Deep Freezing of Boar Semen Packaged in Plastic Bags and Straws

For practical reasons, a large volume (i.e. 5 ml) of frozen boar semen per insemination dose is desirable, but successful freezing has not been achieved, since optimal cooling rates have not yet been established. Post-thaw motility and the acrosome intep'ty of semen from four boars frozen with a programmable freezin machine, in mini-(0.25 ml), maxi-(5 ml) plastic straws and in 10 × 5 cm PVC- or Teflon FEP-plastic bags (0.35 – 0.12 mm thick, 5 ml) was studied. The freezing of the semen was monitored using thermocouples placed in the straws and the bags. The freezing curve started from +5°C, at a rate of −3°C/min, to – 6°C, it was held for 1 min at −6°C, and was followed by further drop to −100°C at a rate of −20°C/min, with subsequent storage in LN₂. The bags had a much shorter freezing point plnteau, compared to the maxi-straws. Post-thaw sperm motility was significantly higher when semen was frozen in mini-straws or in bags than in maxi-straws. The freezing procedure did not cause major acrosomal damages, significantly more normal apical ridges being present in the bags and mini-straws than in the maxi-straws. This in vitro evaluation indicates that the freezing method employed is satisfactory for freezing large volumes of boar semen into plastic bags .     

综合加固法处理沿海滩涂软基施工

采用水泥粉喷柱、砂砾垫层与覆膜土工布三者结合的综合加固法处理滨海相淤泥沉积,水泥粉喷桩的施工及成桩检测;土工布的施工;软基处理应注意的问题。     

Assessment of stakeholder perceptions of the damage to silo bags by vertebrate species in Argentina

We conducted an on-line questionnaire to assess stakeholder perceptions about damage to silo bags by vertebrate species in Argentina. We received 190 responses reporting damage to silo bags by vertebrates from the Pampas, Espinal, and Chaco regions. More than two-thirds of respondents indicated armadillos were the main harmful species, followed by rodents and dogs. Frequency of damage to silo bags was higher for armadillos (79%) than for the other species together (64%), and was higher in the Pampas (79%) than in the other regions (45–66%), suggesting a latitudinal gradient of damage. Economic losses were reported as “medium” or “high” by 37% of respondents. According to these stakeholders, damage to silo bags by vertebrates is a regionally extended phenomenon in most of the Argentine agricultural region and it is recognized as economically relevant by these stakeholders. Management of this conflict should focus on environmental aspects.     

7种能量饲料淀粉降解率的研究

以6头装有永久性瘤胃瘘管的浏阳去势黑山羊为实验动物,利用瘤胃尼龙袋技术研究大麦、大米、高粱、荞麦、小麦、小米、玉米等7种常用谷物饲料淀粉在羊瘤胃内的降解率规律。结果表明各种饲料淀粉有效降解率(%)顺序为:大麦>小麦>玉米>大米>荞麦>高粱>小米。其中以大麦的淀粉有效降解率最高达97.05%,小米的最小为36.43%,其它依次为96.28%、55.37%、45.23%、44.10%、42.58%。     

竹纤维增强聚丙烯复合材料的研究

研究了竹纤维增强聚丙烯复合材料的力学性能、热学性能、加工性能,采用电镜扫描分析了复合材料的界面及其微观结构.用多元统计分析中的主成分分析法,合理地确定竹纤维增强聚丙烯复合材料多项性能指标兼优的最佳纤维含量.     

Chemical characterization of smoke from the production process of wood-plastic composites

The chemical composition of unpleasant smell, emitted from the production process of wood-plastic composites using Manchurian ash sawdust (Fraxinus mandschurica Rupr.) and polypropylene powder as the raw material, was investigated. Wood sawdust and polypropylene powder were subjected to heat treatment to 290°C during 8 min (the conditions were similar to those employed on an industrial scale). The emitted compounds were collected and analyzed by gas chromatography-mass spectrometry (GC-MS). The analytical r...     

木粉加入量对木／塑复合材料性能影响的研究

研究了聚丙烯与木粉以不同比率复合而成的材料的物理力学性能和复合形态特征。结果表明：不同混合比率的聚丙烯与木粉进行复合后所得的复合材料，除冲击强度有所降低外，其它力学性能均比纯聚丙烯的有较大幅度的提高。木粉表面的酯化处理可以改善木塑界面之间的相容性和复合材料的均匀性。在木塑复合过程中木塑之间发生镶嵌现象使木塑之间产生物理结合。     

黄麻土工布控制红壤坡面侵蚀的研究

采用长期室外径流观测和人工模拟降雨的方法,在第四纪红色粘土母质发育的红壤上进行黄麻土工布保持水土的研究,结果表明：黄麻土工布具有很好的水土保持效果,能推迟初始产流时间,减少径流,防止沟蚀产生,与裸地相比,保水效益高达７５％,保土效益达９９％。黄麻土工布覆盖并结合营造植物,可更提高水土保持的持续效果。     

Properties of PEG/thermally modified wood flour/polypropylene (PP) composites

In order to improve the dimensional stability of wood-polymer composites, wood flour pre-treated by polyethylene glyco1 (PEG) at two different concentrations and then thermally treated at 140°C, was used as raw material to produce wood flour/polypropylene (PP) composites at a wood content of 40%. The structure of modified wood flour was analyzed with a scanning electron microscope (SEM) and its effect on the physical and mechanical properties of wood flour/PP composites was evaluated. The SEM results indicated the "bulking" effect of PEG on wood flour, which resulted in reduced water uptake. The combination of PEG and heat treatment further improved the moisture resistance of the composites. However, PEG modification had a negative effect on the flexural modulus of rupture (MOR) and the modulus of elasticity (MOE); whereas heat treatment partly compensated for this reduction. For dynamic mechanical properties, PEG treatment decreased the storage modulus (E′). However, the heat treatment resulted in an increase of E′ of the wood flour/PP composites, with the temperature of loss factor peaks shifting to a higher temperature.