5龄蚕立体条桑育研究

研究了5龄立体饲育架制作，条桑收获及饲养技术，明确了全年采用立体条桑育对蚕茧产质量及桑树秋末生长的关系，条桑收获及饲育是一项省工高效的养蚕技术。     

SH系砧木及对应中间砧红富士苹果枝条水分输导阻力研究

为进一步揭示砧木的矮化机理 ,以SH系矮化砧木及相应中间砧红富士苹果为试材 ,在生长季测定砧木枝条及嫁接部位的水分输导阻力。结果表明 ,SH系砧木枝条及嫁接部位的水分输导阻力 ,随砧木矮化程度的升高而增大 ,表明水分输导阻力的增加 ,是导致嫁接树矮化的原因之一。     

不同有机物对铁皮石斛试管苗生长发育的影响

研究不同有机物浸提液对铁皮石斛试管苗生长的影响。在相同的培养条件下，以8种含有不同有机物的培养基培养试管苗，60d后对试管苗的各种性状进行记录统计，并与对照（没加有机物提取液）进行比较分析。结果不同的有机物浸提液对试管苗的影响效果不一样。壮苗以加入白萝卜提取液、CH和CM为佳，生根以加入香蕉提取液为佳，要提高繁殖系数以不加有机物为佳。     

肥城桃组培苗诱导、基因转化及其增殖

红里、白里是肥城桃的两个优良品种,但不耐贮藏。为试图利用基因工程解决这一问题,先通过组培将其胚、胚乳、子叶的愈伤组织分别诱导再生植株和芽剥离出茎尖培育成苗。再将肥城桃反义PG基因,通过农杆菌介导转化组培苗,转化苗在含卡那霉素培养基上筛选,获得抗卡那霉素的转基因苗。用研制的增殖培养基培养4～7周,一个苗可生长出14～18分枝的苗,解决了转基因苗获得率低的问题,也满足了对转基因株系进行检测和从组培室到温棚到田间果园过渡栽培和芽接的需求,提高了繁育速率。     

‘罗田甜柿’胚乳培养获得十二倍体再生植株

 取‘罗田甜柿’自然授粉后约70 d 的胚乳, 采用不同细胞分裂素和生长素组合进行离体培养。结果表明: 以1/ 2MS (1/ 2N ) + ZT (玉米素) 1.1 mg/ L + 2,4-D 1.0 mg/ L + CH (水解酪蛋白) 1000mg/ L 诱导产生的愈伤组织易获得再生植株; 形态学和细胞学检测确认再生植株中存在2n=12x=180 的个体。该十二倍体植株对中国原产甜柿的遗传改良可能具有潜在的应用价值。     

基于改进YOLOv8n的茶叶嫩稍检测方法

针对名优茶智能采摘中茶叶嫩梢识别精度不足的问题,该研究对YOLOv8n模型进行优化。首先,在主干网络中引入动态蛇形卷积（dynamic snake convolution,DSConv）,增强模型对茶叶嫩梢形状信息的捕捉能力;其次,将颈部的路径聚合网络（path aggregation network,PANet）替换为加权双向特征金字塔网络（bi-directional feature pyramid network,BiFPN）,强化模型的特征融合效能;最后,在颈部网络的每个C2F模块后增设了无参注意力模块（simple attention module,SimAM）,提升模型对茶叶嫩梢的识别关注度。试验结果表明,改进后的模型比原始模型的精确率（precision,P）、召回率（recall,R）、平均精确率均值（mean average precision,mAP）、F1得分（F1 score,F1）分别提升了4.2、2.9、3.7和3.3个百分点,推理速度为42 帧/s,模型大小为6.7 MB,满足低算力移动设备的部署条件。与Faster-RCNN、YOLOv5n、YOLOv7n和YOLOv8n目标检测算法相比,该研究提出的改进模型精确率分别高出57.4、4.4、4.7和4.2个百分点,召回率分别高出53.0、3.6、2.8和2.9个百分点,平均精确率均值分别高出58.9、5.0、4.6和3.7个百分点,F1得分分别高出了56.8、3.9、3.7和3.3个百分点,在茶叶嫩梢检测任务中展现出了更高的精确度和更低的漏检率,能够为名优茶的智能采摘提供算法参考。     

Influence of total soluble salt concentration on growth and elemental concentration of winged bean seedlings,Psophocarpus tetragonolobus (L.) DC.

Abstract

Winged bean (Psophocarpus tetragonolobus) (L.) DC) seedlings of the accession TPT‐1, were grown in a greenhouse with graded, balanced total soluble salt (TSS) concentrations. After 4.5 days, plant height increased quadratically, with a maximum (149 cm) at 3000 ppm TSS. Seedlings were shortest at 1000 and 10,000 ppm TSS, 44.0 and 79.0 cm, respectively. Fresh weight of shoots increased quadratically with greatest weight, 29.03 g, at 5000 ppm TSS. Percent dry matter increased linearly with increasing TSS. Concentration of N, K and P increased quadratically with an increase in the TSS concentration in the growth medium. Concentration of Ca decreased quadratically with increasing TSS. Among the micronutrients, Fe and Mo concentration was quadratic, both elements were highest in the seedlings at 1000 and 10,000 ppm TSS rates. Concentrations of Mn and Zn increased linearly with increasing TSS. Winged bean seedlings at the 1000 to 3000 ppm TSS rates had spindly stems and a sparse, yellow foliage, typical for winged bean seedlings observed in the field during the first 4 to 5 weeks of growth. Seedlings at the 4000 and 5000 ppm TSS rates had sturdy stems and an abundant green foliage. At higher TSS concentrations, 5000 to 10,000 ppm TSS, seedlings had short intermodes and dark green foliage.     

刀削结合滚动摩擦进料竹笋剥皮机设计与试验

针对目前我国竹笋剥皮机械化程度低的问题,设计一种刀削结合滚动摩擦进料竹笋剥皮机。根据竹笋物理特性参数和人工剥笋原理,对竹笋剥皮过程进行力学与运动学分析,确定了影响剥皮效率、损伤率和剥净率的主要因素为刀片安装倾角、剥皮辊转速以及滚筒与剥皮辊轴心高度差,在此基础上,给出了竹笋剥皮机关键部件的设计依据。为获得样机最佳试验物料,以竹笋长度、基部直径作为试验因素进行单因素试验,确定长度为300～320mm、基部直径为29～32mm的竹笋作为剥皮机正交试验物料样本。利用Design-Expert软件设计三因素三水平正交试验,并结合实际工作情况确定最优参数组合,结果表明：当刀片安装倾角为30.12°、剥皮辊转速为229.18r/min、滚筒与剥皮辊轴心高度差为15.43mm时,笋肉损伤率为6.81%,笋皮剥净率为94.59%。在该条件下开展验证试验,得到损伤率、剥净率分别为7.10%、93.22%,与优化参数基本一致,满足剥笋要求。     

Mass propagation of Satyrium nepalense D.Don.—A medicinal orchid via seed culture

An in vitro plant regeneration protocol was successfully established in Satyrium nepalense, a terrestrial orchid by culturing immature seeds from unripe fruits. Seeds were germinated on Murashige and Skoog, Knudson C and Knudson C modified Morel medium. The germination of the seeds and development of protocorm was highest in MS medium (86.7%) followed by Knudson C modified Morel medium (74%) and Knudson C medium (61.2%). Among the cytokinins tried for multiple shoot induction from the protocorm, 1-phenyl-3-(1,2,3-thiadiazol-5-yl)-urea (TDZ) was found to be superior. Indole-3-butyric acid (IBA) was effective for inducing healthy roots. Well-developed plantlets were hardened in vermicompost (leaf litter + cow dung 1:1), sand and coconut husk (1:1:1).     

花椰菜未受精子房、花托、花序轴离体培养诱导成苗研究

以花椰菜的花托、花序轴和未受了房为外植体,诱导出不定芽,并进行继代增殖培养,在工增殖培养基上每隔２５～３０天,不定芽可以增殖５～６倍,不加激素的１／２ＭＳ培养基上,试管苗生根率达到９８％以上,移栽成活率达到９５％以上。经观察,花托和未受精了再生植株是由外植体直接分化而来,不经过愈伤组织阶段,这样可避免不良变异,保持材料的遗传稳定性。