Practical use of response surface methodology for optimization of veterinary antibiotic removal using UV/H2O2 process

Three of the most commonly used veterinary antibiotics—enrofloxacin (ENR), sulfamethoxazole (SMX), and oxytetracycline (OTC)—were chosen as representative antibiotics for UV/H₂O₂ treatments. The objective was to determine the optimization of UV/H₂O₂ to remove antibiotics from aquaculture discharge water using response surface methodology. The degradation of the antibiotics was investigated under varying UV/H₂O₂ conditions in environments with different levels of pH, water matrices, humic acid, and constituent ions. The degradation results demonstrated that increasing the H₂O₂ dosage facilitated ENR degradation at a neutral pH while facilitating degradation of SMX and OTC at a slightly acidic pH. The optimum removal conditions for ENR, which was used in all influential effect experiments and the contact tank experiments, was obtained at 10 mM H₂O₂, a pretreated COD of 87.51 mg L⁻¹, and an initial pH of 6.15. Among the tested anions, only the presence of Cl^- showed slight positive effects on ENR degradation, due to the generation of secondary active radicals. During the reaction, the hydroxyl radical (OH) was present at a higher pH while singlet oxygen (¹O₂) was slightly present at a lower pH. The experimental results from H₂O₂ sequential addition indicated that freshly added H₂O₂ could quench the recently generated OH and therefore a high H₂O₂ concentration with frequent adding was not necessary. Our contact system reduced the ENR concentration in both the effluent reservoir and in the UV irradiation zone. The overall results supported the use of the UV/H₂O₂ system to treat remnant antibiotics in the discharge water.     

响应面法优化沙棘再制奶酪加工工艺

本试验以新鲜沙棘果及奶酪为主要原料,探讨了沙棘再制奶酪的加工工艺。首先经护色、打浆、精磨、过滤、调酸、均质等工序,制备澄清均一的沙棘果汁。以样品感官品质和Vc含量为评价指标,通过单因素试验以及响应面试验,得出最佳配方及工艺为：35.00%天然奶酪、18.56%沙棘果汁（料水质量比1∶1）、1.54%复合乳化盐（m_柠檬酸钠∶m_{多聚磷酸钠}∶m_焦磷酸钠∶m_{六偏磷酸钠}=4∶2∶2∶1）、12.00%黄油、6.00%脱脂乳粉、6.00%白砂糖、0.50%复合稳定剂（m_卡拉胶∶m_黄原胶=4∶1）,其余20.40%为纯净水,乳化温度为84 ℃,乳化时间为11.4 min,搅拌速度为3 000 r/min。经此工艺制成的成品,感官评分为57.5分（满分60分）,Vc含量达16.61 mg/100 g。成品组织结构细腻光滑、色泽橘黄、口感润滑、营养丰富,具有沙棘果的风味,符合《GB25192—2010 再制奶酪》要求。     

杂交构树叶多酚提取工艺优化及其抗氧化活性研究

为建立和优化杂交构树叶多酚的提取工艺,本试验采用超声波辅助提取的方法,以构树叶多酚得率为考察指标,通过单因素试验研究液料比、乙醇浓度、超声时间、超声温度4个因素对构树叶多酚得率的影响;在单因素试验的基础上,借助响应面法设计4因素3水平的试验方案,对构树叶多酚提取的工艺参数进行优化,建立回归模型并进行响应面分析,最终确定最佳的提取工艺参数,并进行3次平行验证;以维生素C为对照,通过测定构树叶多酚对DPPH和ABTS自由基的清除率,评价构树叶多酚的体外抗氧化活性。结果显示：4个因素对构树叶多酚得率的影响顺序依次为：乙醇浓度（B） > 液料比（A） > 超声温度（D） > 超声时间（C）,响应面分析结果显示：两两因素之间存在交互作用,但交互作用不显著（P>0.05）;在液料比为70：1、乙醇浓度为60%、超声时间为50 min、超声温度50 ℃的条件下,构树叶多酚的得率最大,为13.62 mg/g,与响应面法的预测值接近;体外抗氧化试验结果表明,构树叶多酚可以清除DPPH和ABTS自由基,并且在高浓度情况下可以达到与维生素C相当的水平。综上,试验建立的构树叶多酚提取工艺准确、可行,同时证明构树叶多酚具有良好的抗氧化活性;该结果可为构树叶多酚的生物活性研究以及构树叶的药用价值开发提供参考。     

绵羊(ATAG)n四碱基微卫星位点的筛选及其在亲子鉴定中的应用

本试验旨在筛选绵羊高度多态性四碱基微卫星遗传标记,建立适用于绵羊亲子关系鉴定的实验体系。试验以小尾寒羊为主要研究对象,从已有的绵羊参考基因组序列出发,基于全基因组序列筛选法共筛选出53个（ATAG）_n四碱基重复微卫星位点,然后通过基因分型数据共筛选出30个扩增效果好、多态信息含量（PIC）丰富的四碱基重复微卫星位点;30个位点的基因分型结果表明,共扩增出253个等位基因,平均等位基因数为8.433,等位基因数均>5,多态信息含量在0.566~0.898,观测杂合度（Ho）范围在0.548~0.903,期望杂合度（He）范围在0.631~0.921,平均期望杂合度为0.776;哈代-温伯格平衡检验30个位点均处于遗传平衡状态。随后根据PCR的扩增效率从获得的30个多态性位点中筛选出22个微卫星位点用于亲权排除概率的计算,根据多态信息含量的大小由高到低依次增加位点数进行组合。结果表明,在两个亲本的基因型均未知的情况下,标记位点数为15个时,累积排除概率可达到99.99%,其中单个位点的第一非亲排除率（non-exclusion probability of the first parent,NE-1P）介于0.321~0.663之间。利用建立的亲子鉴定体系对16只具有系谱记录的小尾寒羊样本进行检测,结果共鉴定出4个具有高置信度的绵羊家系,鉴定结果与系谱记录完全一致。本试验为绵羊分子系谱的构建、亲子鉴定以及保障绵羊育种工作的正常开展奠定重要基础。     

松辽黑猪OAS1基因多态性及其与繁殖性状的关联分析

为探究寡腺苷酸合成酶1（oligoadenylate synthase 1,OAS1）基因多态性与松辽黑猪繁殖性状的关联性,试验选取130头松辽黑猪母猪为研究对象,利用Sanger直接测序法测序查找OAS1基因外显子1~8的SNP位点,使用SPSS 19.0软件分析OAS1基因SNP位点与松辽黑猪繁殖性状的关联性。结果显示,在松辽黑猪OAS1基因外显子2、3和6上共检测到33个突变位点;其中在外显子2的110 bp处存在1个SNP位点（G110C）,存在3种基因型：GG、GC和CC;在外显子3的176 bp处存在1个SNP位点（C176T）,存在3种基因型：CC、CT和TT;在外显子6的145 bp处存在1个SNP位点（C145T）,存在3种基因型：CC、CA和AA;在166 bp处存在1个SNP位点（G166A）,存在3种基因型：GG、GA和AA;在206 bp处存在1个SNP位点（A206G）,存在3种基因型：AA、AG和GG。卡方适合性检验结果显示,松辽黑猪OAS1基因G110C突变位点符合Hardy-Weinberg平衡状态,C176T、C145A、G166A和G206A位点均偏离Hardy-Weinberg平衡状态。群体遗传参数分析结果显示,各SNPs位点遗传杂合度均位于中等水平,为中度多态（0.25<PIC<0.5）。关联分析结果发现,G110C位点GC基因型个体总产仔数、产活仔数和断奶仔猪数均显著高于GG基因型个体（P<0.05）;C176T位点CT基因型个体断奶仔猪数显著高于CC基因型个体（P<0.05）;C145T位点CC基因型个体总产仔数和产活仔数均显著高于AA基因型个体（P<0.05）;G166A位点GA基因型个体断奶仔猪数显著高于GG基因型个体（P<0.05）;A206G位点GG基因型个体总产仔数和产活仔数显著高于AA基因型个体（P<0.05）。结果表明,OAS1基因外显子区存在突变位点,对松辽黑猪部分繁殖性状有显著性影响。     

灰铸铁生产技术的一些新进展

对灰铸铁的研究现状和生产中的一些新技术做了评述。重点介绍了高强度薄壁灰铸铁的生产现状以及先进的制造工艺和先进的制造手段在灰铸铁生产中应用所取得的技术成果。     

Construction and Identification of Yeast Surface Display Libraries of Ovis aries DRA Gene Exon 2

The specific primers were designed according to Ovis aries DRA gene sequence deposited in GenBank and the multiple cloning site of the plasmid pYD1,which was a vector used for protein surface display on Saccharomyces cerevisiae.The gene encoding DRA was amplified by PCR using the genomic RNA of Ovis aries.The 762 bp fragment was cloned and released in GenBank and registration number was KR422362.The PCR product was inserted into the yeast surface display plasmid vector pYD1 by double enzyme digestion.It was indicated that DRA gene was successfully integrated into the genome.Dot mutation was made at both ends of exon 2 in DRA gene for making restriction enzyme cutting site and design the exon 2 specific primers according to mutated Ovis aries DRA gene sequence.Sequenced exon 2 amplification products based on DNA pooling of sheep large sample template was analyzed the polymorphic loci.The polymorphic exon 2 246 bp fragment was obtained by double enzyme digestion and connected to surface display restructuring mutation carriers pYD1-DRA by the same double enzyme digestion,and then we successfully constructed yeast surface display libraries.We transformed it into Saccharomyces cerevisiae EBY100 cell.Yeast monoclone was identified by PCR amplification and sequencing,and we confirmed that DRA gene had been integrated into Saccharomyces cerevisiae genome.After galactose induced,it was detected that DRA gene library had been successfully demonstrated on the yeast cell surface under the fluorescence microscope by immunofluorescence method.     

响应面法优化杜仲叶提取物的制备工艺

优化杜仲叶提取物制备的工艺条件,在单因素试验基础上,以杜仲叶提取物浸膏得率和绿原酸转移率为评价指标,采用Box-Behnken中心组合设计法优化杜仲叶提取物制备的工艺条件。杜仲叶提取物制备的最佳工艺条件为乙醇浓度500mL/L,液料比10∶1(mL/g),提取温度97℃,提取4次,每次30min;在此最佳工艺条件下,杜仲叶提取物浸膏得率和绿原酸转移率综合评分均值为99.08,与预测值基本一致。响应面法(RSM)优化的杜仲叶提取物制备工艺稳定可靠。