首页 | 本学科首页   官方微博 | 高级检索  
     

厌氧附着膜膨胀床工艺处理有机污水的研究
引用本文:俞秀娥,郑平,方士,周志勤,冯孝善. 厌氧附着膜膨胀床工艺处理有机污水的研究[J]. 浙江大学学报(农业与生命科学版), 1989, 0(2)
作者姓名:俞秀娥  郑平  方士  周志勤  冯孝善
作者单位:浙江农业大学环境保护系(俞秀娥,郑平,方士,周志勤),浙江农业大学环境保护系(冯孝善)
摘    要:用厌氧附着膜膨胀床工艺处理高浓度有机污水,可以取得相当高的运行效率,在进水COD浓度依次为5104,11006和29874mg/l,水力滞留时间为4.0,8.0和17.7小时的条件下,装置的COD负荷达30.6,33.0和40.4g/1.d,容积产气率达13.4,14.7和16.9 1/l.d,COD去除率稳定在80%以上,沼气CH_4含量高于56%.试验表明,处理上述各档浓度污水的适宜COD负荷为359/1.d;适宜的水力滞留时间为4.0,8.0和18.0小时.

关 键 词:厌氧附着膜膨胀床工艺  高浓度有机污水  水力滞留时间  COD负荷

Study on Trpatmentt of Concentrated Organic Wastewater with the Anaerobic Attached Microbial Film Expanded Bed Process
Yu Xiu'e et al.. Study on Trpatmentt of Concentrated Organic Wastewater with the Anaerobic Attached Microbial Film Expanded Bed Process[J]. Journal of Zhejiang University(Agriculture & Life Sciences), 1989, 0(2)
Authors:Yu Xiu'e et al.
Affiliation:Zhejiang Agricultural University
Abstract:The efficiency of treating concentrated organic wastewater with the anaerobic attached microbial film expanded bed process was studied. When influent COD concentration were 5 104, 11 006 and 29874 mg/1, and HRT 4.0, 8.0 and 17. Y hours, the volumetric COD loadings were 30.6, 33.0 and 40.4 g COD/1.d, volumetric biogas production rates 13.4, 14.7 and 16.9 1/1. d, respectively, percent COD removal was more than 80% and methane content of the biogas more than 56%. The results showed that the optimum COD loading was about 35 g/1. d and the optimum HRT were 4.0, 8.0 and 18.0 hours, respectively.
Keywords:AAFEB process  concentrated organic wastewater  HRT5 organic loading rate
本文献已被 CNKI 等数据库收录!
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号