The effects of density and artificial substrate on intensive shrimp Litopenaeus vannamei nursery production

Recirculating aquaculture systems (RAS) can be installed indoors, allowing year-round production of tropical animals in nearly any climate. A nursery phase is commonly used in Litopenaeus vannamei production since it allows for enhanced biosecurity and better quantification of animals while reducing space requirements. However, it is unclear whether animal density and inclusion of artificial substrate may improve shrimp performance during the nursery phase. In this experiment, we compared shrimp production parameters in two stocking densities with or without the use of an artificial substrate by creating four treatments: low-density LD; 1500 PL/m^?3, low-density with substrate LDS, high-density HD; 3000 PL/m^?3), and high-density with substrate (HDS). The LDS and HDS treatments included 0.46-m² of high-density polyethylene 2.5-cm mesh as a substrate, which increased the tank surface area by 21 %. Each treatment was randomly assigned to four 160-l culture tanks, each with a biofilter. The shrimp had an initial weight of 4 mg and were grown for 50 days. The low-density treatments had significantly higher dissolved oxygen (DO) and pH than the high-density treatments (P ≤ 0.001). Specifically, LDS had the highest DO and pH followed by the LD, HD, and HDS treatments, respectively. High-density treatments had significantly higher NO₂-N levels than low-density treatments during week 2 of the experiment when an unusually high concentration of nitrite was observed. FCR was significantly lower in both low-density treatments than in high-density treatments. At harvest, the total biomass (kg m^?3) was significantly higher in high-density treatments than in low-density treatments (P ≤ 0.001), and the HDS treatment had a significantly greater biomass output than HD. Producers should consider artificial substrate and higher densities during nursery production to maximize shrimp production; however, the effects on water quality should also be taken into account.