IMPACT OF SULFUR FERTILIZATION ON DIFFERENT FORMS AND BALANCE OF SOIL SULFUR AND THE NUTRITION OF WHEAT IN WHEAT-SOYBEAN CROPPING SEQUENCE IN TARAI SOIL

A field experiment was conducted at farmer's field in Mollisols of Tarai soils in Uttarakhand (India), to assess the direct and residual effect of sulfur fertilization in wheat-soybean cropping sequence. Four levels of sulfur (S; 0, 15, 30, and 45 kg ha^?1) were applied to main crop (wheat) along with recommended dose of nitrogen (N), phosphorous (P), and potassium (K). The direct and residual effect of sulfur at highest level showed 27 and 6 percent increase in grain yield of wheat and soybean over control, respectively. The increase in grain yield of wheat was significant at each sulfur level. The direct as well as residual effect of sulfur showed significant increase in sulfur concentration and its uptake by grain and straw except increase in sulfur concentration and uptake by soybean straw. In wheat-soybean cropping sequence, the agronomic efficiency and apparent sulfur recovery decreased with increase in levels of sulfur, but the percent response increased with increasing sulfur application. Different forms of sulfur such as total sulfur, organic sulfur, calcium chloride extractable sulfur, potassium dihydrogen phosphate extractable sulfur, and non-sulfate sulfur in post-harvest soil increased according to sulfur level applied but it decreased under control and also after residual crops. The buildup of sulfur in surface soils was greater than in the deeper soils. Application of sulfur showed the positive sulfur balance and it increased with increase in sulfur level, while it was negative under control. A major portion (46–62%) of applied sulfur contributed to increase in sulfur content of root zone soil followed by unaccounted component (25–40%) and small portion (11–18%) was absorbed by wheat plant as uptake.     

Use of adsorbent and supercritical carbon dioxide to concentrate flavor compounds from orange oil.

Orange oil is composed largely of terpene hydrocarbons but is a source of flavor and fragrance compounds (oxygenated) that are present in low concentrations. To increase the ratio of oxygenated compounds to terpene hydrocarbons, orange oil was partially fractionated by adsorption of the oxygenated compounds onto porous silica gel, with full utilization of its adsorbent capacity, and then further purified by desorption into supercritical carbon dioxide. The desorption of 24 compounds was monitored by GC and GC-MS. Adsorption alone removed three-fourths of the terpene hydrocarbons, and fractional extraction by supercritical carbon dioxide (SC-CO(2)) improved the separation further. Response surface methodology was used in the experimental design, and regression analysis was used to determine the effects of process variables. Extraction at low temperatures and flow rates improved separation by SC-CO(2). Decanal was concentrated to 20 times that of the feed oil by using SC-CO(2) at 13.1 MPa, 35 degrees C, and 2 kg/h. The systems were operating at close to equilibrium conditions because of the fine dispersal of the oils and the excellent mass transfer properties of supercritical carbon dioxide.     

Biosorption of Zn (II) onto the Surface of Non-living Biomasses: A Comparative Study of Adsorbent Particle Size and Removal Capacity of Three Different Biomasses

Present research has delineated the biosorption potential of three different nonliving biomasses namely eucalyptus bark saw dust, mango bark saw dust, and pineapple fruit peel with respect to Zn (II) ion removal from liquid phase through batch experiments. The efficacy of Zn (II) ion biosorption onto surface of biosorbents was judged and correlated with biosorbent particle size, surface chemistry, and surface texture. Maximum metal ion uptake capacity, percentage removal, and minimum equilibrium concentration as 1.688 mg/g, 84.4%, and 1.56 mg/l, respectively, was obtained using eucalyptus bark saw dust mediated biosorption followed by mango bark saw dust as 1.028 mg/g, 51.4%, and 4.867 mg/l and pineapple fruit peel as 0.45 mg/g, 22.9%, and 7.71 mg/l, respectively, at a particle size of 0.5 mm. Additionally, present investigation also proved that biosorption efficiency and metal ion interaction with adsorbent surface also depends upon presence of functional groups involved in metal ion adsorption and surface porosity.     

Clinical and hematological findings on "Degnala", a disease of buffalo in Eastern Nepal

A buffalo disease, called "Degnala", causing lameness, edema, gangrenous ulceration of hooves or tail, emaciation, recumbency and eventual death, occurs in Eastern Nepal. Clinical examinations manifested lice eggs on hairs, bradycardia, hypothermia, dehydration, exanthema and icterus. Hematologically, increase of band neutrophil, giant platelet, hypoalbuminemia and hyperglobulinemia were characteristics. Microscopically, dark blue tiny particles were seen on red blood cell (RBC) after Giemsa staining. Administration of tetracycline at an early stage of the disease was effective.     

Moisture-dependent physical properties of jatropha fruit

The physical properties of fruit are important in designing and fabricating equipment and structures for handling, transporting, processing and storage, and also for assessing quality. The study was conducted to investigate some physical properties of jatropha fruit at various moisture levels. The average length, width, thickness and 1000 mass were 29.31 mm, 22.18 mm, 21.36 mm and 1522.10 g, respectively, at moisture content of 7.97% d.b. The geometric mean diameter increased from 24.03 to 24.70 mm and the sphericity varied between 0.82 and 0.83 as moisture content increased from 7.97% to 23.33% d.b., respectively. In the same moisture range, the bulk and true densities decreased from 278 to 253 and 546 to 435 kg m^?3, respectively, whereas the corresponding porosity also decreased from 49.08% to 41.84%. As the moisture content increased from 7.97% to 23.33% d.b., crushing strength was decreased from 275 to 79 N, whereas the angle of repose and surface areas were found to increase from 36.41° to 41.72° and 1815.73 to 1917.59 mm², respectively. The static coefficient of friction of jatropha fruit increased linearly against the surfaces of three structural materials, namely plywood (47.81%), mild steel (62.88%) and aluminium (34.82%) as the moisture content increased from 7.97% to 23.33% d.b.     

Influence of noncellulosic contents on nano scale refinement of waste jute fibers for reinforcement in polylactic acid films

In the present study, nanofibrils of cellulose are extracted from waste jute fibers using high energy planetary ball milling process in wet condition. The rate of refinement of untreated fibers having non-cellulosic contents was found slower than treated fibers due to strong holding of fiber bundles by non-cellulosic contents. At the end of three hours of wet milling, untreated fibers were refined to the size of 850 nm and treated fibers were refined to the size of 443 nm. In the subsequent stage, composite films of poly lactic acid (PLA) were prepared by solvent casting with 3 wt% loading of untreated jute nanofibrils, treated jute nanofibrils and microcrystalline cellulose. The influence of non-cellulosic contents on mechanical properties of PLA films are investigated based on results of tensile test, dynamic mechanical analysis and differential scanning calorimetry. The maximum improvement was observed in case of treated jute nanofibril/PLA composite film where initial modulus and tensile strength increased by 207.69 % and 168.67 %, respectively as compared to neat PLA film. These improvements are attributed to the increased interaction of treated jute nanofibrils with PLA matrix due to their higher precentage of cellulosic contents and mechanically activated surface.     

Comparison of serological tests forBrucella melitensis infection in sheep

Summary A comparative study of the standard tube agglutination test (SAT), Rose Bengal plate agglutination test and counter immuno-electrophoresis (CIEP) was made on 647 sera from naturally aborting ewes, orchitic, in-contact and apparently healthy sheep with no history of vaccination against brucellosis. No individual test could detect all the 13 known positive reactors (the foetuses of which yieldedBrucella melitensis) but by combination of two tests all 13 were positive. The SAT detected more reactors during the early stage of infection while CIEP performed better in later stages of infection. All these tests may be carried out in a field laboratory at very low cost.

---

Resumen Se llevó a cabo un estudio donde se comparó la efectividad de la aglutinación en tubo, la prueba Rosa de Bengala y la contrainmunoelectroforesis en 647 sueros de ovejas que habían abortado naturalmente, machos con orquitis, ovejas en contacto y ovejas aparentemente sanas, sin previa historia de vacunación contra brucelosis. Ninguna de las pruebas utilizadas pudo detectar individualmente todos los 13 reactores positivos (de los fetos de los cuales se aislóBrucella melitensis), pero la combinación de dos pruebas detectó todos los reactores positivos. La prueba de la aglutinación en tubo detectó la mayoría de reactores en los estadíos iniciales de la infección, mientras que la contrainmunoelectroforesis se comportó bien en estadíos iniciales de la infección, mientras que la contrainmunoelectroforesis se comportó bien en estadíos tartíos de la infección. Todas estas pruebas pueden realizarse, en laboratorios de campo a un costo bajo.

---

Résumé Les auteurs ont réalisé une étude comparative entre l'agglutination en tube standard (SAT), le test d'agglutination sur lame au Rose Bengale (RBPT) et la contre immunoélectrophorèse (CIEP), à partir de 647 sérums prélevés sur des brebis ayant avorté naturellement ou sur des moutons atteints d'orchite ou ayant été en contact mais restés apparement sains et sans passé vaccinal contre la brucellose. Aucun test individuel n'a pu reconna?tre comme positif l'un des 13 animaux reconnus réagissant (dont les foetus hébergeaientBrucella melitensis), mais par combinaison des deux tests, tous les 13 se sont révélés positifs. Le SAT a décelé plus de réagissants au cours des premiers stades de l'infection. Par contre, le CIEP a été plus sensible dans les derniers stades. Tous ces tests peuvent être réalisés dans un laboratoire de terrain à, un co?t trés bas.