吉林省西部地区滴灌条件下宜机械粒收玉米品种筛选

确定宜机械粒收的玉米品种是构建吉林省西部旱作补灌区玉米丰产增效技术模式的重要内容之一。2018年和2019年在吉林省西部地区开展滴灌条件下宜机械粒收玉米品种的筛选试验,测定38个玉米品种的收获子粒含水率和产量,并按玉米子粒含水率和产量水平采用双向平均法作图进行品种分类。结果表明,本研究初步筛选出5个滴灌条件下宜机械粒收玉米品种,分别是迪卡159、福莱77,稷秾108、吉农大889和优迪919。根据品种综合性状分析,吉农大889较优,其次为迪卡159,可以作为适宜吉林省西部滴灌条件下丰产高效栽培的推荐品种。     

玉米脱粒破碎率关键影响因子及其最优预测模型研究

子粒破碎率高是当前中国玉米机械收获子粒的重要限制因素,解析破碎率变化原因,建立其简便预测模型是需要解决的重要问题。本文采集7个玉米品种在3个种植密度下组合的果穗,在不同子粒含水率梯度条件下开展单穗脱粒试验。种植密度在6万～9万株/hm2范围内对子粒破碎率没有影响,品种、子粒的含水率、抗侧压碎力和穿刺强度等的影响均达到统计显著水平。品种对破碎率变化的偏贡献率为12.7%,且品种的偏贡献率子粒含水率的偏贡献率抗侧压碎力的偏贡献率穿刺强度的偏贡献率,种植密度的偏贡献率接近于零。破碎率的最优预测因子是穿刺强度,预测模型:破碎率=10.25×0.990穿刺强度,满足破碎率不高于5%约束的穿刺强度值不得低于60 MPa。研究结果可为玉米破碎率预测、宜机收玉米新品种培育与鉴定、脱粒机具设计与制造提供数据支撑和技术参考。     

Influence of intra-row cruciferous surrogate weed growth on crop yield in organic spring cereals

In Northern Europe, inter-row hoeing has become a popular tactic for controlling weeds in organic cereals. Hoeing is highly effective and can be implemented from crop emergence until stem elongation to maintain a nearly weed-free inter-row zone. However, hoeing has a lesser effect on weeds growing in the intra-row zone, where crop–weed proximity results in heightened competition. In the hoed cereal system, it is investigated whether tall-growing, competitive, cruciferous weeds in the intra-row zone affect crop biomass, yield and thousand kernel weight (TKW). An additive experimental design is employed to enable the fitting of rectangular hyperbolas, describing and quantifying the effects of increasing intra-row surrogate weed density on crop growth parameters. Regressions were studied under the influence of crop (spring barley and spring wheat), row spacing (narrow [12.5 or 15.0 cm] and wide [25.0 cm]) and nitrogen rate (50 and 100 kg NH₄-N/ha). Cruciferous surrogate weeds were found to impact crop yield and quality severely. For example, ten intra-row plants/m² of surrogate weed Sinapis alba reduced grains yields by 7%–14% in spring barley and by 7%–32% in spring wheat with yield losses becoming markedly greater in wheat compared to barley as weed density increases. Compared to wheat, barley limited yield and quality losses and suppressed intra-row weed growth more. Row spacing did not have a consistent effect on crop or weed parameters; in one of six experiments, the 25 cm row spacing reduced yields and increased intra-row weed biomass in wheat. Nitrogen rate did not affect crop or weed parameters. Results warrant the implementation of additional tactics to control intra-row weeds and limit crop losses.     

基于Micro-CT的玉米籽粒显微表型特征研究

植物显微表型主要是指植物组织、细胞和亚细胞水平的表型信息,是植物表型组学研究的重要组成部分.针对传统籽粒显微性状检测方法效率低、误差大且指标单一等问题,本研究利用Micro-CT扫描技术对5种类型11个品种玉米籽粒开展显微表型精准鉴定研究.基于对CT序列图像的处理解析,共获取籽粒、胚、胚乳、空腔、皮下空腔、胚乳空腔和胚...     

南麂列岛贝藻生物的调查

本文通过实地调查研究并搜集有关资料后进行总结。结果表明:南麂列岛的贝藻种类非常丰富,共有贝类403种,藻类194种,分别占我国贝类、藻类总数的30％和20％。在保护区核心区,贝类的个体大小、种类和密度显著比其它非核心区大,说明保护区这几年的保护取得了很大的成绩。     

Crop structure in winter oats and the effect of nitrogen on quality-related characters

The relationship between panicle structure and oat grain quality characteristics was examined in a winter oat (Avena sativa) experiment, cv. Gerald, fertilized with 80 and 200 kg/ha N. Spikelets on each whorl were counted and separated into primary, secondary, and tertiary grains, which were counted and weighed, and the kernels extracted manually and weighed. Tiller and whorl rank had relatively small effects on weight per grain and kernel content. Nitrogen application significantly increased weight per primary and secondary grain on the main stem and T1, the first tiller, while spikelet and grain numbers increased only on T1. However, weight per grain and kernel contents in all whorls on both the main stem and T1 were not significantly affected by nitrogen. Although kernel contents were significantly affected by nitrogen application on some occasions, increases and decreases were less than 2.5%. Across the whole plant, numbers of primary and secondary grains increased at the higher nitrogen application, but weight per primary grain and kernel contents were unaffected. However, weight per secondary grain significantly increased at the higher nitrogen application, thus improving uniformity of grain size which is of value to millers.     

Agronomic Practices Influence Maize Grain Quality

Abstract

Maize grain yields have increased dramatically over the past fifty years, and concurrently end-uses have proliferated requiring special quality characteristics. Plant breeders have developed many specialty types of maize, all of which are influenced by the agronomic practices used to produce the crop. Grain yield increases have resulted in lower protein concentration except when the yield increase resulted from nitrogen fertilizer application. Irrigation improves the biological value of protein, while higher nitrogen application rates alter the amino acid balance thereby reducing the nutritional value. Kernel breakage susceptibility and kernel density increase with higher nitrogen fertilizer application rates, and are reduced by irrigation. Extractable starch and oil concentration are largely influenced by hybrid choice, but small production practice effects have been documented. Essential mineral nutrient levels are often influenced by soil or foliar fertilizer application. The production of aflatoxin can be reduced by irrigation or other strategies to avoid water stress during grain fill. Although genetics usually exerts the largest effect on maize grain quality, agronomic practices are also important.     

中国农业面源污染排放的空间差异及其动态演变

以2003—2014年为研究时段,在测算农业面源污染排放强度的基础上,综合运用基尼系数和非参数估计方法,研究我国农业面源污染的空间差异及其动态演变,结果表明:1)我国农业面源污染排放总体下降,且表现出明显的空间差异,东部和中部地区的排放强度较高,西部和东北地区则相对较低。2)2003—2014年,中国农业面源污染排放强度的区域差异略微扩大,地区间差异是其总体差异的主要来源。3)核密度估计结果表明,中国农业面源污染排放总体差异表现为"下降-上升-下降"的波动变化趋势。4)马尔科夫链分析表明,中国农业面源污染在不同类型间的相互流动较为微弱,但从长期来看,存在向两极分化发展的趋势特征。     

Enhanced kernel set promoted by synchronous pollination determines a tradeoff between kernel number and kernel weight in temperate maize hybrids

Maize (Zea mays L.) grain yield is strongly related to the number of harvested kernels, where kernel number can be increased by synchronously pollinating silks rather than allowing them to be progressively pollinated as they naturally appear from the husks. However, there is scarce evidence on how this practice affects kernel weight (KW) and plant grain yield (PGY), and no report exists on its effects when combined with treatments aimed to reduce apical dominance, like male sterility and detasseling. Field experiments were conducted in two growing seasons (Exp₁ and Exp₂) using two hybrids, cropped at contrasting stand densities (3 and 9 plants per m²) and including (i) male-fertile and male-sterile versions, (ii) tasseled and detasseled plants, and (iii) natural (NP) and synchronous pollination (SP; pollen added manually to ears bagged 5 days after initial silking) systems. Tassel growth of sterile and fertile versions was also evaluated in a separate experiment (Exp₃). Detasseling increased the number of ears per plant reaching silking (P < 0.001) of NP plants, but this beneficial effect of reduced apical dominance did not improve kernel number per plant (KNP) or PGY. Similarly, the early arrest of anther growth in male-sterile plants had no clear benefit on KNP. In contrast, KNP was enhanced by synchronous pollination (range between −13% and +71%; average of +15.4% in Exp₁ and +3.9% in Exp₂). However, this pollination system promoted a decreased in KW (range between −30% and +4%; average of −11.8% in Exp₁ and −7.8 in Exp₂) such that the treatment had no effect on PGY (range between −19% and +37%; average of +1% in Exp₁ and −4% in Exp₂). Because plant growth rate around flowering was not different between pollination treatments, assimilate availability per kernel was reduced from ovary fertilization onwards in synchronously pollinated plants when compared to open pollinated plants. This explains the reduced KW when increasing KNP by synchronous pollination. In summary, none of the imposed treatments allowed grain yield to be increased at the plant level.     

仿生敲击式山核桃破壳机的设计与试验

针对目前国内山核桃破壳机实用机型少,破壳率较低,果仁损伤率较高等情况,提出了一种仿生敲击(即模仿人工加工山核桃的方式)破壳方式,研制一款仿生敲击式山核桃破壳机。根据山核桃的物料特性以及破壳时所需的各项力学特性参数,建立了破壳机构设计的数学模型。确定了敲击臂的结构尺寸,优化了凸轮结构,并最终得到了凸轮的实际轮廓曲线。该文阐述了破壳机的总体结构与性能,建立了整机的三维实体模型,并根据建模制造了样机。该样机通过现场试验,结果表明:山核桃的含水率为14.55%~16.35%,大小为直径18~22 mm(沿缝合线方向)时,破壳率为99.41%,果仁损伤率为6.25%,生产率为94.93 kg/h,满足生产要求。该研究丰富与完善了坚果类果实的破壳机理与方法,为含隔坚果类的破壳机具设计与开发提供系统的理论依据和应用基础。