Overload-controlled cultivation shanks under static loads

Cultivators for stony soils have to be protected to prevent breakage. Draft forces of cultivator shanks in hard clod-forming soils are higher than in the temperate soils of wet areas. Load-control devices are used to prevent breakage, but most of them cannot maintain constant depth in hard soils.

Load-controlled light cultivator shanks and chisel plows were tested to define their behaviour under high soil resistances and obstacles. The shanks were loaded with horizontal forces to simulate soil resistances as found in cultivating hard clod-forming soils.

The variations in the depth, the lift angle and the backward deflection were measured. The maximum stresses on the shanks were calculated.

It was found that only the light cultivator shank with a pre-loaded special design moment control device can till hard soils with small reasonable depth variations and still run over an obstacle without being broken.

Only the heavy chisel plow with the rear spring load control device can run over an obstacle without being broken, but it loses cultivation depth under too low a soil resistance, compared with the maximum draft that it can hold.