Wildfire and salvage harvesting effects on runoff generation and sediment exports from radiata pine and eucalypt forest catchments, south-eastern Australia

This study examined the effect of wildfire and salvage harvesting on runoff generation and sediment exports from three small forest catchments in south-eastern Australia. In 2006, wildfire burnt a radiata pine catchment and two adjacent natural eucalypt forest catchments which formed part of a long-term hydrological research project. Subsequently, only the pine plantation catchment was salvage harvested. The combined effect of fire and salvage harvesting in the pine catchment caused a substantial increase in runoff compared to the burnt eucalypt forest catchments and pre-fire conditions, particularly in response to high intensity, short duration summer storms. Post-fire maximum suspended sediment concentrations from fixed-interval sampling greatly exceeded pre-fire values for both eucalypt and pine catchments, while sediment (suspended and bedload) exported from the pine catchment exceeded each of the eucalypt catchments by a minimum of 180 and 33 times. However, the export increase was probably closer to 320 and 71 times based on a survey of eroded channels in the pine catchment combined with measured post-survey exports. Notably, seven summer storm events accounted for approximately 80% of the pine catchment sediment yield. Hillslope process measurements indicated that the highest runoff velocities occurred in log drag-lines formed by cable harvesting, while soil water repellency was more extensive in the harvested pine catchment than in the adjacent eucalypt catchment. The latter effect probably resulted from higher burn severity in the pines combined with reduced soil moisture due to less shading after harvesting. Runoff modelling indicated that the log drag-lines acted as an extension to the drainage network and increased peak flows at the harvested catchment outlet by 48% for a high intensity summer storm event, while substantial reductions in modelled runoff were achieved through increasing the hillslope surface roughness coefficient. It is recommended that post-fire salvage operations should avoid the formation of log drag-lines when using cable harvest techniques and maximise surface cover to limit increases to runoff, erosion and catchment sediment exports.