Determination and use of moisture diffusion coefficient to characterize drying of northern red oak (Quercus rubra) |
| |
Authors: | W. T. Simpson |
| |
Affiliation: | (1) USDA Forest Service Forest Products Laboratory, One Gifford Pinchot Drive, 53705-2398 Madison, WI, USA |
| |
Abstract: | Summary Diffusion analysis can be used to estimate the time required to dry lumber. However, more accurate calculations require additional information on the relationship between the diffusion coefficient as a function of moisture content and on the effects of temperature, equilibrium moisture content, board thickness, and air velocity on drying time and moisture gradients. The primary objectives of this study were (1) to determine the diffusion coefficient of northern red oak (Quercus rubra) as a function of moisture content and (2) to compare experimentally determined sorption times and moisture content gradients with those calculated by the diffusion model. The diffusion coefficient was found to increase approximately exponentially with moisture content over a range of 6 to 30 percent at 43°C. This relationship was similar in both adsorption and desorption tests. Experimental adsorption and desorption times and desorption moisture content gradients were compared with finite difference solutions to the diffusion equation. Practical uses of solutions to the diffusion equation are illustrated for kiln drying wood that has first been predried to below the fiber saturation point. Drying time is also related to variable kiln conditions and board thickness.This research was partially funded under the U. S. Department of Agriculture Competitive Grant programThe Forest Products Laboratory is maintained in cooperation with the University of Wisconsin. This article was written and prepared by U.S. Government employees on official time |
| |
Keywords: | |
本文献已被 SpringerLink 等数据库收录! |
|