Some Comments on Gerechte Designs

In a companion paper we derived the correct analysis for gerechte designs with uncorrected errors. Here we show that this correct analysis cannot be justified by the usual randomization argument. However, when the regions are rectangular there is a randomization procedure which validates an analysis with three separate error terms. We also outline other developments in design and analysis that may be more satisfactory.     

Effect of mate selection on fuzzy selective mating criteria in closed dairy multiple ovulation and embryo transfer nucleus programs

In order to control rates of response and inbreeding, mate selection using fuzzy selective mating criteria (FMC) was investigated in adult multiple ovulation and embryo transfer nucleus schemes for dairy cattle. Stochastic simulation was used to model the closed nucleus scheme. This mate selection was examined in four alternative mating and male selection schemes: (i) a hierarchical scheme; (ii) a hierarchical sibship scheme (two males per sibship); (iii) a factorial scheme (two sires per dam); and (iv) a factorial sibship scheme (two males per sibship and two sires per dam). Genetic response and inbreeding rate tended to be reduced by increasing the trade-off parameter of FMC between the expected breeding value and inbreeding of progeny. Inbreeding rates in all schemes were reduced by reducing the variance of family size through selection and the average coancestry of mating pairs through mate allocation.     

基于工作流的ERP系统重构的研究

分析了企业现有ERP系统运营存在的缺陷，提出了适合本企业的基于工作流的ERP系统重构的开发方案。     

应用于鱼道设计的新疆木扎提河斑重唇鱼的游泳能力测试

为了探究斑重唇鱼的游泳能力,给过鱼设施设计和鱼类游泳行为学研究提供基础参数,本研究以木扎提河野生斑重唇鱼(全长TL=12～16 cm)为研究对象,测定了其在(16.6±1.6)℃水温下的感应流速、临界游泳速度、爆发游泳速度及持续与耐久游泳能力。结果显示,斑重唇鱼感应流速为(0.18±0.02)m/s,相对感应流速为(1.40±0.23) BL/s (BL为体长);临界游泳速度为(1.02±0.15) m/s,相对临界游泳速度为(8.58±1.65) BL/s;爆发游泳速度为(1.39±0.17) m/s,相对爆发游泳速度为(10.92±1.86) BL/s;最大持续游泳速度为0.87 m/s,最大耐久游泳速度为1.37 m/s,与平均爆发游泳速度相近。其持续游泳时间与流速呈负相关(l g T=?5:136X+8:504)。当以斑重唇鱼为主要过鱼对象时,建议为吸引鱼类进入鱼道,进口流速设计为1.02～1.39 m/s,休息池主流设计为0.20～1.02 m/s,鱼道竖缝处流速宜低于0.85 m/s。鱼道长度为1 000 m时,鱼道内平均水流速度应低于0.78m/s。本研究结果可为新疆木扎...     

茄子黄萎病生防内生细菌29-12发酵条件的初步研究

初步探讨茄子黄萎病生防内生性枯草芽孢杆菌29-12的发酵条件,通过培养条件优化及正交试验得出最佳培养基配方为:玉米粉15 g/L、甘薯淀粉5 g/L、豆粕粉15 g/L、蛋白胨8 g/L、MgSO4 0.01%、K2HPO4 0.05%.最佳培养条件为:起始pH值7.5,250 ml三角瓶装液量100 ml,摇瓶速度120 r/min,接种量10%,温度30 ℃.在此条件下培养29-12菌株 84 h,抑菌圈大小为2.12 cm,1 ml含菌量为1.58×109 , 芽孢得率为100%.     

混料设计在辣椒不同类型氮肥配比试验研究中的应用

采用田间试验,研究了混料设计中的单形重心设计在辣椒控释尿素、普通尿素配肥上的应用,测定了辣椒的产量及其构成,配置了各因子的产量回归方程,解析寻优,对肥料效应及经济效益进行了分析.结果表明,三种氮肥比例为普通尿素U=0.20～0.30,控释尿素D60(控释期60天)=0.40～0.60,控释尿素D30(控释期30天)=0.20～0.40(换算为纯氮实际用量U=150.0～225.0 kg/hm2,D60=300.0～450.0 kg/hm2,D30=150.0～300.0 kg/hm2)的方案,预测最高产量可达85.0 t/hm2.控释尿素D30-D60两者配合施用、普通尿素与控释尿素D30-D60三者配合施用均能显著提高辣椒产量,比普通尿素分别增产24.40、28.26 t/hm2,增产率分别为42.0%和49.0%,产量差异均达极显著水平.施肥效应以D30-D60混合最高,为20.88 t/hm2,达极显著水平.经济效益分析表明,U-D30-D60处理施肥利润为2.440万元/hm2,氮素利用率最高,为60.1%.普通尿素与两种控释尿素按一定比例混合施用有利于提高辣椒产量和增加农民的经济收入.     

采用L_9(3~4)正交设计方法筛选血耳菌丝体液体培养基

采用正交设计方法以血耳Tremella sanguinea菌丝体的生物量为测量指标,对血耳菌丝体液体培养基进行了筛选,结果表明血耳菌丝体液体培养的最适培养基为蔗糖7.5g·L-1、麦芽糖7.5g·L-1、麦麸7.5g·L-1、牛肉膏3.5g·L-1、MgSO4·7H2O0.5g·L-1、KH2PO41.5g·L-1、VBl4mg·L-1,pH自然。28℃培养96h,其生物量可达4.29g·L-1。     

Preparation and Characterization of Tilapia Collagen-Thermoplastic Polyurethane Composite Nanofiber Membranes

Marine collagen is an ideal material for tissue engineering due to its excellent biological properties. However, the limited mechanical properties and poor stability of marine collagen limit its application in tissue engineering. Here, collagen was extracted from the skin of tilapia (Oreochromis nilotica). Collagen-thermoplastic polyurethane (Col-TPU) fibrous membranes were prepared using tilapia collagen as a foundational material, and their physicochemical and biocompatibility were investigated. Fourier transform infrared spectroscopy results showed that thermoplastic polyurethane was successfully combined with collagen, and the triple helix structure of collagen was retained. X-ray diffraction and differential scanning calorimetry results showed relatively good compatibility between collagen and TPU.SEM results showed that the average diameter of the composite nanofiber membrane decreased with increasing thermoplastic polyurethane proportion. The mechanical evaluation and thermogravimetric analysis showed that the thermal stability and tensile properties of Col-TPU fibrous membranes were significantly improved with increasing TPU. Cytotoxicity experiments confirmed that fibrous membranes with different ratios of thermoplastic polyurethane content showed no significant toxicity to fibroblasts; Col-TPU fibrous membranes were conducive to the migration and adhesion of cells. Thus, these Col-TPU composite nanofiber membranes might be used as a potential biomaterial in tissue regeneration.     

图书馆建筑设计的原则

文章通过对现代图书馆建筑特点的分析研究,阐述现代图书馆对建筑的要求及现代图书馆建筑设计应遵循的基本原则。     

玉米全膜双垄沟气动直插式穴播机设计与仿真

玉米全膜双垄沟播农艺技术抗旱、增产,实现其机械化膜上播种将是必然趋势。依据玉米全膜双垄沟农艺技术要求,设计了气动直插式穴播机,对作业机关键作业参数进行了设计计算,并结合STEP控制函数对其播种运动轨迹进行仿真分析。为揭示气动播种单体成穴器与种床土壤互作机理,借助ABAQUS有限元法构建了成穴器与种床土壤互作三维模型,分别获得了对应的Mises应力云图、空间位移云图和塑性应变云图。仿真结果分析表明:在相同的气动直插播种作用力下,锥形成穴器与种床土壤互作应力最大值约为1.541 MPa,是楔形成穴器与种床土壤最大值的1.39倍;在相同的载荷与分析步时间内,锥形成穴器对种床土壤作业下的最大塑性变形量约为19.35mm,楔形成穴器对种床土壤的最大塑性变形量约为12.35 mm。因此,锥形成穴器较楔形成穴器形成播种穴孔的能力及动土量效果更好。研究结果将为西北旱区玉米全膜双垄沟机械化播种装置的研发提供参考。