Artificial Insemination of Gilts with 1.5 Billion Sperms Stored in Different Periods Associated with Different Pre-ovulatory Intervals

This study evaluated the reproductive performance of gilts inseminated at three intervals before ovulation (0-12, 13-23, 24-30 h) with sperm doses (SD) stored for 0-48 and 96-120 h. A total of 218 PIC Camborough 22 gilts were inseminated once with SD of 1.5 x 10(9) sperms. Pregnant gilts (n = 166) were slaughtered 30.8 +/- 3.7 days after artificial insemination. The number of corpora lutea (CL) and total embryos (TE) was counted. Pregnancy rates (PR) were analysed by chi-square test. TE and embryonic survival (ES), obtained as the ratio between viable embryos and CL, were analysed by GLM procedure (SAS) and mean values were compared by Tukey's test. Pregnancy rate was similar among artificial insemination-ovulation (AIOV) intervals when semen was stored for 0-48 h. However, the lowest PR was observed in the 24-30 h AIOV interval with storage time (ST) of 96-120 h (p < 0.05). There was a significant effect of the interaction between ST and AIOV (p < 0.05) on TE and ES variables. Total embryos and ES did not differ (p > 0.05) among AIOV intervals in ST of 0-48 h. However, gilts inseminated at 24-30 h AIOV interval with ST of 96-120 h showed a reduction of 6.7 embryos (p < 0.05) compared with gilts in the same interval inseminated with semen stored for 0-48 h. ES for the 24-30 h AIOV interval and ST of 96-120 h was lower than that observed in the other groups (p < 0.05).     

Epidemiology and pathogenesis of Mycobacterium bovis infection of red deer (Cervus elaphus) in New Zealand

AIMS: This study was initiated to investigate aspects of the epidemiology, pathogenesis and transmission of tuberculosis in wild red deer, with the aim of determining whether this species may be considered a reservoir host of Mycobacterium bovis in New Zealand. METHOD: One hundred and six wild red deer (Cervus elaphus) carcasses from the Castlepoint and Hauhungaroa Range areas, which are endemic for bovine tuberculosis, were examined for the presence of M. bovis infection. Samples were also examined from 46 skin test-positive farmed deer killed at two deer slaughter premises. Where possible, a standard set of tissues and excretion site samples was collected for mycobacteriological examination. RESULTS: Fifty-eight infected deer were identified, and of these 28% showed no gross lesions. The prevalence of tuberculosis confirmed by culture in the wild deer was 32%. Only one of 18 deer younger than 1 year was infected. Mature deer (>2 years) were 12 times more likely to be infected than those under 1 year of age. Infected older deer were less likely to show typical gross lesions than younger animals. Mycobacterium bovis was isolated from the oropharyngeal tonsil of 34 of 56 (61%) of the infected deer, and this was the most commonly infected site. Gross lesions were found in 18 of the 34 infected tonsils and only one of these showed a purulent tonsillitis. Mycobacterium bovis was recovered from four of 53 nasopharyngeal tonsils, four of 53 oropharyngeal swabs, one of 53 tracheal and nasal swabs, and one of 46 faecal samples, but not from any urine specimens. CONCLUSION: These findings suggest that significant bacillary excretion from infected deer was uncommon, and is more likely to occur in severely affected animals. This study has confirmed the importance of mucosa-associated lymphoid tissues (MALT), particularly the oropharyngeal tonsil, in the pathogenesis of tuberculosis in deer. The findings justify investigation of the hypotheses that the prevalence of tuberculosis in wild deer in New Zealand is high due to transmission of infection from possums, and that in the absence of an infected possum population, the prevalence of tuberculosis in deer is likely to be low, and spatially patchy. CLINICAL RELEVANCE: The results suggest that about one quarter of infected deer show no detectable gross lesions. This implies that many infected carcasses may enter the food chain unrecognised and that the estimated sensitivity and specificity of diagnostic tests may be erroneous if there is a difference in test performance between those conducted on deer with or without gross lesions. Diagnostic sensitivity following slaughter may be improved by routine culture of oropharyngeal tonsils and careful examination of lungs for adhesions and small subpleural tubercles.     

Holding Power of Different Pin Designs and Pin Insertion Methods in Avian Cortical Bone

Objective —To measure pullout strength of four pin types in avian humeri and tibiotarsi bones and to compare slow-speed power and hand insertion methods.
Study Design —Axial pin extraction was measured in vitro in avian bones.
Animal Population —Four cadaver red-tailed hawks and 12 live red-tailed hawks.
Methods —The pullout strength of four fixator pin designs was measured: smooth, negative profile threaded pins engaging one or two cortices and positive profile threaded pins. Part 1: Pins were placed in humeri and tibiotarsi after soft tissue removal. Part 2: Pins were placed in tibiotarsi in anesthetized hawks using slow-speed power or hand insertion.
Results —All threaded pins, regardless of pin design, had greater pullout strength than smooth pins in all parts of the study ( P < .0001). The cortices of tibiotarsi were thicker than the cortices of humeri ( P < .0001). There were few differences in pin pullout strengths between threaded pin types within or between bone groups. There were no differences between the pullout strength of pins placed by slow-speed power or by hand.
Conclusions —There is little advantage of one threaded pin type over another in avian humeri and tibiotarsi using currently available pin designs. There were few differences in pin pullout strengths between humeri and tibiotarsi bones. It is possible that the ease of hand insertion in thin cortices minimizes the potential for wobbling and therefore minimizes the difference between slow-speed drill and hand insertion methods.
Clinical Relevance —Threaded pins have superior bone holding strength in avian cortices and may be beneficial for use with external fixation devices in birds.     

Characteristic site disturbance due to harvesting and extraction machinery traffic on sensitive forest sites with peat soils

The effects of wood harvesting and extraction machinery traffic on sensitive forest sites with peat soils were characterised with the objective of quantifying the threshold levels beyond which significant site impacts (compaction and rutting) would occur. The treatments involved running the machines in selected extraction racks (i.e., 3 m wide machine routes) while conducting normal wood thinning and extraction operations comprising one and two passes by the harvester and the forwarder with full payload, respectively. Soil disturbance thresholds were established by testing the level of significance of the difference in induced soil damage and compaction before and after machine traffic treatments. For volumetric soil water content lying between 10.0 and 14.9%, threshold cone penetration resistance levels for two 600/55–30.5 tyres were found to range from 594 to 640 kPa for deep-raised peat soil with initial strength lying between 524 and 581 kPa. In general, the proportion of the total rut depth data in each rack that exceeded the threshold level of 21.5 cm was about 5%. The threshold value corresponds to sinkage equivalent to 15% of the overall wheel diameter of the harvester, above which machine mobility would be hampered considerably. In addition, after harvester traffic the mean rut depth per unit rack length was 10.2×10⁻² cm/m, and it ranged from 0.7 to 24.7×10⁻² cm/m.     

The Post‐Cervical Insemination does not Impair the Reproductive Performance of Primiparous Sows

The study evaluated the reproductive performance of primiparous sows submitted to post‐cervical insemination (PCAI) compared with cervical artificial insemination (CAI). Difficulty with catheter introduction, the occurrence of bleeding or semen backflow during insemination, and volume and sperm cell backflow up to 60 min after insemination were also evaluated. Sows were homogenously distributed, according to body weight loss in lactation, lactation length, weaned piglets, weaning‐to‐oestrus interval and total born in previous farrowing, in two treatments: PCAI (n = 165) with 1.5 × 10⁹ sperm cells in 45 ml (2.4 ± 0.04 doses per sow) and CAI (n = 165) with 3 × 10⁹ sperm cells in 90 ml (2.5 ± 0.04 doses per sow). During PCAI, sows were inseminated in the absence of boars. Transabdominal real‐time ultrasonography was performed at oestrus onset, immediately before the first insemination and at 24 h after last insemination. There was no difference (P > 0.05) between treatments in farrowing rate (91.5% × 89.1%) and litter size (12.5 × 11.9 piglets born, respectively for PCAI and CAI sows). Successful passage of the intrauterine catheter in all the inseminations was possible in 86.8% (165/190) of sows initially allocated to PCAI treatment. Difficulty of introducing the catheter in at least one insemination did not affect the reproductive performance of PCAI sows (P > 0.05). Bleeding during insemination did not affect (P > 0.05) the farrowing rate in both treatments, but litter size was reduced in CAI and PCAI sows (P ≤ 0.06). Percentage of spermatozoa present in backflow within 1 h after insemination was greater in CAI than PCAI sows (P < 0.01). More than 85% of primiparous sows can be successfully post‐cervical inseminated with doses containing 1.5 × 10⁹ sperm cells in the absence of the boar during insemination without impairing the reproductive performance.     

Body measurements of newborn calves and relationship of calf shape to sire breeding values for birth weight and calving ease

Body measurements on Angus- (n = 374) and Polled Hereford-sired (n = 438) calves were used to quantify calf shape via multivariate factor analysis, and measurements on Polled Hereford-sired calves were further used to investigate relationships between calf shape and sire expected progeny differences (EPD) for birth weight and first-calf calving ease. Calf birth weight, head circumference, shoulder width, hip width, heart girth, cannon bone circumference and length, and body length were recorded at 24 h postpartum. Sire birth weight EPD was positively associated (P less than .05) with all calf measures but only with head and cannon circumference after adjustment for phenotypic birth weight and gestation length. Thus, at constant birth weight, calves from higher birth weight EPD bulls tended to have larger cannon and head circumferences. Calving ease EPD was negatively related (P less than .05) to all calf measures except shoulder width. After adjustment for birth weight, only cannon circumference was associated with calving ease EPD, and this effect was removed by additional adjustment for birth weight EPD. Thus, at constant birth weight, bulls with higher EPD for calving ease sired calves with smaller cannon circumference, but at constant birth weight EPD, body measures were not associated with calving ease EPD. Factor analysis defined underlying skeletal width and frame components of shape (independent of birth weight) for both sire breeds. Calf shape differed among sires and was in part explained by birth weight EPD. No additional variation in shape was explained by calving ease EPD. Calf shape seemed to add no information for prediction of dystocia to that provided by birth weight EPD.     

Effects of alternative lamb production systems, maternal line, and culling strategy on flock age structure.

The 5-yr attrition of 1/4 (n = 411) or 1/2 (n = 403) Finnsheep (Finn) ewes exposed to terminal sire breeds in either an accelerated or semi-intensive annual lambing system was recorded to test the effects of system and percentage Finn on flock age structure at equilibrium. Ewes were culled for discernible ailments and failure to lamb after two consecutive non-spring exposures in yr 3, 4, or 5 only. Additionally, four progressively more intensive culling strategies for nonconception were practiced in retrospect. Flock productivity (kilograms of lamb weaned per ewe maintained per year) at age structure equilibrium was estimated for all culling strategies. The majority of all systems (cull strategy x lambing system x percentage Finn combination) were composed of ewes less than or equal to 3 yr old. Replacement requirements ranged from 24 to 38% in the accelerated system and 22 to 26% in the annual system. Quarter-Finns yielded greater replacement needs and shorter productive lives in accelerated lambing but fewer replacement requirements and longer productive lives than 1/2 Finns in annual lambing. Replacement requirements greatly increased with culling intensity in accelerated lambing (up to 54% above original levels) but only slightly in annual lambing (up to 8% above original levels). Mean (reproductive) lifetime estimated from fitted Weibull survival curves ranged from 3.1 to 5.1 yr in accelerated lambing and 4.5 to 5.4 yr in annual lambing. Increased culling for non-lambing decreased productivity at flock age structure equilibrium in accelerated lambing but did not change productivity in annual lambing. Repeatability of ewe effects on conception was generally low. Overall, system, percentage Finn, and culling strategy interact to influence system productivity through flock age structure. Intensive culling for non-lambing and replacement with ewe lambs of equal genetic merit should not be practiced in accelerated lambing systems.