| Abstract: | The effect of fungicide spray droplet density (droplet cm-2), droplet size, and proximity of the spray droplet deposit to fungal spores was investigated with Mycosphaerella fijiensis ascospores on the banana (Musa AAA) leaf surface for two contact fungicides: chlorothalonil and mancozeb. When droplet size was maintained at a volume median diameter (VMD) of 250 μm while total spray volume per hectare changed, M. fijiensis ascospore germination on the leaf surface fell below 1% for both fungicides at a droplet deposit density of 30 droplet cm-2. At a droplet deposit density of 50 droplet cm-2, no ascospores germinated in either fungicide treatment. When both droplet size and droplet cm-2 varied while spray volume was fixed at 20 litre ha-1, ascospore germination reached 0% at 10 droplet cm-2 (VMD=602 μm) for both fungicides. At lower droplet densities (2–5 droplet cm-2 VMD=989 μm and 804 μm respectively), ascospore germination on the mancozeb-treated leaves was significantly lower than on the chlorothalonil-treated leaves. The zone of inhibition surrounding a fungicide droplet deposit (VMD=250 μm) on the leaf surface was estimated to extend 1·02 mm beyond the visible edge of the spray droplet deposit for chlorothalonil and 1·29 mm for mancozeb. The efficacy of fungicide spray droplet deposit densities which are lower than currently recommended for low-volume, aerial applications of protectant fungicides was confirmed in an analysis of leaf samples recovered after commercial applications in a banana plantation. Calibrating agricultural spray aircraft to deliver fungicide spray droplets with a mean droplet deposit density of 30 droplet cm-2 and a VMD between 300 and 400 μm will probably reduce spray drift, increase deposition efficiency on crop foliage, and enhance disease control compared to aircraft calibrated to spray finer droplets. © 1997 SCI. |
