DETERMINATION OF METALLIC IRON IN HIGH TITANIUM SLAG BY HEADSPACE GAS CHROMATNGRALHY

The following details are discussed in the present paper, after high titanium slag and H3PO4 is put in the closed system,the .reaction takes place under controlled temperature conditions, and the gas produced is collected. The two phases of gas liquid attain kinetic equilibrium, ihe gas above the liquid is used to make GC analysis with the aid of chromatographic column of 5A molecular sieve, TCD and N2 30ml/min. Satisfactory quantitative results can be achieved with simple instruments and uncomplicated operation technique.     

Determination and Evaluation of Saccharides Content in Extract of Herba Spirodelae Seu Lemnae Polysaccharides

In the course of searching immunodulators from natural herbal sources,the polysaccharide has been isolated from the water extract of duckweed(Herba Spirodelae seu Lemnae).The authors aim at investigating the methods that determine the content of total saccharides in the mixture,accordingly,to be used as a quality control in the procedure of producing polysaccharides from duckweed.The contents of saccharides in the extraction were mensurated by spertrophotometry of sulphuric acid-phenol and sulphuric acid-anthrone.And the validitiy of methods was evaluated through some indexes such as linearity and range,precision,stability,and accuracy.The results reveal the methods are convenient,rapid,accurate,and high sensitive,thereby leading to a wide and effective use in determining the saccharides contents in polysaccharides extraction from Herba Spirodelae seu Lemnae.     

Determination of Molecular Weight and Distribution of Hyroxyethl Starch (HES) by Means of GPC- RI- MALLS Technique

The author introduces a method and experimental procedures that determine dn/dc,molecular weight and its distribution of the hyroxyethyl starch(HES) by means of Gel Permeation Chromatography-Refractive index-Multi-angle laser light scattering detection(GPC-RI-MALLS)techniques.The key experimental technique and results are discussed.The method takes CH3COOH/CH3COONa as mobile phase and solvent.The experiment gets satisfactory results.It can be used as a routine method to determine the hyroxyethyl starch(HES) molecular weight and its distribution.     

贵阳地区水稻中甲胺磷农药残留研究

甲胺磷（methamidophos）具有内吸、触杀和胃毒杀作用，防治抗性蚜、蟥和水稻叶蝉、悦虱等药效较好，但残留期较长，有时会影响作物的品质。通过对贵阳地区水稻中甲胺磷农药残留分析，得到贵阳地区的大米中甲胺磷未检出。样品以丙酮提取，经过盐析、再经二氯甲烷萃取后进行气相色谱分析（最低检测浓度为0.03μg/g），本方法的结果符合农药残留分析的要求，因此说明贵阳地区的大米中甲胺磷没有超标，为贵阳地区绿色食品的开发提供理论依据。     

弧型齿残膜捡拾滚筒捡膜的机理

对弧型齿残膜清理滚筒捡膜齿的轴向排列、滚筒转速、捡膜齿运动轨迹和各相关参数进行分析研究,初步找出弧型捡膜齿满足要求的排列布置、滚筒转速和合理的入土深度,确定了残膜回收机具的运动参数λ范围,为残膜清理滚筒的设计提供了理论依据。试验表明,所设计的残膜回收机具运动参数是合理的,在保证膜土分离效果好和较高残膜捡拾率的前提下可显著提高工作效率。     

厌氧消化物对西瓜的促生抑病作用

本文研究了厌氧消化物（沼液和沼渣）对西瓜生长和西瓜枯萎病的影响。用沼液浸种，浓度为０．５％～５％时均可提高发芽率，以２％沼液与８小时浸泡时间为最佳组合，大于５％时降低发芽率。用沼渣与土壤混合，比例为１：５，１：７，１：１０时西瓜生长的各项指标均高于对照，以１：５为最佳；１：３时各项指标与对照相差不多；１：２时各项指标低于对照。沼渣与土壤混合后可抑制西瓜枯萎病，沼渣用量越大抑制作用越明显。当比例为１：７，１：５，１：３时，防效分别为１８％，５８％和８６％。病害发生后用沼液灌根可阻止西瓜枯萎病发展，但没有治疗作用。     

旱地全膜双垄沟残膜捡拾机的设计

针对我国西北旱地全膜双垄沟残膜捡拾机仿形能力差、拾净率低的问题,设计了一种旱地全膜双垄沟滚筒式残膜捡拾机。同时,阐述了整机结构及工作原理,并通过机构分析和计算确定了关键部件工作参数,旨在为残膜回收提供一种新的机具。     

沼肥对水稻增产作用的研究

本文根据本所4年沼肥肥效定位试验结果,证实沼气发酵剩余物是一种缓速兼性的优质有机肥料。不仅沼液、浮渣、沉渣单独施用对水稻有较为显著的增产作用,而且沼液、浮渣、沉渣合并施用对水稻的增产作用更为显著,因此,必须纠正某些地方“弃渣用液”或“弃液用渣”的片面施用沼肥的现象,大力提倡全沼肥的合理施用。     

高效液相色谱法测定复方非泼罗尼滴剂中抗氧剂的含量

建立高效液相色谱法(HPLC)测定复方非泼罗尼滴剂中抗氧剂叔丁基对羟基茴香醚(BHA)与二丁基羟基甲苯(BHT)含量。采用高效液相色谱法,色谱柱为Agilent Zorbax SB-C18(250×4.6 mm, 5μm),流动相A为乙腈-甲醇-水(47∶21∶32),混合前在水中加入1%冰醋酸,流动相B为乙腈,线性梯度洗脱;检测波长为285 nm;流速为0.9 mL/min;柱温为30℃;进样量为20μL;采用外标法计算BHA、BHT含量。在建立的色谱条件下,空白溶液、阴性样品对BHA、BHT的测定均无干扰;BHA、BHT的检测限分别为0.08μg/mL和0.19μg/mL,定量限分别为0.31μg/mL和0.77μg/mL,分别在5.13～15.39μg/mL与2.56～7.66μg/mL范围内线性关系良好;平均回收率分别为98.5%和99.9%(n=9)。所建立的方法简单易行、专属性强、准确度高、灵敏度好,可用于复方非泼罗尼滴剂中抗氧剂的含量测定。     

泄流激励下水工闸门运行模态参数自动识别

为了能够自动快速准确的识别泄流激励下水工闸门的模态参数,解决系统稳态图自动化定阶困难和真实模态筛选的问题,该研究提出了一种改进的势能聚类（Potential-based Hierarchical Agglomerative,PHA）的协方差驱动随机子空间（Covariance-driven Stochastic Subspace Identification,COV-SSI）水工闸门自动模态参数识别方法。首先采用小波阈值的方法对采集信号进行去噪处理。再通过奇异值加权判断指标（Singular-value Weighted Index,SWI）进行系统阶次及稳态图最大阶次的自动化确定,剔除稳态图中的噪声模态,进一步使用势能聚类方法实现结构模态参数的自动化识别。将该方法应用于泄流激励下弧形闸门试验模型中,并与锤击法测试结果进行对比分析,结果表明,所提识别方法在无需人工激励条件下,能够实现系统阶次和稳态图最大阶次的自动化确定,剔除稳定图中虚假极点。通过与试验对比,该方法平均相对误差为3.5%,可用于泄流激励下水工闸门结构运行模态参数的自动智能化识别。