Development of an air-injection press for preventing blowout of particleboard IV: effects of air-injection conditions on board performance and formaldehyde emission

An air-injection press, which has holes punched in the heating plates, injects high-pressure air through the holes of one plate into particleboard and discharges the air through the other plate during press heating. The press can manufacture particleboard from high-moisture particles by controlling blowout of the boards. In this study, the optimum diameter and spacing of the air-injection holes and the effects of pre- and post-pressing were investigated. An optimum hole diameter was not found for the modulus of rupture and thickness swelling for a spacing of either 25 or 50 mm. In terms of internal bond strength, the optimum diameter of the holes arranged at a spacing of 25 mm was 1 mm, but the internal bond strength was not changed by the diameter of holes spaced 50 mm apart. Air injection under all hole conditions reduced the formaldehyde emission from the board. Pre-pressing was tested for further increase in the modulus of rupture and internal bond strength, but was found to have no effect. More efficient use of the air-injection press was achieved by injecting air from the early stages of pressing.