阔叶红松林的生物量和营养元素含量的研究

一、研究内容和方法我们于1985—1987年对小兴安岭阔叶红松林的生物量进行了研究。生物量的测定是在凉水自然保护区的阔叶红松林内进行的。林龄220年,组成8红2椴,林分平均高23.1m,平均直径37.4cm。其中红松平均高27.2m,平均直径45.2cm,密度622株/ha,针     

笃斯越桔硬枝扦插繁殖技术研究

采用笃斯越桔硬枝扦插,用生根剂处理插穗,并在不同的基质上进行扦插试验,结果表明:笃斯越桔硬枝扦插用河沙作为基质最好,生根剂ABT处理的插穗生根率最高。     

两种商品木浆的纸浆性能研究

选取市场上具有代表性的两种商品针、阔叶木浆进行PFI打浆处理,研究在不同打浆度下浆料纤维质量、动态滤水性能、Zeta电位、微观结构等方面的变化,并对不同比例配抄条件下的成纸性能进行考察,结果表明:针、阔叶浆的打浆度与打浆转数之间的关系均符合线性分布:y=17.7503+0.0015x,R^2=0.9914(针叶浆);y=8.8986+0.00275x,R^2=0.9734(阔叶浆);经PFI打浆后,两种木浆纤维长度、宽度变化较小,细小组分含量变化明显;随着打浆度的升高,两者的滤水性能下降,Zeta电位先上升然后基本保持不变;初始打浆度下,随着针叶浆比例的减少、阔叶浆比例的增加,成纸的抗张强度先下降再增大,厚度逐渐下降至不变,定量逐渐增加,柔软度逐渐下降;随着打浆度的升高,成纸的抗张强度增大,厚度、定量逐渐下降,针叶浆成纸柔软度逐渐下降,阔叶浆成纸柔软度先升高再逐渐降低。     

Plywood frame corner joints with glued-in hardwood dowels

This paper presents research on plywood frame corners jointed to glulam beams and columns by means of glued-in hardwood dowels. The frame corner was made of a solid block of ordinary plywood of the same width as the glulam beams and with plies parallel to the plane of the frame to avoid splitting due to stress perpendicular to the grain. Hardwood dowels with a diameter of 12mm and a maximum glued-in length of 120mm were glued into drilled holes in the plywood corner and glulam beam ends parallel to the grain direction of the beams to form a momentresisting joint. Static bending tests were conducted of frame corners with 100 X 200mm² and 120 X 420mm² beam cross sections. Bending capacities of the joints corresponding to a modulus of rupture of the jointed glulam beams of about 30MPa were obtained for both closing and opening moments for the small cross sections, and about 22MPa was obtained for the large cross sections. Simple design models for calculation of joint strength and rotational stiffness are also presented.     

Formation and chemical structures of acid-soluble lignin I: sulfuric acid treatment time and acid-soluble lignin content of hardwood

To elucidate the formation mechanism of acidsoluble lignin (ASL) formed in the Klason lignin determination, beech wood meals were treated with sulfuric acid (SA) under various conditions, and the ASL solution was extracted with CHC1₃. The results indicated the following: (1) wood components yielding ASL are dissolved in 72% SA during the initial stage; (2) the quantity of ASL is highest during the initial stage, then decreases with prolonged time of 72% SA treatment and finally reaches a constant value; (3) soluble lignin prepared by 72% SA treatment and subsequent standing in 3% SA again yield insoluble Klason lignin and ASL after boiling in 3% SA; and (4) about half the amount of ASL is dissolved in CHC1₃. The foregoing suggest that wood components yielding ASL are dissolved in 72% SA at the beginning and finally change to ASL after being subjected to depolymerization, hydrolysis, and other reactions. ASL may thus be composed of low-molecular-weight degradation products and hydrophilic derivatives of lignin.     

紫叶小檗硬枝扦插育苗技术研究

对紫叶小檗硬枝扦插育苗的主要影响因素：插穗选取部位、插穗粗度、ABT1号生根粉的处理质量浓度、扦插基质等，通过正交试验进行了系统研究。结果表明，紫叶小檗硬枝扦插育苗的最佳处理组合是：插穗直径4mm 150mg/kg的ABT1号 蛭石。     

Organic Matter Added to Bareroot Nursery Beds Influences Soil Properties and Morphology of Fraxinus pennsylvanica and Quercus rubra Seedlings

Bareroot hardwood seedling production involves intensive soil management. To increase soil organic matter (OM), nurseries commonly grow a cover crop for 1 year after every 1–2 year of seedling production. Raising soil OM levels can also be achieved through addition of soil amendments. We studied the influence of chicken manure (CM) and composted leaf, tree, and lawn trimmings (Cp) on soil properties and morphology of green ash (Fraxinus pennsylvanica Marsh.) and northern red oak (Quercus rubra L.) seedlings. CM was applied at 725, 1450, or 2900 kg ha⁻¹ (CM725, CM1450, and CM2900, respectively) and Cp was applied at 200 m³ ha⁻¹. Addition of CM and Cp significantly raised soil OM levels and altered soil chemical properties compared to the control (Ctrl). Root-collar diameter increased with addition of CM1450, CM2900, or Cp compared to CM725 or Ctrl plots for northern red oak, but was largest in soils amended with CM2900 for green ash. Conversely, height was greatest with addition of CM725 for northern red oak, but green ash seedlings were shorter in Ctrl plots than in all amendments except for CM725. Root volume of green ash and northern red oak seedlings was positively influenced by addition of CM or Cp. Seedling responses to nursery soil amendments vary with different forms and amounts of OM. Benefits to seedling growth through application of appropriate materials in the proper balance can improve seedling morphological quality and positively influence soil chemical properties.     

Modelling of vertical density profile of particleboard,manufactured from hardwood sawmill residue

Abstract

Particleboards are generally made in three layers using softwood as the major raw material. Limitation on natural wood resources and concerns about the carbon footprint of products has created a significant interest in environmentally friendly or ‘green’ building materials. Hardwood sawmill residue, which has been disposed as solid waste, was investigated by authors as the main raw material for producing particleboard at RMIT University, Australia. Physical and mechanical properties of final particleboard were measured and analysed against original materials and process variables. The density of a particleboard along its thickness direction is not uniform, and is called the vertical density profile (VDP) which is dependent upon processing parameters. The VDP influences particleboard properties including flexural strength and its dimensional stability and fastening capacity. It is important to influence the formation of the VDP, altering processing variables, to achieve optimum particleboard properties. This paper presents an attempt to develop a model to predict the formation of the VDP of hardwood residue particleboard compared to processing parameters, using the theory of experimental design. The advantages of such a model in optimising particleboard properties are also discussed.     

黄果枸杞硬枝扦插繁殖技术研究

[目的]探讨黄果枸杞硬枝扦插繁殖对植株成活率、结果率的影响.[方法]以一年生和二年生黄果枸杞不同部位的硬枝为插穗试验材料,采用不同浓度的生根粉及赤霉素进行处理.[结果]采用生根粉2 500 mg/L药液处理的二年生基部枝条的插穗植株其平均成活率及结果率最高,分别为63.6％和71％,植株生长状况最好;其次是赤霉素50 mg/L药液处理的二年生基部枝条的插稳,其植株生长状况较好.[结论]该研究为黄果枸杞规范化栽培提供技术服务.     

引进俄罗斯杨树新品种硬枝扦插生根能力研究

高加索白杨、N12、N2、N21和SL-1在硬枝扦插生根率、生根数、生根根长和生根指数上存在显著差异。生根能力综合分析表明,N21的硬枝扦插生根率、生根数、生根根长和生根指数指标均优,其中生根根长和生根指数均优于对照品种小黑杨,说明其硬枝扦插生根能力最强。