蜗壳式离心泵外特性仿真与实验研究

为探索不同仿真方法的适用性,对ns=157的单级蜗壳离心泵不同工况的扬程和效率进行定常和非定常计算,并分别分析了定常计算时不同叶片夹角及非定常计算时不同时间步长的影响,通过与实验对比,得到的主要结论有:定常计算仅适用于额定工况外特性仿真,其扬程和效率计算误差分别为4.9%和2.9%,而定常多相位的计算误差分别为7.1%和3.2%;非定常仿真计算时,以4°为时间步长,并间隔20°保存一次计算数据,较好地预测出扬程曲线走势,额定工况扬程和效率计算误差约1.1%和1.8%,但小流量和大流量区间扬程计算误差达到10%左右。因此在水力优化设计时,若只关注高效点位置及其扬程和效率,可采用定常计算,若还关注扬程曲线走势,则应采用非定常计算。     

Experimental investigation on the transport of different fish species in a jet fish pump

A jet fish pump with a throat of ø60 mm was designed to study its performance in the transport of different fish species and the physiological changes in fish thereafter. Experiments were conducted to investigate the fish transport rate and energy required to transport each ton of fish when transporting Carassius auratus, commonly known as the Chinese goldfish, Megalobrama amblycephala, or Wuchang bream, and Ctenopharyngodon idella, the grass carp. Fish were examined for external injuries as well as for several important enzymes and hormones which are indicators of tissue injury and stress. The results showed that the transport rate for all three species of fish rose dramatically with an increase in the primary stream rate. In this experiment, the transport rates of C. auratus, M. amblycephala and C. idella reached 2357 ± 37.2 kg ∙ h⁻¹, 2888 ± 41.6 kg ∙ h⁻¹, and 2060 ± 40.2 kg ∙ h⁻¹, respectively. However, both injury rate and energy required to transport each ton of fish increased no matter whether the primary stream rate was too low or too high. Considering both transport rate and injury rate, the mean primary stream rate of 80 m³ ∙ h⁻¹ was determined to be the optimal operating condition in this experiment. Fish were stressed and most likely some of their organs were damaged. However, most physiological indexes almost fully recovered after several hours.     

Engineered-airlift pumps for aquaculture applications using multiphase flow analysis

Currently, very few aquaculture operations are employing airlift pump technology for water recirculation, aeration, and waste removal. This is likely due to the poor design and lower efficiency of traditional airlift design, the limited amount of research effort that has been invested in improving performance capabilities of air lift pumps and the general lack of awareness of the industry about the inherent advantages of airlift systems. A new efficient airlift pump is hydrodynamically designed by incorporating the Volume of Fluid (VOF) multi-phase model along with the K-ε turbulence model utilizing Computational Fluid Dynamics (CFD) tools. The pump is designed to offer a substantial reduction in total energy usage as well as an improved quality of the culture products in order to make it attractive to aquaculture industry. In this study, both numerical and experimental investigations were carried out for airlift systems operating under two different submergence ratios of 50% and 90% in a lab setting using 2.54 cm diameter pumps. Also, the performance of a large-scale pumps of 10.16 cm diameters were also tested in an aquaculture raceway to determine its effect on the operation. The numerical results were found to be in agreement with the experiments within ±20% which is considered very reasonable for multiphase flow analysis. The present study was found to present a great tool for modelling the airlift pump performance, and potentially proposing new designs.     

含刚性沉水植物明渠水流结构的试验研究

【目的】得到含刚性沉水植物明渠的水流结构。【方法】采用粒子图像测速仪(PIV),用有机玻璃棒模拟刚性植物,在不同来水流量、植物密度条件下对明渠水流结构进行了试验研究。【结果】无植物时平均流速沿垂向呈对数分布规律,有植物时则呈现明显的分区分布特性。无植物时紊动强度值沿垂向变化不大,有植物时在植物顶端位置处紊动最剧烈。流量或植物密度越大,植物顶端位置的流速梯度就越大,植物层上方的流速最大值也越大。植物密度越大,植物顶端位置的紊动强度越大,植物密度对水流紊动强度由最大值减小到最小值的区域影响很大。【结论】刚性沉水植物的存在会改变水流结构,增强紊动掺混,增强流体质点交换和能量传递,且上述影响会随着流量或植物密度的增大而增强。     

叶轮出口边对双蜗壳泵压力脉动的影响

泵的叶轮扫掠蜗壳隔舌时产生的压力脉动是引起船用泵振动噪声的原因之一.为尽可能弱化这一影响,分别设计了叶片出口边与前后盖板基本面垂直和倾斜的2种不同形式叶轮,将其配置在相同的双蜗壳中,通过数值计算与样机试验相结合的手段,对蜗壳内9个不同位置的压力脉动情况进行对比分析.结果表明:出口边倾斜的叶轮相比于出口边垂直的叶轮可明显改善蜗壳内次脉动的“驼峰”现象,且可以进一步降低隔舌处主波动的压力峰值;对蜗壳内2个隔舌稍前的位置,出口边倾斜的叶轮反而会使得该点的压力系数幅值明显增大,且该点主波动的周期数发生改变;2种叶轮出口边的不同形式对蜗壳出口位置的压力脉动的影响基本相同;采用出口边倾斜叶轮对改善因叶轮与隔舌间的液流压力脉动是可行的.     

Establishing an eyeball-weight relationship for Litopenaeus vannamei using machine vision technology

This study aimed to establish a shrimp eyeball-weight relationship model for Litopenaeus vannamei using machine vision technology. A total of 295 shrimp were sampled from a recirculating aquaculture system (RAS). The long-axis length (d), body length (L), and body weight (W) of each individual was measured. The long axis length of the shrimp eyeball was identified and measured using machine vision technology. Continuous fitting and piecewise fitting models were used to construct the eyeball-weight relationship model for L. vannamei. The continuous fitting relationship model was described as: W = 38.865d^2.7914, while the piecewise model was described as: d < 2 mm, W = 0.0326d^3.7363, R² = 0.9288; 2 mm ≤ d < 3.9 mm, W = 0.0401d^3.104, R² = 0.9629; 3.9 mm ≤ d < 5.8 mm, W = 0.0421d^3.0311, R² = 0.9216; 5.8 mm < d, W = 0.103d^2.6226, R² = 0.9457. The root mean square error (RMSE) of the piecewise fitting model (0.0244, 0.1575, 0.5034, 0.7072) was smaller than the continuous fitting model (0.8229). The correlation coefficient (R²) of the piecewise model (0.9288, 0.9629, 0.9216, and 0.9457) was similar to that of the continuous fitting model (R² = 0.9621). The results indicated that the piecewise fitting model is suitable for calculating the biomass of L. vannamei in RAS and provides a novel way of estimating the biomass of L. vannamei cultured in RAS. The piecewise fitting model can also provide the foundation of evaluating the production of shrimp using underwater image recognition in intelligent aquaculture systems.     

泡沫比例混合器在液下喷射灭火系统中的应用

提出了环泵泡沫比例混合器和泡沫压力比例混合器在相应灭火系统中的应用、安装和操作中应注意的问题，对两种泡沫比例混合器组成的系统进行了对比，认为环泵比例混合泡沫灭火系统采用正压进水，可以克服负压进水方式存在的缺陷，比较适合油库火灾的扑救；压力比例混合泡沫灭火系统灵活性、匹配性较差，适用于泡沫混合液流量相对不变的火灾扑救。     

有摩擦的高速气体管流

本文以多变热力过程为基础建立了有摩擦管路的计算公式,并对计算方法和有关问题作了分析说明.     

Reproduction in three species of rainbowfish (Melanotaeniidae) from rainforest streams in northern Queensland, Australia

Abstract – The reproductive biology of three species of rainbowfish (Melanotaeniidae) in northeastern Australian rainforest streams was investigated. Two species, Melanotaenia eachamensis and Cairnsichthys rhombosomoides are endemic to the area, whereas the third, M. splendida splendida, is more widespread. The species were all highly fecund, producing many hundreds of eggs between 1.10 and 1.24 mm in diameter. Melanotaenia eachamensis was the most fecund, produced the largest eggs of the three species, and consequently exhibited the greatest maternal investment (as measured by gonadosomatic index). The majority of reproductive effort occurred during the dry season, although reproductively active fish were present year-round for each of the species, but particularly so for M. s. splendida and C. rhombosomoides. No evidence for a role by temperature or photoperiod as environmental cues for reproduction was found, and it was suggested that gonad development was strongly tied to somatic growth. The concentration of reproduction to the dry season ensures that larvae are produced during a period of relatively stable and benign physical conditions. Comparison of temporal changes in gonadosomatic index values suggest that the spawning season of M. eachamensis , which occurs in high-elevation streams, is more restricted and commences about 1 month earlier than either other species. A similar phenology was observed for the M. s. splendida population found at high elevation and highlights the potential for spatial differences in stream productivity to influence life history. ^Note     

迷宫螺旋槽的选取研究

以提高迷宫螺旋泵的扬程、流量、效率、汽蚀等性能参数为目标,给出不同使用条件下螺旋槽形状与几何参数的选取。