被 CNKI 维普 等数据库收录！ |
