Age estimation of different tree species using a special kind of an electrically recording resistance drill

The determination of tree age is an important issue for urban green planning, forestry and dendrology; finding non-destructive and quasi-non-destructive methods for this purpose is of great theoretical and practical importance. The resistance drilling method is quasi-non-destructive because the average diameter of an opening that remains after drilling does not exceed 3 mm. Do electrically recording resistance drills allow precise assessment of tree age? The aim of this study is to assess the accuracy of determining the number of tree rings based on an examination of this special kind of drilling resistance profiles for three tree species, the pine Pinus sylvestris L., the oak Quercus robur L., and the birch Betula pendula ROTH. In 2015 and 2016, 15 pine trees, 15 oak trees, and 15 birch trees were randomly selected. For each studied tree, a measurement was conducted using the electrically recording resistance drill IML-Resi E400 with a flat-tipped 1.5/3 mm steel needle (research sample), and an increment core was taken (reference sample). The drill used was not a real Resistograph^®. The analysis of the E400-profiles underestimated the number of tree rings; the mean bias error (MBE) values were –6.5, –2.5, and –6.0 years for pine, oak, and birch, respectively. The proportion of investigated trees with less than five years difference between the research and reference samples varied from 38.4 (birch) to 66.7 (oak) percent. The accuracy of tree age determination was lowest for birch and highest for oak. The binomial generalised linear model (GLM) revealed that the most accurate tree age assessments were obtained from tree rings wider than 2 mm. The measurements clearly showed that the electrically recording resistance drill IML-Resi E400 enables a quick, although approximate, tree age assessment. Future research should concentrate on electronically regulating and recording drills, providing a higher spatial and signal resolution, and a stronger correlation to wood density.     

同期排卵处理母牛体温和活动量变化规律及效果分析

为探究同期排卵处理母牛体温和活动量变化规律及不同同期排卵技术处理效果，指导同期排卵技术优化。本研究自动监测了18头20月龄左右同期排卵（GnRH-PG-GnRH）处理荷斯坦母牛和17头产后40~60 d预同期排卵（PG-PG-GnRH-PG-GnRH）处理荷斯坦母牛的体温和活动量，应用自动检测系统进行母牛发情监测。结果发现，同期排卵处理母牛发情时阴道温度平均升高（0.43±0.20）℃，持续（12.37±2.73）h；活动量平均升高（18.28±18.61）倍，持续（11.00±1.68）h；排卵时阴道温度平均下降（0.20±0.10）℃，持续（11.00±1.68）h。自动化发情监测显示，同期排卵处理母牛7头发情并排卵；预同期排卵母牛GnRH处理前全部发情排卵。两种同期排卵处理，虽可改变母牛性周期进程，促进母牛性周期同步化，但均难以使母牛性周期完全同步。因此，将同期排卵-定时输精和发情鉴定技术科学结合才能取得更好的繁殖效果。     

合作猪胴体品质、肉质特性及随体重变化规律的研究

本研究测定了24头合作猪的胴体品质和肉质特性,以分析合作猪胴体、肌肉品质随体重(30kg,35kg,40kg,45kg)的变化规律,确定其最佳屠宰体重。研究结果认为,合作猪瘦肉率在48.8%～55.0%之间,肌肉pH1值在6.35～6.50之间,肉色指标优良,大理石纹评分均在3.75～4.05之间,肌内脂肪含量在3.60%～3.85%之间;当40kg体重时屠宰的失水率和滴水损失均最低,分别为10.68%和1.84%,且剪切力值最低,为3.08kg。相同性状间的有较高的正相关,肌肉pH1值几乎与各项肉质指标呈负相关。通过灰色关联度综合评定结果认为,合作猪是在活重达到40kg时屠宰,其肉质最优。     

东北地区外来针叶树种引种现状及发展策略

介绍了东北林区主要针叶树种引种现状及取得的成就，分析了东北三省针叶树种引种工作中存在的问题，提出了建立较为科学的引种网络体系和发展策略，并提供了可能在干旱、半干旱区引种成功的针叶树种名     

波尔山羊杂交后代体尺、体重与肉用性能的相关性研究

本文利用 SPSS数据处理软件 (10 .0版 )统计分析了 2 3只 (约 8～ 9月龄 )波尔山羊与唐山奶山羊杂交后代公羊的体尺、体重和肉用性能。结果表明 :(1)波尔山羊与唐山奶山羊杂交 F1 代体尺、体重与肉用性能指标的变异程度大于 F2 代 ,其中宰前重、胴体重、净肉重和胸宽四项指标变异程度在 F1 和 F2 代中都很大 ;(2 )杂交 F1 代、F2 代各项指标 t检验结果 ,除胸宽外其余指标差异显著或极显著 ;(3 )波尔山羊杂交后代中胸宽与各项指标间相关不显著 ,宰前重、胴体重、净肉重与体尺指标相关显著或不显著。     

冬春季莱芜黑山羊松果体功能状态的免疫组织化学比较

应用5-HT免疫组织化学染色法，对冬春两季的莱芜黑山羊松果体进行了观察比较，以探讨松果体与下丘脑垂体-性腺轴的关系。结果显示，莱芜黑山羊松果体内存在大量5-HT阳性的松果体细胞及5-HT纤维；冬季松果体阳性细胞面积及阳性面积比都明显大于春季（P〈0．01），平均光密度在冬、春季间无明显差异（P〉0．05）。表明莱芜黑山羊松果体的功能活动呈现季节性变化，与羊的繁殖活动关系密切。     

酮粉法检测泌乳牛尿酮乳酮的应用研究

荷斯坦泌乳牛尿、乳酮体的酮粉法定性试验表明：尿酮阳性率为29．25％，乳酮阳性率为10％。尿、乳阳性牛的血酮、血糖、乳酮、尿酮定量测定表明：酮粉法判定泌乳奶牛亚临床酮病，尿酮阳性反应具有早期、敏感、准确性低的特点。乳酮阳性反应具有准确、敏感性低、方便等特点。二者同时定性检测具有互补作用。     

略论骆驼的耐干渴能力

荒漠水源奇缺,常有干渴威协。骆驼长期在这种自然选择下,造就出一种十分惊人的耐干渴能力,十日不饮可照常供使役,30～40日内缺水不致有生命危险。据研究认为,骆驼高度耐渴的机理主要在于:一次能饮入60～80升甚至更多的水;能饮用含盐量相当高的水;血液和体液中保存水的能力很强;能节约散热、呼吸、排尿、排粪过程中的水份消耗;有较高排泄浓缩尿的能力;可有效利用体内的代谢水;即使高度失水(达体重的30%)也能短期耐受过去。正因其耐渴能力强,所以才使人类开发利用荒漠成为可能;使大面积缺水草埸和其它家畜所不能利用的灌木类植物得到合理利用;还能在缺水条件下持续分泌稀薄的低脂肪驼乳,为沙漠旅行者提供上等饮料。     

Reproductive roles predict sexual dimorphism in internal and external morphology of lake whitefish,Coregonus clupeaformis

Abstract – The different reproductive roles of the sexes can predict the direction and magnitude of sexual dimorphism of external and internal morphology. Males should have enlarged structures that enhance the acquisition of mating opportunities, whereas females are predicted to have enlarged organs that are associated with the production of eggs. We tested these predictions in male and female lake whitefish, a species in which both sexes have similar overall body size and shape. After controlling for body size, male lake whitefish had significantly longer jaws and pectoral and pelvic fins, larger hearts, and more muscle than females. Sexual dimorphism in relative muscle mass may be one of the most fundamental morphological differences between males and females. Females had relatively heavier livers than males. Because the liver is important for the breakdown of fats and vitellogenesis, selection should favour an enlarged liver in females for the processing of energy and the production of large numbers of eggs.