On the mechanical interaction between cellulose microfibrils and matrix substances in wood cell walls: effects of chemical pretreatment and subsequent repeated dry-and-wet treatment

We investigated the influences of chemical pretreatments and subsequent repeated dry-and-wet (RDW) treatments on the mechanical linkage between cellulose microfibrils (CMFs) and matrix substances (MT) in wood cell wall. Sugi (Cryptomeria japonica D. Don) quarter-sawn specimens were subjected to various types of chemical pretreatments, including ethanol and benzene extraction, delignification, alkali extraction, and hygrothermal treatment, to give substantial damages to principal constituents of wood cell wall, followed by 5 times of RDW treatment. After giving chemical pretreatment, the d-spacing of (200) lattice plane of cellulose I_β (d ₂₀₀), the crystallinity of wood cell wall, and the crystal size of the cellulose were measured at the fiber saturated point, using X-ray diffraction techniques. Thereafter, these were measured again at the absolutely dried condition in the process of subsequent RDW treatments. The d ₂₀₀ in specimens, which were given to light pretreatments, largely expanded by drying at the early stages of RDW treatments, then it decreased and became constant after 5 times of RDW treatments. On the other hand, d ₂₀₀ in specimens, which were given to intensive pretreatments, remained constant at a relatively small level throughout the whole process of RDW treatments. After 5 times of RDW treatments, d ₂₀₀ became similar values between the above two groups. This suggests that RDW treatments have similar effects as intensive pretreatments, which induce substantial damages to the microscopic region in the wood cell wall such as interfacial separation between CMF, MT, and so forth. These defects would weaken mechanical interaction between CMF and MT in the wood cell wall during drying.