楚雄师范学院校园绿化植物研究

对楚雄师范学院绿化植物种类概况进行了初步调查,结果表明,楚雄师范学院校园绿化植物现有105种隶属51科,其中物种较丰富的科有蔷薇科、桑科、柏科及木兰科。笔者根据楚雄师范学院绿化植物现状,提出今后合理配置绿化植物的建议。     

Comparison and sensitivity of measurement techniques for spatial distribution of soil salinity

In Khorezm, a district of Uzbekistan situated in the Aral Sea Basin, soil salinization is an important driver of soil degradation in irrigated agriculture. The main objective of this study was to identify techniques that enable rapid estimation of soil salinity. Therefore, bulk electrical conductivity of the soil (EC_a-meas) was measured with three different devices (2P, 4P, and CM-138) and electrical conductivity of the soil paste (EC_p-meas) was measured with the so-called 2XP device. These measurements were compared with independent estimates of EC_a-calc and EC_p-calc based on laboratory measurements of the saturated extract, EC_e, of soil samples from the same sites. Soil salinity could be assessed satisfactorily with all four devices. EC_p-meas could be well reproduced by the 2XP device (R ² = 0.76), whereas EC_a-meas estimates using 2P, 4P, and CM-138 in the field were less accurate (R ² < 0.50). The sensitivity of all devices to the main ions Cl⁻ and Ca^{2 +} suggests that the measuring principles are similar for all instruments. The devices can therefore be used interchangeably. Field assessment of soil salinity was considerably enhanced by the use of CM-138, because large areas can be quickly assessed, which may be desirable in spite of the lower accuracy.     

A logistic analysis of the factors determining the decision of smallholder farmers to intercrop: A case study involving rubber–tea intercropping in Sri Lanka

The factors influencing the decision of smallholder farmers to adopt new farming technologies were studied with reference to rubber–tea intercropping in Sri Lanka. Rubber–tea intercropping has been recommended previously to rubber farmers as a means to improve productivity and income during the early pre-tapping phase of rubber growth. Although crop trials have shown that the two crops are agronomically compatible and potentially produce a combined economic yield superior to the yield of a sole crop grown on the same area of land, there is little evidence of widespread adoption of this practice among smallholder farmers in Sri Lanka. The aim of the study was to determine the major factors that influence the decision to undertake rubber–tea intercropping and to construct a predictive model that describes the likelihood of adoption of intercropping by traditional smallholder rubber growers. A rapid rural appraisal (RRA) was undertaken based on semi-structured interviews of 90 smallholder farmers in the main rubber growing low wet zone of Sri Lanka. Among a number of factors shown to significantly influence the decision to intercrop tea with rubber, three were shown to operate independently, namely level of income, source of income (i.e. solely from own farm or from farm plus additional off-farm enterprises), and availability of land considered suitable for tea cultivation. A statistical model developed through correlation and logistic analysis, which predicts the likelihood of a smallholder adopting intercropping based on these factors, is presented and discussed. The most likely combination of circumstances (82% probability) under which rubber–tea intercropping is practiced is shown to be where the farmer’s income is greater than Rs. 10,000 per month, where the farmer’s income is based solely on own farm enterprises, and where more than 80% of the farmer’s land area was judged to be suitable for tea cultivation. Conversely, 30% of smallholder farmers that chose not to intercrop did possess land suitable for tea cultivation. Qualitative responses to the RRA indicated that limitation of technical knowledge was the main problem subsequently faced by rubber farmers who had adopted rubber–tea intercropping. Results indicate that there is need for both income support through farm subsidies and further agricultural extension services, if rubber–tea intercropping is to be adopted more widely in Sri Lanka. The wider usefulness of the developed logistic model in determining the likelihood of adoption of intercropping by smallholder farmers is discussed.     

联合收割机割台总成的虚拟装配

研究了基于虚拟现实技术的联合收割机割台总成的虚拟装配.根据产品的装配结构模型,生成了联合收割机割台总成的装配结构树;采用UG建立了割台总成零部件的三维数字模型,导入到数字制造仿真软件,建立了总成各零部件的约束及装配关系,对割台总成进行了虚拟装配.     

果树栽植机光电定株距装置的设计与试验

针对果树栽植过程中株距难以控制的问题,考虑到现有的果树栽植机定株距存在结构复杂、制造成本高及受土壤滑移率影响较大等问题,设计了一种光电定株距装置,可以避免土壤滑移率对株距的影响,保证栽植果树株距的一致性,且可实现株距连续可调,满足不同果树栽植时对株距选择的要求。针对试验中出现的部分株距较设计值有所偏差的问题,分析了原因并提出了优化方案。试验结果表明:果树栽植机光电定株距装置栽植合格率92.5%,平均栽植深度合格率为92.9%,在1.7m栽植株距下,株距变异系数为5.9%,满足现代标准果园机械化生产要求。     

果树专用饼状缓释肥递肥机构设计与优化

针对现代果园生产过程中出现的化肥施用不当、浪费资源、污染环境等问题,提出果园缓释肥施肥方法。缓释肥料由于肥力释放速率、方式和持续时间已知并可控制而被推广,发展潜力大,但目前缓释肥施肥以手工施肥为主,劳动强度大,作业效率低。为解决这些问题,提出了一种缓释肥施肥机凸轮递肥机构。该机构由单片机、步进电机、凸轮、推杆及递肥盒构成,实现可控单一递肥。基于碰撞函数接触算法(IMPACT-Functionbased Contact)对不同基圆半径R的凸轮进行仿真,通过对凸轮递肥机构的仿真试验,获取凸轮机构与推杆机构之间的接触力数据及推杆运动时的加速度和速度数据。通过对所得数据进行分析,优化凸轮基圆半径,结果表明:当基圆半径为105mm时,不仅可以减少材料成本,而且凸轮与推杆之间的挤压与接触力、推杆运动的加速度和速度在要求范围内实现多目标最优。     

基于图像处理的温室黄瓜霜霉病诊断系统

为进一步提高温室黄瓜霜霉病诊断的准确率,构建了一个基于图像处理的温室黄瓜霜霉病诊断系统。针对温室黄瓜栽培现场采集的病害图像,采用基于条件随机场(Conditional random fields,CRF)的图像分割方法进行病斑图像分割,并采用决策树模型扩展一元势函数,提高病斑图像分割的准确性;将分割后的病斑图像转换到HSV颜色空间并提取其颜色、纹理和形状等25个特征,利用粗糙集方法进行特征选择与优化;构建了基于径向基核函数的SVM分类器,准确地识别与诊断温室黄瓜霜霉病。系统试验验证结果表明,该系统采用的病斑分割方法,能够克服复杂背景和光照条件的影响,准确地提取病斑图像;采用粗糙集方法能够有效地选择分类特征,将25个初始特征减少到12个,提高了运行效率;黄瓜霜霉病识别准确率达到90%,能够满足设施蔬菜叶部病害诊断的需求。     

间作木薯对橡胶树根际土壤真菌群落结构的影响

研究间作木薯对橡胶树根际土壤真菌群落多样性变化规律,为判断胶园间作木薯的可行性提供理论支撑。以橡胶与木薯间作为处理,橡胶单作为对照,采用传统方法和高通量测序技术分析橡胶树根际土壤理化性状及真菌群落结构。结果表明：（1）间作模式下橡胶树根际土壤的碱解氮、速效磷、速效钾、有机质含量和真菌Shannon指数显著降低,真菌Simpson指数显著提高,pH和Chao1指数虽有降低,但差异未达到显著水平;（2）门分类水平上,2个处理的橡胶树根际土壤真菌群落结构组成相近,共有的3大优势菌门均为Ascomycota、Zygomycota和Basidiomycota。间作木薯降低了橡胶树根际土壤中Zygomycota和Basidiomycota的相对丰度,但提高了Ascomycota相对丰度,达到91.54%;（3）属分类水平上,2个处理中相对丰度比例前10的优势菌属占所有检测出菌属的61.30%~65.59%,间作木薯提高了橡胶根际土壤中Phyllosticta、Gibberella和Lecythophora的相对丰度;（4）土壤碱解N、速效P和速效K含量对橡胶树根际土壤中真菌群落α-多样性产生影响,土壤真菌多样性变化与土壤有机质含量有关。因此,间作木薯增加了植物对土壤矿质营养元素的吸收,导致橡胶树根际土壤肥力下降,进一步降低了橡胶树根际土壤真菌的群落多样性,同时增加了病原真菌的丰度。     

不同铝水平胁迫对橡胶树幼苗若干生理指标的影响

研究不同铝水平胁迫(0、50、100、200、400 mmol/L)对橡胶树幼苗过氧化物酶(POD)、超氧化物歧化酶(SOD)、丙二醛(MDA)、叶绿素含量、叶片相对电导率及幼苗地上部与地下部铝含量变化的影响。结果表明,铝胁迫均使橡胶树幼苗生理指标产生一定的变化。在200 mmol/L和400 mmol/L铝水平下橡胶苗叶片POD活性和SOD活性先上升后下降至胁迫前甚至为0;MDA含量则大量增加,而且越来越高;叶绿素总量、叶绿素a和叶绿素b随胁迫时间的推移呈下降趋势,且铝浓度越大下降趋势越明显;相对电导率随胁迫时间的推移均呈现上升趋势,介于60%~100%之间,超过细胞质膜死亡的阈值;橡胶苗地下部铝含量分别约为地上部铝含量的3倍、2倍、1.3倍。不同铝水平胁迫处理中,随着铝浓度越高、胁迫时间越长对橡胶树幼苗生理指标的影响越大。其中在200 mmol/L铝水平下叶片相对电导率大于50%,达到叶片细胞膜透性阈值,MDA则大量增加,SOD和POD急速上升后下降,叶绿素含量极少。因而认为橡胶树幼苗的最高铝耐受浓度为200 mmol/L,地下部铝含量的耐受量为6.2 mg/g,地上部的耐受量为2.9 mg/g。     

橡胶草可作为产胶研究的模式植物

以尾细桉9个无性系叶片为外植体进行叶片离体培养和植株再生研究。结果表明,TDZ对尾细桉的再生诱导起着明显的促进作用,9个尾细桉无性系都获得了植株诱导再生,再生过程中不同的无性系呈现出不同的TDZ响应浓度,TDZ浓度在0.005～0.010 mg/L时获得较高的再生效率。不同无性系之间的再生率呈现出明显的差异,其中无性系YL2获得了最高达69.2%的植株再生效率,且每个外植体平均芽数超过10个。TDZ浓度对YL2的再生起到显著性影响,0.050 mg/L时再生效率最高,可以进行下一步的遗传转化研究。