Some Comments on Gerechte Designs

In a companion paper we derived the correct analysis for gerechte designs with uncorrected errors. Here we show that this correct analysis cannot be justified by the usual randomization argument. However, when the regions are rectangular there is a randomization procedure which validates an analysis with three separate error terms. We also outline other developments in design and analysis that may be more satisfactory.     

大型液化气低温储罐结构及其保冷设计

根据储存液化气大容量储罐的超低温特点，对液化石油气和液化天然气低温储存储罐的隔冷保温材料及其保温结构设计进行了研究，并对几种大型圆筒型立式储罐的结构设计及其技术经济特性进行了讨论和比较。     

Effect of mate selection on fuzzy selective mating criteria in closed dairy multiple ovulation and embryo transfer nucleus programs

In order to control rates of response and inbreeding, mate selection using fuzzy selective mating criteria (FMC) was investigated in adult multiple ovulation and embryo transfer nucleus schemes for dairy cattle. Stochastic simulation was used to model the closed nucleus scheme. This mate selection was examined in four alternative mating and male selection schemes: (i) a hierarchical scheme; (ii) a hierarchical sibship scheme (two males per sibship); (iii) a factorial scheme (two sires per dam); and (iv) a factorial sibship scheme (two males per sibship and two sires per dam). Genetic response and inbreeding rate tended to be reduced by increasing the trade-off parameter of FMC between the expected breeding value and inbreeding of progeny. Inbreeding rates in all schemes were reduced by reducing the variance of family size through selection and the average coancestry of mating pairs through mate allocation.     

国产MJ3210小型木工跑车带锯机锯解正交试验分析

采用正交试验设计法，对国产MJ3210小型木工跑车带锯机的锯解质量进行研究。通过实测马尾松锯材尺寸偏差、表面粗糙度等参数，得到其最佳的进料速度、锯解厚度和锯卡高度的组合方案。结果表明，该设备具有结构简单、出材率高、锯解精度高、质量好、成本低和生产效率高等优点。     

Analysis of a Long-term Experiment with Repeated-measurement Models

Long‐term experiments are a classical case of repeated measurements. Traits are measured on the same experimental unit over many years so that correlations arise between the observations made on the same plot in consecutive years. This paper describes the analysis of a three‐crop‐rotation long‐term experiment. We analysed the yields of the crops and the organic carbon content in the topsoil over 30 consecutive years. Several variance–covariance approaches are discussed and the trait‐specific best fit is interpreted. Mixed models are used to describe the structure of the experiment. Both yields and soil organic carbon show a more or less pronounced variance heterogeneity. Especially for yields, the heterogeneity of cycles and years is dominant. The consideration of correlations results in a better model fit in all cases.     

基于工作流的ERP系统重构的研究

分析了企业现有ERP系统运营存在的缺陷，提出了适合本企业的基于工作流的ERP系统重构的开发方案。     

多花黑麦草品种比较试验

通过对现行生产中常用的4个多花黑麦草品种在昆明地区的物候期、株高、草产量、生长率、净同化率等指标的规定表明,在生长初期,特高的生产性能比其余3个品种都好,但生长一段时间后,邦德的生产性能明显超过特高(P<0.05),抗锈王略高于特高(P>0.05),旺饲的生产性能最差(P<0.05)。因此,邦德是一个在生产中值得推广应用的品种。     

MB22木聚糖酶发酵条件的研究

通过因素轮换试验和正交试验,对MB22菌产木聚糖酶的培养基配方和发酵条件进行了研究。结果显示最佳培养基组成是:以玉米芯粉和麸皮为碳源,麸皮120g/l,玉米芯280g/l,(NH4)2SO44g/l,CaCO31.5g/l,Tween80,2.0g/l,MgSO4·7H2O1.5g/l;最佳发酵条件为:起始pH5.0,摇床培养温度30℃,转速160r/min,振荡培养84h。在最佳发酵条件下,MB22菌的最高产酶活力可达898.23U/ml。虽然与一些高产菌株相比该菌株的产酶能力还有待于进一步提高,但该试验结果为进一步进行微生物生产木聚糖酶的研究提供了理论依据。     

应用于鱼道设计的新疆木扎提河斑重唇鱼的游泳能力测试

为了探究斑重唇鱼的游泳能力,给过鱼设施设计和鱼类游泳行为学研究提供基础参数,本研究以木扎提河野生斑重唇鱼(全长TL=12～16 cm)为研究对象,测定了其在(16.6±1.6)℃水温下的感应流速、临界游泳速度、爆发游泳速度及持续与耐久游泳能力。结果显示,斑重唇鱼感应流速为(0.18±0.02)m/s,相对感应流速为(1.40±0.23) BL/s (BL为体长);临界游泳速度为(1.02±0.15) m/s,相对临界游泳速度为(8.58±1.65) BL/s;爆发游泳速度为(1.39±0.17) m/s,相对爆发游泳速度为(10.92±1.86) BL/s;最大持续游泳速度为0.87 m/s,最大耐久游泳速度为1.37 m/s,与平均爆发游泳速度相近。其持续游泳时间与流速呈负相关(l g T=?5:136X+8:504)。当以斑重唇鱼为主要过鱼对象时,建议为吸引鱼类进入鱼道,进口流速设计为1.02～1.39 m/s,休息池主流设计为0.20～1.02 m/s,鱼道竖缝处流速宜低于0.85 m/s。鱼道长度为1 000 m时,鱼道内平均水流速度应低于0.78m/s。本研究结果可为新疆木扎...     

马尾松毛虫多功能氧化酶测定正交试验优化研究

应用L16(43)正交试验设计对影响马尾松毛虫多功能氧化酶细胞色素P450测定的因素PMSF浓度、酶原稀释比和离心速度进行优化研究。结果表明供试的16组复配组合中,组合A1B1D1(选用0.2 mol/L PMSF浓度、酶原稀释比为2∶1,离心速度1为5 000 r/min)最优,按照该组合的条件进行马尾松毛虫MFO酶细胞色素P450测定,效果最佳。