Compatibility of root growth and tuber production of potato cultivars with dynamic and static water‐saving irrigation managements

The important root characteristics of root length density (RLD) and root mass density (RMD) generally differ among irrigation managements and potato cultivars. The objective of this study was to investigate the RLD and RMD variations and their functional relationships with gross potato tuber yield for two commercial potato cultivars, Agria and Sante, under different irrigation strategies. Full irrigation and water‐saving irrigation strategies, deficit and partial root drying irrigations, were applied statically (S) and dynamically (D) based on daily crop evapotranspiration. Results showed that SPRD had significantly greater RLD (3.64 cm/cm³) and RMD (132.7 μg/cm³) than other irrigation treatments. Between the potato cultivars, Agria had significantly larger values of RLD (3.50 cm/cm³) and RMD (138.7 μg/cm³) than Sante. The functional relationship between the root growth characteristics and tuber yield showed that under water‐saving irrigations, Agria increased root mass at the expense of gross tuber yield but Sante increased root mass to maintain larger gross tuber yields. However, Agria produced more roots and gross tuber yield than Sante, and it is concluded that Agria is a more drought‐tolerant potato cultivar, which is recommended for tuber production in regions where water might be scarce. It was shown that larger root production in potatoes was associated with improved tolerance to water stress.     

Propagation techniques on root turion sprout browse ofPopulus davidiana Dode

The root segments selected from dominant trees ofPopulus davidiana Dode were taken as reproductive material and were buried in different depths to carry out the reproduction of root turion sprout. The affecting factors of gemination rate, survival rate, and height growth for cutting wood of root sprout were comparatively analyzed. The results showed that the best suitable substrate for burying root is pearlite, with a germination rate of 15.16%. 3–4-cm root segments has the highest rate of germination (12.4%). The mixture of sand and soil (2∶1) is the best cutting substrate, with a survival rate of 81.3%, while as to height growth of cutting wood, the mixture of turfy and soil (1∶1) is the best. The cutting woods selected from different positions of stem show difference in height growth. The cutting wood from top stem is higher obviously than those from middle or low stem. Biography: XING Ya-juan (1969-), female, assistant researcher in Forest Research Institute of Heilongjiang Province, Harbin 150040, P. R. China. Responsible editor: Song Funan     

水分胁迫对荔枝幼树根系与梢生长的影响

以盆栽沙培1年生荔枝空中压条苗为试材,研究了水分胁迫对荔枝幼树根系和梢生长的影响以及二者的相互关系。3个处理为:沙体积含水量为7.5%(严重缺水),15.0%(一般缺水),22.5%(充分供水)。结果表明:水分胁迫严重抑制荔枝幼树地上部分和各级侧根的生长,使地上部枝梢生长严重受阻,叶片数量、平均叶面积、叶片厚度均显著变小;根总干重、侧根长度、根表面积显著减少。水分胁迫下促进须根的生长,须根的长度、根表面积比水分充足时显著增加。水分胁迫时叶片淀粉含量下降,而根系积累更多的淀粉。比较不同处理的根梢比发现,干旱对根系生长的抑制作用比枝梢更显著。     

紫花苜蓿受冻害后促进根颈枝条再生方法的研究

对蔚县苜蓿根颈冻害后切除冻伤部分处理的比较研究结果表明,处理区的根颈苗数、地上高度、地上生物量、分蘖丛数是对照区的1.6～2倍;处理区苜蓿的各个数量指标的b值大于对照处理苜蓿b值,说明除冻害根颈后苜蓿的生长比不除冻害根颈部分的苜蓿生长更为合理。通过除去苜蓿冻害部位,防止根系继续腐烂,保护了未冻害部分,增加了苜蓿发芽的有效部位。同时,使根系与地面的距离变短或露出地面,增加光照强度,提高地温,促使未冻害苜蓿根系发芽,返青提前增加产量。     

西北工业大学金叶信息技术学院中心绿地景观设计

探讨了西北工业大学金叶信息技术学院中心绿地的景观设计方案,本着生态可持续发展、以人为本和浓郁文化内涵的原则,创造一个以自然景观和人文景观相结合的优美环境,为师生提供具有园林艺术氛围的学习、交流、休闲、娱乐和生活的场所.     

Radiation Balance Components of Maize Hybrids Grown at Various Plant Densities

Components of the energy and heat balances were examined in two maize hybrids grown at three different plant densities (40, 70 and 100 thousand plants per hectare). One of the hybrids was drought tolerant, while the other was bred for cultivation under irrigated conditions. An increase in plant density influenced not only the size of the leaf area, but also the distribution of the leaves at various plant heights. The extinction coefficient, which provides a quantification of radiation penetration, was higher in the irrigated treatments. By contrast to the other two treatments, the plant canopy in the thinly sown stands remained open throughout the vegetation period, and thus behaved quite differently to the closed stands, making it impossible to compare them. Smaller albedo values were recorded for the hybrid bred for irrigation and in thinly sown stands. The low plant density allowed more energy to reach the soil, from which it was reflected, making a considerable contribution to the final temperature in the stand. The latent heat, in keeping with the quantity of water transpired, was the greatest in the densely sown stands. There was little difference between the latent heat values of the normal and dense stands in either hybrid, indicating that they both had a similar sensitivity to increased stand density. If sufficient water is available it would appear that the stand density could be increased even for the drought-tolerant hybrid.     

论建筑创作整合思维方法及其应用

本文针对建筑创作思维方法进行研究 ,提出了研究整合思维方法的目的、意义以及功能 ,论述了以“真、善、美”作为建筑创作的追求目标和应用整合思维方法进行建筑创作应遵循的基本原则     

微生物诱导剂浸种对小麦萌发期的抗旱诱导效果

试验结果表明,在正常供水和水分胁迫条件下,经微生物诱导剂处理,可增加小麦萌发时期的根冠比,而且在水分胁迫条件下的增加幅度大于正常供水条件。微生物诱导剂可在水分胁迫条件下促进根系生长发育,提高根系干物质积累。这些性状的改善有利于提高小麦的抗旱能力。但诱导剂处理后在一定程度上抑制了小麦种子萌发率以及小麦芽和根的伸长生长。     

互联网环境下的暖通CAD组件模块的开发方法研究

针对单机环境下暖通CAD软件重复开发量大、开发周期长等现状，提出了基于互联网环境的三层体系结构及其开发的通用环境，即整个暖通CAD系统被分为不同逻辑块，开发和管理的工作向服务器方转移，从而使分布处理数据成为可能，基于组件的软件开发是互联网环境中应用软件的主要开发方式，以构架为组装蓝图，以可重用组件为组装预制块，支持组装式软件重用，从而克服人力和物力的浪费，进而为了重用暖通CAD已开发出的功能模块，给出组件逆向工程的开发方法、组装流程和组件管理过程。     

园林布局中必然性和偶然性要素的辩识与运用

阐释了园林构成要素中的必然性要素和偶然性要素及其相互关系与运用意义；以昆明世博园中“齐鲁园”为例，辩识了“齐鲁园”中必然性与偶然性园林要素，分析了诸要素在特定园林环境布局中的运用。