首页 | 本学科首页   官方微博 | 高级检索  
     检索      


Dimensional stability of wood-plastic combinations to moisture changes
Authors:Wesley E Loos
Institution:(1) Engineering Experiment Station, West Virginia University, Morgantown, West Virginia, USA;(2) Present address: School of Forestry, Louisiana State University, Baton Rouge, Louisiana, USA
Abstract:Summary Anti-shrink efficiency (ASE) measurements were made on four wood-plastic combinations (WPC). The WPC test d were made from loblolly pine and yellow-poplar impregnated with polymethylmethacrylate, P (MMA), and a poly(styrene-acrylonitrile), P (ST+ACN).The ASE values were much higher with P (ST+ACN) than with P (MMA) for both species of wood and were higher for yellow-poplar than for loblolly pine for both polymer species The high ASE for the P(ST+ACN) WPC systems is explained by the fact that this comonomer solution swells the wood during treatment and thus creates a bulking action. The maximum ASE values were obtained at intermediate polymer loadings (sim50% full) rather than at very high polymer loadings. The reason for this was that the samples shrank during treatment when the polymer loading was high, therefore the sample was stressed. During the swelling these stresses were relieved causing greater than normal swelling.
Zusammenfassung Die Wirkung einer Schwindungs-Vergütung wurde an vier Holz-Kunststoff-Kombinationen gemessen. Diese Holz-Kunststoff-Kombinationen bestanden aus Lobolly pine und Gelbpappel jeweils imprägniert mit Polymethylmetracrylat P (MMA) und mit Polystryrenacrylonitril P (ST+ACN).Die Werte für die Schwindungsvergütung lagen bei beiden Holzarten für P (ST+ACN) höher als für P (MMA) und ebenso für Gelbpappel bei beiden Kunststoffen höher als für Lobolly pine. Die bessere Wirkungsweise des P (ST+ACN) wird durch die Tatsache erklärt, daß dieses Monomer das Holz während der Behandlung quellen läßt, wodurch ein raumfüllender Prozeß in Gang kommt. Die höchsten Werte der Schwindungs-Vergütung wurden bei einer mittleren Beladung mit Polymeren (rd. 50%) erzielt; sie waren besser als bei sehr hoher Polymer-Beladung. Ursache hierfür war ein Schwinden der Proben während der Behandlung mit hoher Polymer-Beladung, wodurch die Proben unter Spannung kamen. Während der Quellung wurden diese Spannungen aufgehoben und hatten dann eine übernormale Quellung zur Folge.
Keywords:
本文献已被 SpringerLink 等数据库收录!
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号