混凝土结构表面蜂窝麻面成因及其防治措施

随着建筑业的飞速发展和科技水平的不断提高,工程对混凝土的各种性能要求越来越高,不仅要求混凝土工作性能好、强度指标高、耐久性好等,而且还要求混凝土结构表面无蜂窝麻面光洁如镜的外观,尤其是清水混凝土结构要求更为严格,为此我们必须加以防范,给予重视。     

加工现场微机控制系统抗干扰的研究

针对制造业加工现场的环境特点，分析了微机控制系统的干扰来源和途径，介绍了实用的抗干扰措施。实践证明：这些软硬件抗干扰措施的综合运用，使自动化加工中微机控制系统的稳定性得到了较大的提高。     

Long-term variation in brown trout, Salmo trutta L., stocking success in a large lake: interplay between availability of suitable prey and size at release

Abstract –  Factors affecting long-term variation in brown trout, Salmo trutta L., stocking success were examined in a large lake, Lake Oulujärvi, in central Finland. Brown trout were stocked in spring (late May to early June) in 1974–1991 and in summer (late June to early July) in 1992–2001. The biomass of the vendace, Coregonus albula (L.), population (prey) at release time had the largest positive effect on stocking success within both periods: biomass of adult vendace in spring and both 0+ and adult vendace in summer. Increasing the size of stocked fish had a positive effect if the vendace available at release were only adults. The increasing trend of predator-catch-per-unit-effort (CPUE) [combined CPUE of northern pike Esox lucius L., burbot Lota lota (L.), and pike-perch Stizostedion lucioperca (L.)] through the study period and its negative effect on trout stocking success suggested an increasing effect of predation within the entire time series.     

模拟发电机组专用可控硅直流调速系统

本文从分析同步发电机原动系统基本数学模型入手，提出了一种实现同步发电机原动系统仿真的专用可控硅直流调速系统及其实用装置。该控制系统采用有差调节的模拟调速器，水汽管道特性模拟、自平衡特性模拟和集成块模拟触发器，以及过流与超速保护，并可实现有差－无差调节的转换。     

不同海拔下甲醇替代率和主喷正时对RCCI发动机性能的影响

为探究不同海拔条件下甲醇/柴油反应活性控制压燃（reactivity controlled compression ignition, RCCI）发动机的运行特性,该研究基于甲醇/柴油双燃料发动机试验台架,试验研究1 800r/min、100%负荷和3 200r/min、100%负荷下不同甲醇替代率、柴油喷射正时对发动机燃烧与排放性能的影响规律。结果表明：不同海拔条件下随着甲醇替代率的增加,缸压和瞬时放热率峰值逐渐升高,燃烧始点和燃烧中心前移,当量有效燃油消耗率（equivalent brake specific fuel consumption, ESFC）降低,有效热效率升高,NO_x和碳烟排放大幅降低,THC（total hydrocarbons）和CO排放增加。1 800 r/min、100%负荷工况下,甲醇替代率由0增至20%,0、1 000、2 000m海拔下最大缸压平均增加1.72MPa,瞬时放热率峰值平均升高25.08J/(°),ESFC平均降低4.67%,有效热效率平均升高4.90%,NO_x和碳烟排放分别平均降低16.63%和50%,THC和CO排放量分别平均增加142.03、388.18 mg/kg。3 200 r/min下甲醇替代率由0增至7%,不同海拔高度下ESFC平均降低1.76%,有效热效率平均升高1.79%,NO_x和碳烟排放量分别平均降低8.17%和20.70%。海拔高度由0升至2 000m,1 800r/min、20%甲醇替代率与3 200r/min、7%甲醇替代率下,瞬时放热率峰值分别降低4.80和8.08J/(°),燃烧中心分别推迟1.44°和1.43°,有效热效率分别降低0.82%和0.68%,ESFC分别升高2.10%和1.99%,NO_x排放量分别减少10.61%和7.35%,碳烟排放分别增加26.54%和32.12%,THC排放分别升高29.88%和15.45%,CO排放量分别增加22.42%和18.15%。固定甲醇替代率后,随着柴油主喷正时提前,不同海拔条件下缸压和放热率峰值逐渐升高,燃烧中心向上止点靠近,ESFC逐渐降低,有效热效率升高,碳烟排放减少,NO_x、THC和CO排放增加。1 800 r/min、15%甲醇替代率下,主喷正时从-1.5°提前至-7.5°,不同海拔高度下ESFC平均降低8.27%,有效热效率平均升高9.08%,碳烟排放平均减少90.94%。为提升高海拔条件下甲醇/柴油RCCI发动机的热效率和燃油经济性,可以适当增大柴油主喷正时。研究结果可为不同海拔环境下甲醇/柴油RCCI发动机燃烧与污染物排放控制优化提供参考。     

多酚羧酸合成功能高分子材料研究(Ⅱ)——没食子酰化改性纤维素合成及其功能特性试验

以没食子酰基为功能基团,以改性纤维素为骨架合成功能高分子材料没食子酰化改性纤维素(没食子酰基-1,6-己二亚胺基-羟丙基-纤维素,CG):先将纤维素与环氧氯丙烷反应,然后依次接上己二胺桥链和三乙酰基没食子酰基,最后将没食子酰基脱去乙酰基得到目标产物。功能试验表明,1g产物能结合明胶49.5mg,并可再生使用。1g产物络合金属离子的能力:Fe3 53.4mg,Cu2 38.7mg,Hg2 46.5mg,Mn2 6.8mg,Zn2 27.9mg,Pb2 57.2mg。产物在稀酸、稀碱、稀醇和热水中具有稳定性。     

缓释氮肥配施尿素对迟播小麦产量形成及氮素利用的影响

为建立稻茬迟播小麦树脂包膜缓释氮肥高效施肥模式与技术,以冬小麦品种扬麦23为材料,以43%树脂包膜缓释氮肥(PCU,含氮43%)和尿素(U,含氮46%)为氮肥,设置“一次性基施”(A)与“一基一追”(B)2种施肥模式,共形成100%树脂包膜缓释氮肥基施(A1)、80%树脂包膜缓释氮肥+20%尿素基施(A2)、60%树脂包膜缓释氮肥+40%尿素基施(A3)、80%树脂包膜缓释氮肥基施+20%尿素返青期追施(B1)、80%树脂包膜缓释氮肥基施+20%尿素拔节期追施(B2)、60%树脂包膜缓释氮肥基施+40%尿素返青期追施(B3)、60%树脂包膜缓释氮肥基施+40%尿素拔节期追施(B4)等7个施肥处理,分析了缓释氮肥与尿素配施对迟播小麦产量及其构成、茎蘖动态、干物质积累、叶面积指数、SPAD值、氮素利用效率等指标的影响。结果表明,一次性基施模式处理(A1～A3)的小麦产量显著低于常规施肥(CK,基肥∶分蘖肥∶拔节肥∶孕穗肥=5∶1∶2∶2);“一基一追”两次施肥模式处理(B1～B4)的产量显著高于CK,泰州与扬州两地分别平均增产5.77%和5.64%,其中B4处理产量最高,分别为8 796....     

谈砖砌体裂缝原因及其防治

分析了砖砌体裂缝的三种原因:即温差变形引发的、地基基础不均匀沉降引起的及特殊砌体材料产生的裂缝;并阐明了防治裂缝的对策.     

Preliminary Research on Regional Material Flow Analysis： A Case Study of Chengyang District in Qingdao

The method ＂Material Flow Analysis （MFA）＂ is one of the effective tools to study law and quantification of material flow between economic system and ecological system. On the national level, economy-wide material flow analysis has been published for a number of countries. However, published studies on the regional or local level are still very limited and a standardized method does not exist yet. On the basis of framework of Material Flow Analysis proposed by Eurostat, the paper collected related data and analyzed material input and output for the Chengyang district in Qingdao. The results showed that DMI （Direct Material Input） and TMR （Total Material Requirement） in absolute number increased about 3.6 and 3.9 times, respectively from 1995 to 2004. Fossil fuel and mineral contributed to about 50.3%-76.3% of DMI. Imports of material increased about 5.0 times and became the most important Contributor to DMI, which showed that local economic growth was highly dependent on resources from other regions and countries. DPO （Domestic Processed Output） and TDO （Total Domestic Output） represent slow increasing trend, and DPO contributed to 22.2%-58.1% of TDO, suggesting local hidden flows were of obvious effect on TDO. The biggest component of DPO is CO2, approximately accounting for 90% of DPO. The material productivity increased 57.7% in last decade, reflecting improvement of efficiency of resources utilization in some extent. However, compared to developed countries and regions, material productivity of Chengyang district was relatively low. Therefore, in order to promote the sustainability, it is essential to develop circular economy and enhance materials productivity.     

低温贮藏下不同包装材料对蔬菜种子质量的影响

蔬菜种子在低温贮藏条件下,其质量会有一定保证。为探讨在低温贮藏条件下不同包装材料对蔬菜种子质量的影响,为正确选材包装贮藏蔬菜种子、保持种子的优良种性提供依据,做以下试验,试验结果为：低温贮藏一年,塑料、纸塑、铝铂、铁罐包装对所做试验的蔬菜种子水分的变化有影响,而对其发芽率变化却没有影响;纸塑材料包装的蔬菜种子在低温贮藏一年后水分上升幅度最大。