环模制粒机中环模结构型孔的有限元分析

苜蓿草粉对环模系统的磨损是造成饲料制粒机关键部件环模失效的主要原因.本研究应用Pro/E及ANSYS软件完成三种类型环模型孔的建模及有限元静力分析.得到了三种类型环模型孔沿轴向路径的应力与变形分布,找到了环模孔倒角与环模孔轴向路径的应力与变形的影响关系,60°倒角环模孔结构好,为环模进行结构优化提供了依据.     

Stability of crystalline and coated vitamins during manufacture and storage of fish feeds

The stability of two forms of vitamins, crystalline and fat-coated, during manufacturing processes and storage of fish feeds was investigated. After extrusion, vitamin recovery was generally lower than that found after pelleting. The recovery of coated forms after pelleting was higher than that of crystalline ones, especially for ascorbic acid, menadione, pyridoxine and folic acid. Coated forms were also found to be more resistant to extrusion than crystalline forms. No significant differences in vitamin losses during storage were found between pelleted and extruded feeds. However, losses of ascorbic acid, menadione and pyridoxine in both manufactured feeds were much greater in crystalline than in coated forms.     

棉仁(籽)饼—玉米型肉仔鸡饲粮的研究

用LOHMANN品种肉仔鸡608只进行两次试验,研究了棉仁(籽)饼—玉米型饲粮的应用问题,单因子设计。第一次试验给饲八种试粮:(1)、棉仁饼(CSM)为0,游离棉酚(FG)为0;(2)、CSM为7.5%,FG为111ppm;(3)、(2)+亚铁离子(Fe~(++))111ppm;(4)、CSM为15.0%,FG222ppm;(5)、(4)+F~(++)222ppm;(6)CSM为30％,FG为444ppm;(7)、(6)+Fe(++)444ppm;(8)、(6)+L—赖氨酸(Lys)。第二次试验给饲4种试粮:(9).CSM:大豆饼(SBM)=20:80,粉料;(10).CSM:SBM=50:50,粉料;(11).CBM:SBM=100:0,粉料;(12)、(11),颗粒料。结果:(1)、CSM配比为0—7.5—15.0—30.0%,FG为0—111—222—444ppm时,不经任何脱毒处理,各组49日龄增重(分别为1779.3—1853.8—1861.3—1819.0克)、累积耗料(分别为3978—4217—4208—4158克)、耗料比(分别为2.24—2.27—2.26—2.29)等均未随FG水平提高而产生有规律的明显差异;鸡肝脏残留FG均在安全水平以下;氰化高铁血红蛋白(CNMHb)在正常生理范围以内。(2)、日粮FG为111—222—444ppm时,分别添加111—222—444ppm的Fe~(++)后,对试粮各项生产指标、能量代谢率、蛋白质表现存留率、鸡肝脏残留FG水平、血液CNMHb量均未发生明显影响。(3)、当CSM:SBM分别为20:80、50:50、100:0,构成等蛋白质(%),不等能量浓度(不以饲料脂肪调整)的试粮,试鸡各项生产指标差异均不显著(P>0.05)。(4)、CSM配比为30%时,添加L—Lys,将Lys:精氨酸(Arg.)由1:1.6～1.7调整为1:1.2。结果,Lys:Arg.平衡组(为1:1.2时)试鸡49日龄体重明显较高,但累积耗料量、耗料比,试粮能量代谢率、蛋白质表观存留率差异均不显著(P>0.05)。(5)、用棉仁饼100%地取代豆饼的低能量浓度试粮,经颗粒加工后,其饲料进食量,增重量明显提高。     

虾料制粒机的压辊数量对颗粒品质的影响

压辊数量对虾料制粒机的颗粒品质有很大影响。文章分别对两压辊、三压辊结构进行分析,研究表明,两压辊制粒机较三压辊制粒机,更适宜用于虾料制粒。     

Growth performance and carcass quality are not different between pigs fed diets containing cold-fermented low-oil DDGS and pigs fed conventional DDGS,but pelleting improves gain to feed ratio regardless of source of DDGS

The objective of this study was to test the hypothesis that growth performance and carcass characteristics of pigs fed diets containing cold-fermented, low oil distillers dried grains with solubles (DDGS) is not different from that of pigs fed diets containing conventional DDGS regardless of the physical form of the diets. A total of 160 barrows and gilts were used. There were 4 diets, 10 pens per diet, and 4 pigs per pen. Pigs were weaned at 21 d of age and fed a common phase 1 diet that did not contain DDGS during the initial 7 d post-weaning. Pigs were then allotted to the four diets that were arranged in a 2 × 2 factorial design with two sources of DDGS (cold-fermented and conventional DDGS) and two diet forms (meal and pellets). Pigs were fed phase 2 diets from day 7 to 21 and phase 3 diets from day 21 to 43 post-weaning. All diets were based on corn and soybean meal, but phase 2 diets also contained 15% DDGS and phase 3 diets contained 30% DDGS. From day 43, pigs were fed grower diets for 38 d, early finisher diets for 38 d, and late finisher diets for 18 d and these diets also contained 30% DDGS. Feed was provided on an ad libitum basis and daily feed allotments were recorded. Pigs were weighed at the beginning of each phase and at the conclusion of the experiment. On the last day of the experiment, the pig in each pen with a body weight that was closest to the pen average was slaughtered and carcass measurements were determined. Combined results for the two nursery phases indicated that feeding meal diets instead of pelleted diets increased (P < 0.001) average daily feed intake and decreased (P < 0.05) gain to feed ratio (G:F). However, no differences between the two sources of DDGS were observed for the overall growth performance of weanling pigs. For the entire growing-finishing period, the source of DDGS did not affect growth performance, but pigs fed meal diets had reduced (P < 0.001) G:F compared with pigs fed the pelleted diets. There were no differences between the two sources of DDGS for carcass characteristics. Back fat was greater (P < 0.05) for pigs fed pelleted diets than for pigs fed meal diets. In conclusion, no differences in growth performance or carcass characteristics between pigs fed cold-fermented DDGS and pigs fed conventional DDGS were observed. However, pigs fed pelleted diets had greater G:F and greater back fat than pigs fed meal diets.     

日粮制粒对绵羊利用玉米秸秆的影响

[目的]研究颗粒料对绵羊生产性能、经济效益及秸秆消化率的影响。[方法]将玉米秸秆与混合精料混合并添加营养性添加剂,在此基础上制成颗粒料,分别饲喂2组小尾寒羊,测定各营养物质的采食量、消化量和消化率。[结果]结果表明,日粮制粒能明显地提高绵羊对玉米秸秆的利用率和绵羊的生产性能。[结论]该研究制备的颗粒料能大幅度促进绵羊的生长。     

Response of broiler chicks to non-steam- or steam-pelleted diets containing raw,full-fat soybean meal

The objective of this study was to evaluate the effects of steam pelleting of diets containing graded levels of raw, full-fat soybean meal (RSBM) on the chemical properties and feeding values of the diets. Samples of diets with steam- or non-steam-pelleted as well as the mash containing varying levels of RSBM were subjected to detailed chemical analysis. As a result of this study, trypsin inhibitor (TI) concentrations in the diets ranged between 4,153 and 10,484 TIU/g. Amino acid concentrations were higher in the non-steam-pelleted and mash diets than the steam-pelleted diets. A 4 × 2 factorial arrangement (RSBM: zero, 10, 20 or 30%, equivalent to zero, 30, 60, and 90 g/kg of diet, respectively, and non-steam- or steam-pelleted diets) was used while feeding broiler chicks (zero to 14 d of age). Each treatment was replicated 6 times with 8 birds per replicate. As a result of this study, there was no difference (P > 0.05) in mortality of birds among the groups. Feed intake (FI) (P < 0.05) and body weight gain (BWG) (P < 0.001) decreased with increasing levels of RSBM. Birds fed on steam-pelleted diets gained less (P < 0.001) weight than birds on the non-steam-pelleted diets, but the FI was not significantly (P > 0.05) different. The FCR was negatively affected (P < 0.05) by increasing levels of RSBM. There was no interaction effect between RSBM and pelleting method on the FI, BWG, or FCR of birds. The weight of the pancreas (P < 0.001) and duodenum (P < 0.01) increased with a rise in the level of RSBM in diets. Non-steam pelleting increased (P < 0.05) the pancreatic protein content, whereas the activity of chymotrypsin was reduced (P < 0.01) when the RSBM level was increased. Birds fed with RSBM-free diets had thicker muscle, longer villi, wider villus surface area, and higher villus to crypt depth ratios than birds on the other diets, but these differences were not significant. It can be concluded that steam pelleting of diets containing RSBM is inadequate to reduce the adverse impact of TI on chicks.     

Effects of two commercial diets and technical feed treatment on stomach lesions and immune system of fattening pigs

The impact of technical feed treatment and diet on stomach lesions and traits of the local and systemic immune system were investigated in fattening pigs. Feeding groups differed in technical feed treatment (standard ground meal vs. finely ground and pelleted feed) and diet (soya bean meal vs. rapeseed meal/DDGS/soya beans). Pigs were fattened approximately 10 weeks by ad libitum feeding and slaughtered subsequently. Gastric alterations were assessed by a macroscopic scoring system [macroscopic stomach score (MSC) 0 =  normal to 4 =  severe lesions]. For immunological investigations, lymphocytes from blood and jejunal tissues were isolated. T‐cell phenotyping was carried out by staining intestinal lymphocytes with monoclonal antibodies for CD4 and CD8 and flow cytometric measurements. MSC was higher in animals fed finely ground and pelleted feed compared with their counterparts. Significant interactions between diet and feed treatment considering the MSC were observed (p = 0.027). There was no effect of diet or technical feed treatment on T cells of blood, Lymphonodi gastrici or lamina propria (LP) and intraepithelial cells. However, technical feed treatment significantly affected subsets of CD4⁺, CD8⁺, CD8^low, CD4/CD8 double‐positive T cells, the mean fluorescence intensity of CD4⁺ T cells and the ratio of CD8^low/CD8^high T cells in Peyer's patches (PP). All named parameters were reduced in PP of animals fed finely ground and pelleted feed compared with animals fed standard ground meal. Furthermore, significant differences between T cells of lymph nodes and LP were observed between animals with middle MSC (MSC = 1–2.5) and animals with high MSC (MSC = 3–4). Significant alterations in T cells of PP were observed between animals of low (MSC = 0–0.5) and high MSC. The observed effects provide the evidence that the impact of technical feed treatment is not limited on the stomach lesions. Possible stimuli and consequences of the immune system should be studied in more detail.     

基于挤压模拟试验的苜蓿草颗粒成型工艺参数优化

为了确定最佳的苜蓿草颗粒产品制粒成型工艺,以苜蓿草粉为制粒物料,通过环模制粒过程的模拟试验,利用二次回归正交旋转试验设计,探讨了制粒密度与挤出力、物料含水率、草粉粒度的关系,建立了各因素与制粒密度之间的数学模型。试验数据分析显示：建立的回归方程显著;3个因子对制粒密度影响大小顺序为挤出力、含水率、草粉粒度;通过方程模拟选优得出模拟试验条件下的最优参数组合为：挤出力5.47?kN、含水率16.96%、草粉粒度6.34?mm,即制粒密度为最大值1.241?g/cm3。该研究可为提高草颗粒及其它颗粒物料产品的质量提供指导。