营养坯育苗技术和效益对比

池杉营养坯育苗技术环节包括有浸种催芽、制坯育苗和栽培管理．池杉营养坯育苗比常规育苗利用地力高，经济效益好。宜于平原地区推广应用。     

高分子吸水剂在沙地植被重建中的盆栽效果试验

本试验于2002年4～10月在红原县进行,其目的在于通过对吸水剂的盆栽试验,探讨吸水剂对植株生长的作用,从而达到节水重建植被的目的。     

套袋黄冠梨黑点病与钙素营养和果实衰老的关系

为探明套袋黄冠梨果实黑点病发病原因,从采后生理、矿质营养水平、酚类物质酶促褐变和果实衰老等方面对套袋黄冠梨果实黑点病进行了研究。结果表明:套袋果呼吸强度显著高于不套袋果;套袋果Ca含量仅为不套袋果的49%-63%,果皮钙素含量未套袋果>套袋健康果>套袋病果,套袋病果与不套袋果果皮N/Ca比值分别为9.8和6.1,K/Ca比值分别为17.6和8.8;果皮和果心酚类物质含量及多酚氧化酶活性(PPO)呈套袋病果>套袋健康果>未套袋果的趋势;套袋病果果皮丙二醛(MDA)含量及电导率显著高于未套袋果;果皮钙素含量与其PPO活性、多酚及丙二醛含量、电导率呈高度负相关。初步分析黄冠梨果实黑点病病因为缺钙性生理衰老。     

两种商品木浆的纸浆性能研究

选取市场上具有代表性的两种商品针、阔叶木浆进行PFI打浆处理,研究在不同打浆度下浆料纤维质量、动态滤水性能、Zeta电位、微观结构等方面的变化,并对不同比例配抄条件下的成纸性能进行考察,结果表明:针、阔叶浆的打浆度与打浆转数之间的关系均符合线性分布:y=17.7503+0.0015x,R^2=0.9914(针叶浆);y=8.8986+0.00275x,R^2=0.9734(阔叶浆);经PFI打浆后,两种木浆纤维长度、宽度变化较小,细小组分含量变化明显;随着打浆度的升高,两者的滤水性能下降,Zeta电位先上升然后基本保持不变;初始打浆度下,随着针叶浆比例的减少、阔叶浆比例的增加,成纸的抗张强度先下降再增大,厚度逐渐下降至不变,定量逐渐增加,柔软度逐渐下降;随着打浆度的升高,成纸的抗张强度增大,厚度、定量逐渐下降,针叶浆成纸柔软度逐渐下降,阔叶浆成纸柔软度先升高再逐渐降低。     

多菌灵降解菌的鉴定及降解条件初步优化

对已分离到的多菌灵降解菌进行16S r DNA序列分析后,采用均匀设计法,优化多菌灵降解菌降解条件。用4因素6水平混合均匀设计表,综合考察培养时间、接种量、p H、温度对多菌灵降解菌降解能力的影响。通过二次多项式逐步回归得出最终降解条件为:培养时间6 d、接种量10%、p H 4.0、温度为45℃时,最优目标函数Y(降解率)为68.65%。进一步进行盆栽试验,检测该菌在实际应用中的降解效率为59.54%。     

硒肥与钝化材料组配对土壤Cd钝化及稻米Cd消减效果

为了探讨不同硒肥施用方式联合钝化材料对土壤镉钝化和稻米镉消减的效果,采用盆栽试验的方式,选用亚硒酸钠作为硒肥,钙镁磷肥和硅藻土作为钝化材料,设置基施硒肥+钙镁磷肥+硅藻土和叶面喷施硒肥+钙镁磷肥+硅藻土2种方式,研究其不同用量对镉污染酸性稻田土壤修复与安全利用的影响。结果表明：随着施用量的增加,稻米产量增加,基施硒肥产量略高于叶面喷施硒肥,产量差为 2.115 g/pot,与对照(CK)相比,基施0.28%钙镁磷肥+0.12%硅藻土+0.004‰硒(T3)能够提高1.68倍的稻米产量;随着施用量的增加,pH升高,有效Cd降低,有机质与CEC变化不大;基施硒肥与叶面喷施硒肥处理对土壤pH、有机质与CEC差异不显著,但基施硒肥处理有效Cd含量略低于叶面喷施硒肥处理,T3对土壤Cd的钝化效果最佳;随着基施硒肥用量的增加,稻米Cd含量降低,随着叶面喷施硒肥用量的增加,稻米Cd含量先降低后升高,基施硒肥处理对稻米Cd的消减程度强于叶面喷施硒肥处理,相差 0.021 mg/kg,与对照(CK)相比,T3处理稻米Cd降低0.063 mg/kg。可见,硒对调控稻米镉累积具有重要作用,且基施硒肥强于叶面喷施。综上所述,基施0.28%钙镁磷肥+0.12%硅藻土+0.004‰硒对土壤Cd钝化与稻米Cd消减的效果最佳,值得在镉污染稻田推广应用。     

2株重组根瘤菌在4个大豆品种根圈中定殖动态的比较研究

在灭菌和未灭菌土盆栽缩影条件下，比较研究了重组大豆根瘤菌HN01DL和TA113QD在4个不同品种大豆根圈中的定殖动态与水平，并初步考察了其与共生效应的关系。结果表明：HN01DL在渝豆1号和宁镇1号大豆根圈表现出较强的适应性和竞争性，而TA113QD则在Williams大豆根圈的适应性较强，在宁镇1号大豆根圈的适应性较差，且供试菌在4种大豆根圈定殖动态与水平的差异在共生效应上也有一定程度的反映，但未达到显著水平。     

Principle analysis and parameters optimization of rotary rice pot seedling transplanting mechanism

通过分析国内外水稻钵苗移栽机的缺点与不足,根据水稻钵苗移栽机的特征与优点,提出一种以椭圆-不完全非圆齿轮为传动机构的旋转式水稻钵苗移栽机构,使水稻移栽达到高产高效率的移栽水平。首先,在分析该移栽机构工作原理的基础上,建立了椭圆-不完全非圆齿轮机构的运动学模型。然后基于Visual Basic6.0可视化编程软件,开发了椭圆－不完全非圆齿轮行星轮系水稻钵苗移栽机构的辅助分析与优化软件。最后,通过分析各参数对移栽轨迹的影响,利用人机交互的优化方法,得到了一组较优的符合水稻钵苗移栽要求的结构参数,该研究可为旋转式水稻钵苗移栽机构的设计提供参考。     

The effects of sodium chloride on ornamental shrubs

The use of saline waters is an option for the irrigation of salt tolerant ornamentals as competition for high quality water increases. However, despite the importance of ornamental shrubs in Mediterranean areas, salt tolerance of such species has received little attention. The aims of our investigation were to quantify the growth response and any injury symptom of 12 widely cultivated ornamental shrubs to irrigation with saline water and to investigate any possible relation with the concentration of Na⁺ and Cl⁻ in the plants. Species were irrigated with different salinities (10, 40, and 70 mM NaCl) for a 120-day period. At the end of salt treatment, plants were sampled and dry biomass recorded; the relative growth rate (RGR) was also calculated. Root and leaf samples from each species were used to evaluate Na⁺, K⁺ and Cl⁻ concentrations. Growth rates were significantly reduced in Cotoneaster lacteus, Grevillea juniperina and Pyracantha ‘Harlequin’, which also showed the highest percentage of necrotic leaves. The increasing external NaCl lead to an increase of Na⁺ and Cl⁻ in roots and leaves of the different species, although less Na⁺ was accumulated than Cl⁻: growth reduction well correlated with the concentration of Cl⁻ and/or Na⁺ in the leaves. The most sensitive species (i.e. C. lacteus, G. juniperina and Pyracantha ‘Harlequin’) had high concentrations of Na⁺ and/or Cl⁻ in their leaves and also showed a decrease in their leaf K⁺/Na⁺ ratios. Even though other species (i.e. Bougainvillea glabra, Ceanothus thyrsiflorus, Leptospermum scoparium, Leucophyllum frutescens and Ruttya fruticosa) demonstrated a high ion concentration in their leaves, they could be considered relatively salt tolerant as there was little growth reduction and few symptoms of injury in the leaves. In some other cases (i.e. Cestrum fasciculatum, Escallonia rubra and Viburnum lucidum) the observed tolerance was related to higher ion concentration in the roots compared to the leaves, probably indicative of a limited transport to the shoots. Only in Eugenia myrtifolia was the absence of symptoms associated with a limited Na⁺ and Cl⁻ uptake from the rhizosphere.     

氮肥运筹对钵苗机插优质食味水稻产量及品质的影响

以江苏优质食味水稻代表性品种南粳9108和南粳5055为材料,采用新型栽培技术钵苗机插移栽,在大田常用量总施氮270 kg hm~(–2)条件下,设置10∶0、9∶1、8∶2、7∶3、6∶4、5∶5、4∶6七种基蘖肥与穗肥比例的处理。比较研究不同处理对钵苗机插优质食味水稻产量及稻米品质的影响,以期为氮肥的合理施用提供理论依据和技术指导。结果表明,当基蘖肥与穗肥比例为6∶4时,产量最高,与其他处理差异显著。稻米的糙米率、精米率和整精米率均随着基蘖肥比例的降低而逐渐增加;直链淀粉和胶稠度含量随着基蘖肥比例的降低而逐渐减小,但蛋白质的含量变化趋势相反,后期施氮量大时蛋白质含量增大。两品种的垩白率和垩白度均随着基蘖肥比例的降低呈先增加后减小的趋势,以6∶4处理显著大于其他处理,而垩白大小逐渐增加。食味品质中除了完整性随着基蘖肥所占比例的降低而增加外,香气、光泽、味道、口感以及食味值均呈现递减趋势。各处理的稻米峰值黏度、热浆黏度、崩解值和最终黏度,除对照不施氮肥处理最大外,均随基蘖肥比例的降低而逐渐减小,而消减值的变化呈现相反的趋势。基蘖肥与穗肥比例为6∶4的氮肥运筹方式能显著提高钵苗机插优质食味水稻的产量;适当增加穗肥比例能有效改善稻米的加工品质和营养品质,增大稻米粒长和粒宽,但降低了稻米的外观品质和食味品质。