二氧化碳基塑料降解性能的研究

[目的]研究二氧化碳基塑料的降解性能.[方法]以PPC为原料,通过生物降解、热氧化降解和光降解研究了PPC的降解性能.利用乌式粘度计测定了降解过程中PPC塑料的分子量变化;利用傅里叶变换红外光谱仪表征了降解过程中PPC的红外光谱特性.[结果]PPC薄膜在27℃恒温培养箱中生物降解15 d后,降解效果明显.180℃热氧化降解36 h,PPC塑料的分子量减少了63％.光氧化降解5d后,PPC塑料的分子量减少了约85％.[结论]与生物降解相比,PPC塑料的热氧化和光降解程度更为明显.     

Current Status of DIMOX in Synthesizing Al/Al2O3 by Aluminum Alloy

The processes, microstructures, properties and mechanisms of DIMOX in synthesizing Al/Al 2O 3 by Al-Mg-Si alloy are reviewed and their problems are considered mainly as following:non_homogeneous oxidation growth of Al/Al 2O 3 at the surface of melts and the porosity of Al/Al 2O 3 limites structural application of Al/Al 2O 3 composite. The mechanisms and models of microchannel,magnesium action,silicon action,and induction are outlined. Several problems which need to be noticed are pointed out,which are diffusion and transfer of oxygen in aluminium melts;the role of MgO and MgAl 2O 4 at outer layer;the reaction feature of solid_gas in the oxidation microstructures of Al_Mg_Si alloy;SiO 2 induction mechanism of silicon and its correlation with the mechanism of magnesium action in Al_Mg_Si alloy.     

Pinning Theory of Fermi Energy and Surface State Measurement of ZnSnO3 Gas Sensitive Material

In order to research the state of energy bands and gain and loss of electrons on the surface of ZnSnO_(3),it is put forward that Pinning theory of Fermi energy is applied to development of gas sensitive materials.The relative position between surface state and conduction band on surface of zinc tin complex oxide(ZnSnO_(3)) gas sensitive material has been investigated by utilizing oxidation redox couple,FeCl_(2)/ FeCl_(3),which have high surface state.Fermi energy is pinned at about 0.2 eV below conduction band E_(cs)on the surface of ZnSnO_(3).It has been determined that additives doping ratio,addition concentration and working atmosphere have no effect on this value.Therefore,pinning theory of Fermi energy has been verified by using this method.     

Studies on the Oxidation of Weathered Coal with Nitric Acid

A raseach has been done on the possibility of producing nitriochumic acid fromweathered coal of Nantong,Sichuan,oxidised by nithic acid.The optimun reacting conditions,whichare found through the way of orthogonal experiment,are suggested as follows:concentration ofHON3 35%,rate of HON3 to coal 3.5,reacting take 15 min,and reaction temperature 369 K. Thecomposition of product is Wf 2. 91 %;Ag 14.06%;HAg 78.28%;Ng 1.62%.     

CO2-O2混合喷吹对铁液中C、V元素氧化的影响

为了验证用CO2替代部分O2进行转炉氧化提钒的可行性,在实验室进行了CO2-O2混合喷吹提钒模拟实验。结果显示C的氧化量与C的氧化速率随CO2含量的增加而升高;V的氧化量随CO2含量的增加而降低,其中CO2含量为20%与纯O2对C、V的氧化量接近;纯O2喷吹时C的氧化量为34.56%,V的氧化量为96.85%;CO2含量为20%混合气体喷吹时C的氧化量为36.83%,V的氧化量为93.29%;以V的相对氧化量与C的相对氧化量的比值(ΔV/ΔC)来衡量提钒保碳能力,CO2含量为20%的最终ΔV/ΔC为5.96,CO2含量,40%、60%、80%的最终ΔV/ΔC均小于3.8;反应前期,V的氧化速率随CO2含量的增加而升高,反应后期V的氧化速率随CO2含量的增加而降低。     

高氨氮厌氧消化液后处理技术研究

采用SBR-絮凝沉淀-Fenton氧化-活性炭吸附组合工艺对高氨氮厌氧消化液的后处理进行实验研究.结果表明,当进水COD浓度为4516 mg·L^-1时,SBR出水COD可降为1752 mg·L^-1,去除率达到61.2%;絮凝沉淀出水COD浓度为1189 mg·L^-1,去除率为32.1%;Fenton氧化和活性炭吸附出水COD浓度分别为452和216 mg·L^-1,去除率分别为61.7%和52.7%.当进水NH3-N浓度2162 mg·L^-1时,SBR出水NH3-N浓度降至13.8 mg·L^-1,去除率为99.4%,NH3-N主要在该段去除.整个组合工艺对COD和NH3-N的去除率分别达到95.2%和99.9%,达到了很好的有机物和氨氮去除效果,在技术上是可行的.     

厌氧生物水处理技术研究进展

在原有脱碳技术基础上,废水厌氧处理在其他领域的研究与应用被不断拓展.本文介绍了近年来厌氧生物处理技术的新发展,从理论和工艺两个方面,综述了厌氧生物脱硫、生物制氢、厌氧氨氧化、厌氧反硝化的原理、研究、技术开发与应用.     

厌氧氨氧化工艺在废水脱氮领域中的应用进展

厌氧氨氧化是一种全新的生物脱氮工艺。对于处理低碳氮比废水,与传统方法相比,它具有节省氧耗、无需外加有机碳源、污泥产量低等优点。近年来,随着基础研究的逐渐深入,各国学者开始将研究视角转向厌氧氨氧化工艺的实际应用。本文对该工艺在消化污泥上清液、垃圾渗滤液等实际废水脱氮研究中的进展进行了综述,并指出了目前存在的问题和今后的研究方向。