混料设计及响应面法优化大黄药渣固态发酵生产漆酶的工艺

通过优化大黄药渣固体培养基的组成及发酵条件,以期最大程度提高发酵生产漆酶的活力。采用D-最优混料设计对固体培养基碳源组成进行优化,优化后得到的固体培养基组成为:小麦麸皮47.2%,大黄药渣47.2%,葡萄糖1.6%,蛋白胨2.5%,氯化钙0.48%,磷酸二氢钾0.5%,硫酸铜0.02%,硫酸镁0.5%。通过中心组合设计响应面试验建立二次回归模型对固态发酵条件进行优化,确定最优发酵条件为发酵初始pH 4.3,发酵温度32.5℃,固液质量体积比1.47∶1,发酵时间7.5 d。在此条件下,发酵生产的漆酶酶活为7 602.1 IU/mL,与模型预测值相对误差在0.6%。     

高效液相色谱法测定花生仁中甲咪唑烟酸残留

目前花生仁中甲咪唑烟酸残留量的检测是参考国标中茶叶农残的方法,花生仁基质含有大量的油脂和蛋白质,这与茶叶基质有显著区别,且该方法只能定性。本文建立了一种高效液相色谱法定量检测花生仁中甲咪唑烟酸残留量的方法。花生仁样品采用乙腈溶液提取后再经过除脂净化处理,以乙腈:0.02mol/L磷酸二氢钾缓冲液(加入0.1%的三乙胺,磷酸调pH3.0)体积比1:3作为流动相进行高效液相色谱紫外检测器分析。结果表明:甲咪唑烟酸标准在0~1.2mg/L范围内线性关系良好(R2=0.9999),检出限为7μg/kg;加标回收率为91.1%~98.9%;精密度、重复性、稳定性都较好。该方法操作简便、分离度好、结果准确,能很好地满足花生仁中甲咪唑烟酸残留量检测的要求。     

茶叶中高氯酸盐检测方法研究进展

高氯酸盐是一种持久的化学污染物,近年来在出口茶叶中被频繁检测出来,逐渐成为影响我国茶叶出口的因素之一。检测茶叶中的高氯酸盐对我国茶产业的发展具有重要意义,本文主要介绍了茶叶中高氯酸盐残留检测的背景及现状,总结了茶叶中高氯酸盐的检测方法,为高氯酸盐的研究以及茶叶中高氯酸盐标准检测方法的制定提供依据。     

基于阵列芯片现场高灵敏同步快速检测粮油中氨基甲酸酯类农药残留混合污染

The quality and safety of agricultural products is the technique focus of the strategy of rural vitaliza⁃tion. Carbamate pesticide residues are seriously threatening the safety of agricultural product and human life and health. Nowadays, the common detection methods are instrument-based for carbamate pesticide residue, which dis⁃ satisfy the request of an on-site rapid, sensitive and simultaneous detection for multiple carbamate pesticide resi⁃ dues. Based on the home-made monoclonal antibodies against carbofuran and carbaryl respectivity, a microarray for rapid and simultaneous detection of multiple carbamate pesticide residues was developed within 30 min. Under the optimized conditions, the limits of detection（LODs）were found to be 0.11 and 0.09 ng/g, while the linear ranges were 0.33-3000 and 0.18-1500 ng/g for carbofuran and carbaryl respectively. By using spiked peanut samples, it recorded recoveries of 88.4%-98.3%, 90.1%-118.8% for carbofuran and carbaryl respectively. The RSD of intraarray were found at 9.0%, 3.5%, while the RSD of inter-array were recorded at 12.3%, 16.3% respectively. The de⁃ tection results of the microarray were highly consistent with that of HPLC-MS/MS. This proposed microarray provid⁃ ed an on-site high-sensitivity, simultaneous and rapid detection of carbofuran and carbaryl, and could be widely used in the fields of agricultural product quality safety, food safety and environmental monitoring.     

诺氟沙星在草鱼体内的残留规律研究

研究了多剂量混饲口灌给药方式下,诺氟沙星在草鱼体内的残留消除情况。结果显示：以每千克鱼体重10 mg连续5d混饲给药后,停药后第12天在草鱼肌肉中未检测到药物,此时血清、肝脏和肾脏中的药物浓度分别降为（0.0287±0.0015）μg/mL、（0.0181±0.0042）μg/g和（0.0369±0.0037）μg/g,均低于0.05μg/mL或0.05μg/g。因此初步建议在（19±1）℃水温条件下,以每千克鱼体重10 mg连续5 d混饲给草鱼诺氟沙星,休药期至少为最后一次给药后的12 d。     

磺胺甲基异噁唑在中国明对虾体内的残留和消除规律

在(20±2)℃水温条件下,研究磺胺甲基异唑在中国明对虾肌肉、血淋巴和肝胰脏3种组织中的残留及消除规律。药物在对虾肌肉、血淋巴、肝胰脏中的残留用二氯甲烷提取,反相高效液相色谱法检测,最低检测限可达0.01μg/mL,平均回收率为80%~90%。研究结果表明:磺胺甲基异唑在中国明对虾血淋巴中的残留量最小,在肝胰脏中的残留量最大且消除较慢,差异明显。建议把对虾的肝胰脏作为该药残留监控的靶组织,相应的休药期至少为20 d。     

超高效液相色谱-串联质谱法测定凡纳滨对虾中的硝基呋喃代谢物残留

采用超高效液相色谱-串联质谱（UPLC-MS/MS）法,测定了凡纳滨对虾（Litopenaeus vannam ei）中氨基脲（SEM）、1-氨基-2-内酰脲（AHD）、3-氨基-2-唑烷基酮（AOZ）和5-甲基吗啉-3-氨基-2-唑烷基酮（AMOZ）4种硝基呋喃类代谢物。采用2-硝基苯甲醛作为衍生化试剂,氘、碳-13、氮-15同位素标记的SEM1-3C1-5N2、AHD1-3C3、AOZ-D4和AMOZ-D5为内标物,样品经衍生、乙酸乙酯提取、正己烷净化,以甲醇0.5 mmol.L-1乙酸铵水溶液（含0.1%甲酸）为流动相进行梯度洗脱,8 m in可将4种目标化合物完全分离并测定。结果表明,4种待测物在0.4～20.0 ng.mL-1范围内线性关系良好（R〉0.999）,检出限为0.03～0.15μg.kg-1。在0.5μg.kg-1、1.0μg.kg-1和2.0μg.kg-13个水平上进行加标回收试验,平均回收率为92.0%～107.3%,RSD为3.1%～8.7%。采用该法参加FAPAS国际水平测试,获得了满意的结果。     

水产品等食品中磺胺类抗生素残留分析与预处理方法的研究进展

对水产品等食品中磺胺类抗生素常用的分析方法和预处理方法进行了综述,归纳和比较了毛细管电泳法、微生物方法、液相色谱-质谱法、免疫法、气相色谱法、分光光度法、高效液相色谱法等特点。其中高效液相色谱法由于操作简便、快速、灵敏、准确的特点,是当前检测磺胺类抗生素的主要方法。同时,对包括固相萃取、分子印迹等预处理方法进行了综述。     

甘草渣中碱木质素的提取工艺研究

采用一般碱法从甘草渣中提取木质素,以水浴温度、恒温时间、碱液用量、碱液浓度为因素,进行正交试验,确定了其最佳提取工艺条件为:水浴温度40℃、恒温时间2.5h、碱液浓度0.8mol/L、碱液用量30 mL/g,木质素的提取率为4.88％.碱木质素的总羟基、酚羟基和醇羟基含量分别为5.43％、3.18％、2.43％.     

Cost structure of and competition for forest-based biomass

Abstract

Biomass has become a popular alternative to satisfy expanding energy demand and as a substitute for fossil fuels and phased-out nuclear energy in Europe. The European Union White Paper stipulates that the utilization of biomass shall increase to 1566 TWh by 2010. However it is often overlooked that the forest resources are already, to a large extent, used by the forest industries. When promoting biomass for energy generation the consequences for the forest industries also need to be considered. Sweden is an excellent case study, as there are vast quantities of forest resources, nuclear power is starting to be phased out, there are restrictions on expanding hydropower and the political desire exists to “set an example” with respect to carbon dioxide emissions. This paper attempts to estimate and analyse the supply of two types of forest resource, namely, roundwood and harvesting residues derived from final harvesting and commercial thinnings. Two separate supply curves are estimated: one for roundwood and one for harvesting residues. The cost structure is based on an economic-engineering approach where the separate cost components are constructed from the lowest cost element into aggregates for labour, capital, materials and overhead costs for each forest resource. The results indicate an unutilized economic supply of 12 TWh of harvesting residues in Sweden. However, after these 12 TWh have been recovered it becomes more profitable to use roundwood for energy purposes than to continue extracting further amounts of harvesting residues.