红外相机技术在河北雾灵山国家级自然保护区中的应用

为了充实河北雾灵山自然保护区的野生动物资源本底资料,提高监测能力和监测水平,雾灵山保护区自2015年开始将红外相机技术应用到野生动植物的资源调查和管护中。目前应用红外相机技术发现兽类5目10科14种,鸟类4目6科10种,掌握了区内主要物种猪獾(Arctonyx collaris)、狍(Capreolus)和勺鸡(Pucrasia macrolopha)的日活动节律,补充了保护区的本底调查资料,为保护区进一步开展金钱豹(Panthera pardus)、斑羚(Naemorhedus goral)和鸟类多样性等科学研究奠定了基础,为保护区制定关于野生动物资源的相关管护政策提供了科学依据。     

不同覆土深度对鸡腿菇子实体产量的影响

本试验研究 11种覆土深度对鸡腿菇子实体产量影响。结果表明 ,不同覆土深度对子实体产量、有效子实体数和幼蕾数均存在显著的影响。覆土越厚 ,幼蕾数越少。当覆土深度在 0 5～ 3cm时 ,子实体产量和有效子实体数随着覆土层的加厚逐渐增加 ,在覆土深度为 3cm时达到最大值 ,覆土深度大于 3cm时 ,则随着覆土层的加厚而逐渐减少。从生产的角度看 ,覆土 3cm是比较适宜的覆土深度 ,此时的子实体产量最高。     

Comparison of Seven Digital Cameras for Digitizing Radiographs

The purpose of this study was to evaluate seven digital cameras for their ability to adequately capture quality radiographic images and their relative cost effectiveness. Radiographs of line pair (LP) phantoms (ranging from 0.6 to 16.6 LP/mm) and a 20-step contrast phantom were photographed at a near distance of 30.0 cm and a far distance (determined for each camera) at which a full 14 x 17 in film filled the viewfinder. Of the seven cameras tested, the Canon EOS-D30 consistently performed the best in LP/mm resolved (7.7 at close distance, 1.4 at far distance) and in contrast latitude (all 20 steps at both close and far distances). The Canon EOS-D30, determined to be the best camera used in this study for photographing radiographic images, is also the most expensive camera that was used. Two cameras, the Nikon Coolpix 995 and the Sony DSC-F707, were very close to the Canon in performance at considerably less cost. Certain inexpensive cameras may not be acceptable choices for teleradiology.     

Determining spatial feed distribution in sea cage aquaculture using an aerial camera platform

Within this paper we describe an unmanned aerial vehicle (UAV) based method to estimate the spatial feed pellet distribution in salmon fish-cages and exploit it within a case study to determine the radial pellet distribution for different rotor spreaders and blower configurations. Compared to previously used methods, capturing pellets thrown from a rotary feed spreader in rows of Styrofoam boxes, the UAV based method is simpler and faster to setup and allows to cover a larger portion of the sea cage surface area. We compare results obtained with the Styrofoam box method with results we obtained by an automatic analysis of aerial videos taken by the UAV during feeding experiments. The employed method helps to gain insight into the spatial feed pellet distribution in full-scale salmon fish-cages where the feeding pipe and actual fixation of the spreader may influence the dynamic behaviour of the feeding system. This can also be seen as a step towards a continuous measuring of the feed pellet distribution, particularly in view of possible future feeding systems that may allow to adapt the feed pellet distribution to the actual fish distribution.     

梯形明渠水力学特征水深的解析计算式研究

通过数学理论分析,推出了梯形明渠的临界水深和正常水深高精度解析计算式,并与现有文献相关计算式进行了对比分析。结果表明,新推出的临界水深计算式相对误差小于0.3%;当梯形明渠坡比0.1~7时,新推出的正常水深初值计解析算公式相对误差一般小于3%;另外,给出了收敛速度更快的正常水深迭计算公式,且在m1时正常水深计算公式在初值迭代一次后其误差均小于0.5%。新推出的梯形明渠临界水深和正常水深解析计算式方便简捷、精度可靠。     

Seismic behavior of reinforced-concrete and steel reinforced concrete ultra short columns

进行了4个钢筋混凝土(RC)超短柱、4个型钢混凝土(SRC)超短柱和6个RC分体柱的滞回性能试验研究.8个超短柱的剪跨比为1;6个分体柱的剪跨比为2.4.试验结果表明,RC超短柱的变形能力不满足现行抗震规范要求.不设剪力连接件的SRC超短柱的破坏模式为黏结破坏,与RC超短柱相比,其抗剪承载力和变形能力并无明显提高;设置剪力连接件的SRC超短柱的破坏模式为斜压破坏,其抗剪承载力和变形能力显著提高,但构件的变形能力仍然难以满足现行抗震规范要求.试验结果还表明,在RC超短柱中开缝,形成剪跨比大于2的RC分体柱,可有效提高柱子的延性和变形能力.对于RC分体柱,随轴压比的提高,构件的抗弯承载力提高,但延性和变形能力下降;当设计轴压比大于0.7时,RC分体柱的变形能力不满足现行抗震规范要求.根据试验结果,提出了SRC超短柱的剪力连接件设计方法和RC分体柱的设计建议.     

保温型刚性护面渠道设计

在刚性面层下设置一道性能良好的保温层来防止基土冻结,可以从根本上解决冻胀破坏的问题。这种带保温层的刚性护面渠道称为保温型刚性护面渠道,根据热工原理,提出了保温型刚性护面渠道横断面设计在构造方面的要求,进一步推导出计算保温层厚度的有关公式,并给出算例,还指出了需要进一步研究和探讨的问题。     

Penetration behavior of bath induced by top-blown gas jets for steelmaking converter

The cavity induced by top-blow gas jets impinging on the bath surface is one of most important parameters, which has overwhelming influence on the rate of slag formation and metallurgical performance. Water model experiments are conducted through a 1/10 scaled-down top-blown convertor. Effects of lance height and gas flow rate on penetration behavior are studied, and also the influence mechanism of liquid surface tension on penetration depth is addressed based on the experiments and theory analysis. An energy utilization index (EUI) is defined to reflect how much the impinging kinetic energy of gas jets are transferred into bath for formation of cavity, and an improved model is proposed to predict penetration depth of jets. The results show that penetration depth increases with lowering lance height and increasing gas flow rate, and impact diameter increases with increasing lance height, but is little affected by gas flow rate. Influence of liquid surface tension on penetration depth is enhanced with increasing surface tension and penetration depth. The EUI increases with increasing lance height, and a function relationship of it with lance height is obtained based on the experiments.