High-performance solid Acid fuel cells through humidity stabilization

Although they hold the promise of clean energy, state-of-the-art fuel cells based on polymer electrolyte membrane fuel cells are inoperable above 100 degrees C, require cumbersome humidification systems, and suffer from fuel permeation. These difficulties all arise from the hydrated nature of the electrolyte. In contrast, "solid acids" exhibit anhydrous proton transport and high-temperature stability. We demonstrate continuous, stable power generation for both H2/O2 and direct methanol fuel cells operated at approximately 250 degrees C using a humidity-stabilized solid acid CsH2PO4 electrolyte.     

Optothermistor as a breakthrough in the quantification of lycopene content of thermally processed tomato-based foods: verification versus absorption spectrophotometry and high-performance liquid chromatography

This study reports on the first use of the "optothermistor" as a novel, precise, fast, and low-cost detector of lycopene in a wide range of commercially available processed-tomato products. The quantitative performance of the new device was evaluated by comparing data obtained to that acquired by conventional methods, namely, absorption spectrophotometry and high-performance liquid chromatography (HPLC); the linear correlation was high (R = 0.98). The variation of data obtained with the optothermistor in a series of consecutive measurements performed with the same loading of the sample was better than 1%. However, the repeatability (RSD 0.5-9.0%, n = 3-5) achieved with the optothermistor by independent analyses (multiple loading) is comparable to that of HPLC and spectrophotometry. Results of the studies performed on the 19 products derived from tomatoes demonstrated that the optothermistor is suitable for selective, accurate, precise, and simple determination of lycopene (range = 7-75 mg/100 g of product weight) without the need for a sample pretreatment step. The estimated sensitivity of the present optothermistor is 2 mg of lycopene/100 g of product.     

Plasma endotoxin concentration in horses: a methods study

Background: Accurate determination of plasma endotoxin concentration is critical for ex vivo and in vitro cellular and molecular studies of endotoxemia in horses. However, reports are conflicting with respect to anticoagulant, handling, and sample preparation.

Objective:

Objective: The purpose of this study was to determine the effect of blood sample fraction and handling time on measurement of endotoxin concentration in horses.

Methods:

Methods: Whole blood, anticoagulated with 3.8% (0.12 M) sodium citrate (9:1), was collected from 5 healthy horses. Whole blood (WB), platelet-rich plasma (PRP), and platelet-poor plasma (PPP) were spiked with endotoxin (2 EU/mL). Endotoxin-spiked WB samples were centrifuged immediately to generate PRP for measurement. Endotoxin concentration was subsequently measured by Limulus amebocyte assay at 0, 15, 30, 45, and 60 minutes. Assays were performed in triplicate and results were analyzed using Student's t -test, with significance set at P < .05.

Results:

Results: Mean endotoxin concentrations in 2 EU/mL-spiked WB were significantly different from those in PPP at all time points tested. Recovery of endotoxin in PRP generated from WB was significantly diminished after just 15 minutes.

Conclusion:

Conclusion: PRP generated from WB is significantly more reliable than PPP in determining endotoxin concentration ex vivo. Measurement of endotoxin in PRP generated from WB was significantly diminished after 15 min, identifying a time frame within which to process blood samples for endotoxin analysis.     

Cytokine responses to EHV-1 infection in immune and non-immune ponies

Protecting equids against equine herpesvirus-1 (EHV-1) infection remains an elusive goal. Repeated infection with EHV-1 leads to protective immunity against clinical respiratory disease, and a study was conducted to measure the regulatory cytokine response (IFN-gamma and IL-4) in repeatedly infected immune ponies compared to non-immune ponies. Two groups of four ponies were established. Group 1 ponies had previously been infected on two occasions, and most recently 7 months before this study. Group 2 ponies had no history no vaccination or challenge infection prior to this study. Both groups were subjected to an intranasal challenge infection with EHV-1, and blood samples were collected pre-infection, and at 7 and 21 days post-infection for preparation of PBMCs. At each time point, the in vitro responses of PBMCs to stimulation with EHV-1 were measured, including IFN-gamma and IL-4 mRNA production, and lymphoproliferation. Group 1 ponies showed no signs of clinical disease or viral shedding after challenge infection. Group 2 ponies experienced a biphasic pyrexia, mucopurulent nasal discharge, and nasal shedding of virus after infection. Group 1 ponies had an immune response characterized both before and subsequent to challenge infection by an IFN-gamma response to EHV-1 in the absence of an IL-4 response, and demonstrated increased EHV-1-specific lymphoproliferation post-infection. Group 2 ponies had limited cytokine or lymphoproliferative responses to EHV-1 pre-challenge, and demonstrated increases in both IFN-gamma and IL-4 responses post-challenge, but without any lymphoproliferative response. Protective immunity to EHV-1 infection was therefore characterized by a polarized IFN-gamma dependent immunoregulatory cytokine response.     

Use of Biosolids for Phytocapping of Landfill Soil

Conventional clay capping for post-closure management of landfill commonly cracks and deteriorates over time. As a consequence, water ingress into waste increases as a function of time, potentially causing a range of environmental issues. An alternative approach is known as phytocapping, which utilizes select plant species to control cap stability and moisture percolation. In this study, growth of Arundo donax L. (giant reed), Brassica juncea (L.) Czern. (Indian mustard), and Helianthus annuus L. (sunflower) on a landfill site was studied with different biosolid amendment rates (0, 25, and 50?Mg?ha^?1). Cultivation of the landfill cap and amendment with biosolids significantly improved the characteristics of the soil. Growth of each plant species increased due to biosolid addition. Giant reed produced the largest biomass in the 50?Mg?ha^?1 biosolid amendment rate (38?Mg?ha^?1 dry weight). The high pH and clay content of landfill cap soil, and the low metal concentrations of the biosolid resulted in low heavy metal (copper, zinc, cadmium, and lead) accumulation in leaves of most treatments. The improvement in growth and limited uptake of metal contaminants to plant shoots indicated that biosolid application to landfill clay caps improves the application of phytocapping of old landfill sites.     

Influence of soil physicochemical properties, particle size fractions and mineralogy on the leaching potentials of arsenic and antimony in abandoned mine soils

At abandoned mine sites, arsenic (As)- and antimony (Sb)-enriched soils are often disposed of through onsite burial or capping. In highly weathered mine sites, the mobility of As and Sb is typically controlled by iron (Fe)(Ⅲ)/Fe(Ⅱ) phases; thus, the suitability of such disposal methods and appropriate testing techniques are questionable. In the present study, leaching potentials of As and Sb were examined using the toxicity characteristic leaching procedure (TCLP), waste extraction test (WET), and WET-extended procedure (WET-EXT) at three abandoned mine site soils in Australia. The leached concentration of As regularly exceeded USEPA criteria (5 mg L^-1). The highest leached concentrations of As and Sb were observed in the finest particle size fraction (< 0.053 mm) by WET-EXT (1 040 mg L^-1 for As and 21.10 mg L^-1 for Sb) followed by WET (800 mg L^-1 for As and 20.90 mg L^-1 for Sb). The TCLP method resulted in the lowest concentrations of leached As (0.000 9 mg L^-1) and Sb (0.000 3 mg L^-1). Crystalline and amorphous As-bearing Fe oxides were the main phases in the soils studied. However, the best correlations of leached As determined by TCLP (0.832), WET (0.944), and WET-EXT (0.961) were found with the non-specifically sorbed (NS1) As fraction. The mineralogical and sequential extraction data clearly indicate the dominant role of Fe geochemistry in controlling leachability of As and Sb. The TCLP method was unlikely to be suitable for assessing leachability, as it exhibited no relationship with leachable Fe and substantially lower leached As and Sb than the other two methods. Given the high to extremely high leachable As and Sb concentrations, most of the soil samples would not be recommended for placement in capping works, old shafts, or reduction systems (e.g., collection in drainage basins).