Resin canal traits relevant for constitutive resistance of Norway spruce against bark beetles: environmental and genetic variability

The influence of genetic determination and environment on the variability of secondary resin canal traits was investigated on 15–19-year-old Norway spruce (Picea abies (L.) Karst.) clones grown in Lower Austria (Pressbaum and Ulmerfeld) and southern Sweden (Knutstorp and Hermanstorp). Eleven and 20 clones were present on the two Austrian and the two Swedish sites, respectively. The sites differed in their water availability, as indicated by different annual precipitation and soil type. Resin canal traits measured were the number of epithelial cells per canal, the number of resin canals per unit tangential wood surface area, the mean resin canal area and the total resin canal area per unit tangential wood surface area. The latter three traits are known to be related to the constitutive resin flow of Norway spruce.

Environment had an influence on the variability of resin canal traits but the most important factor for the variability was the tree’s genetic disposition. Within countries, clones from the drier sites (Pressbaum and Hermanstorp) showed significantly smaller resin canals. Trees from Pressbaum also had smaller total resin canal areas than trees from Ulmerfeld. The number of epithelial cells and the number of canals did not differ between sites.

Resin canal traits had wide genetic variation and high broad sense heritabilities (H²), with values between 0.28 and 0.82. Highest heritability values were reached for the number of epithelial cells and the number of canals (H² > 0.8). Genotypic correlations across trials were high for the resin canal traits and approached 1 in both the Austrian and the Swedish trials, indicating that there was little genotype by environment interaction for these traits and thus the ranking of clones was very similar in the different environments.

The number of epithelial cells, the mean area and the total resin canal area showed either moderately significant positive genotypic correlations with tree growth traits or none at all.

In a breeding context, our results are encouraging and indicate that high constitutive defence potential against bark beetles, such as Ips typographus, is not aligned with low volume growth. But it should be taken into consideration that environment and forestry practices can also have an impact on the resin reservoir provided by the radial resin canals.     

Digital image analysis of radial shrinkage of fresh spruce (Picea abies L.) wood

Contact-free digital image analysis was performed of the radial shrinkage of fresh, fully saturated small spruce wood beams. An experimental test set-up was developed to ensure constant distance from the charge-coupled device camera to the sample surface as well as constant climate and light conditions during the whole experiment. Dimensional changes were observed immediately after the drying process began. An unexpected distinct effect could be observed which could not be explained by drying surface layers only. After a fast initial radial shrinkage a slowing down of the dimensional changes occurred at high mean moisture contents. A complete interruption of any dimensional changes followed. Finally, a recovery from shrinkage was even observed. It is assumed that strong negative pressure occurred in the fully saturated capillaries owing to dehydration which led to additional dimensional changes. As a consequence, the break of the water column and aeration in these capillaries finally resulted in a recovery period in the shrinkage rate due to the pressure release. After this effect, the dehydration was characterized by a phase of fast and almost linear shrinkage due to drying surface layers. Finally, the shrinkage slowed down to zero when reaching equilibrium moisture content.     

Comparison of methods to quantify loss of hydraulic conductivity in Norway spruce

? Percent loss of hydraulic conductivity (PLC) is an important measure in plant water relations, but the available methods differ and results have rarely been compared.

? We compared PLC measured in Norway spruce (Picea abies) by quantifying conductivity before and after removing emboli, either by flushing with high water pressure or by infiltration under a partial vacuum, with relative water loss and staining conductive xylem to test advantages and possible problems of commonly applied methods.

? Infiltration removed nearly all gas from sections of drought-stressed and unstressed twigs, and flushing and infiltration efficiently removed emboli. Infiltration appears less prone to producing clogged xylem elements than high pressure flushing. Relative water loss (RWL) and the proportion of xylem stained with phloxine B (PSX) was also highly correlated with PLC, the latter can be quantified by image analysis, and also shows the pattern of xylem dysfunction. Loss of conductivity was more common in the inner annual rings, in early wood within an annual ring, and in compression wood, though pattern differed substantially between branches.

? Advantages and potential problems of these methods are discussed and it is suggested that RWL or PSX may be used as proxy measures for PLC in species when the correlations have been established.

     

Sap flux – a real time assessment of health status in Norway spruce

Top dieback of Norway spruce (Picea abies), triggered by drought in 2004–2006, has been observed in Southeast Norway and trees died within four years after appearance of the first symptoms. The aim of our study was to use sap flux measurements as a diagnostic method for assessment of tree vitality. We used the heat field deformation method to monitor the sap flux density (SFD) in four pairs of healthy and declining trees in situ. To provide retrospective information on hydraulic performance of the trees we took samples for wood anatomical analysis. After felling the trees we used the modified differential translucence method (MDT) as a proxy for the SFD measurements. Healthy trees had three times higher SFD values as declining trees. In some healthy trees we detected decreasing SFD with time. The MDT method agreed with the SFD measurements. In conclusion, we detected sap flux dysfunction in declining trees and showed that the SFD reduction may occur during a short period, prior to occurrence of any visual symptoms. We suggest incorporating the SFD measurements into the repertoire of diagnostic tools in forest pathology.