奶牛乳房炎发泡药剂的研究Ⅱ.发泡药剂的研制与动物试验

研究了奶牛乳房炎发泡药剂的制备方法及其质量控制标准。该药剂是以碳酸氢钠和枸橼酸作发泡剂，研制药物的发泡量为原药液体积的8-12倍。经动物乳房给药试验证实，该药剂安全、无刺激性、在乳腺内分布效果明显优于常规剂型，室温保存有效期为2年。     

雀鹰耳蜗核的定位及形态学的研究

向非鸣禽雀鹰（Ａｃｃｉｐｉｔｅｒｎｉｓｕｓ）的耳蜗内注入ＣＢ—ＨＲＰ溶液，结果发现在同侧的听神经内有许多的标记纤维；同侧的角状核及巨细胞核内有较密集的标记终末。表明由耳蜗神经元发出的纤维组成听神经后，分别投射到耳蜗核的两对亚核，即角状核和巨细胞核。尼氏染色法表明，角状核和巨细胞核有不同的核团形态和细胞组成。提示这两对耳蜗亚核可能具有不同的听觉和定向功能。     

不同施肥水平与组合对饲用黑麦经济效益的影响及施肥决策

应用回归均匀设计构造试验方案,研究氮肥、磷肥、钾肥不同水平与组合对饲用黑麦经济效益的影响及优化施肥方案。结果表明,饲用黑麦干草价格较低时,应减少肥料投入以降低生产成本为主,使所获利润最大;干草价格较高时,应适量增加肥料投入以提高产量,从而获得较高利润; 在饲用黑麦生产中,施肥量多少取决于所追求的目标。以产量为目标,就要投入较高的施肥量,以经济效益为目标,就要求适宜的施肥量,考虑到牧草品质,就要求较多的施氮水平。只有饲用黑麦产品实行优质优价,才能基本达到三者目标的统一。综合考虑,施肥量投入应为N:225 kg/hm²左右,不应低于150 kg/hm²,P₂O₅为75 kg/hm²,K₂O为30 kg/hm²以下比较适宜。     

全混合日粮在生产实践中使用的条件与方法

全混合日粮(TMR)是现代奶牛场普遍采用的饲喂技术。本文就目前我国奶牛养殖场(户)使用TMR日粮应具备的条件及使用方法进行介绍。     

饲料及其原料中尿素检测方法的研究进展

本文就近年来国内外报道饲料及其原料中尿素检测方法的相关原理及应用进行综述,并对建立健全统一的尿素检测体系提出建议。     

Assessment of stiffness and strength of 4 different implants available for equine fracture treatment: a study on a 20 degrees oblique long-bone fracture model using a bone substitute

OBJECTIVE: To compare the mechanical properties of 4 stabilization methods for equine long-bone fractures: dynamic compression plate (DCP), limited contact-DCPlate (LC-DCP), locking compression plate (LCP), and the clamp-rod internal fixator (CRIF--formerly VetFix). STUDY DESIGN: In vitro mechanical study. SAMPLE POPULATION: Bone substitute material (24 tubes) was cut at 20 degrees to the long axis of the tube to simulate an oblique mid-shaft fracture. METHODS: Tubes were divided into 4 groups (n=6) and double plated in an orthogonal configuration, with 1 screw of 1 implant being inserted in lag fashion through the "fracture". Thus, the groups were: (1) 2 DCP implants (4.5, broad, 10 holes); (2) 2 LC-DCP implants (5.5, broad, 10 holes); (3) 2 LCP implants (4.5/5.0, broad, 10 holes) and 4 head locking screws/plate; and (4) 2 CRIF (4.5/5.0) and 10 clamps in alternating position left and right of the rod. All constructs were tested in 4-point bending with a quasi-static load until failure. The implant with the interfragmentary screw was always positioned on the tension side of the construct. Force, displacement, and angular displacement at the "fracture" line were determined. Construct stiffness under low and high loads, yield strength, ultimate strength, and maximum angular displacement were determined. RESULTS: None of the implants failed; the strength of the bone substitute was the limiting factor. At low loads, no differences in stiffness were found among groups, but LCP constructs were stiffer than other constructs under high loads (P=.004). Ultimate strength was lowest in the LCP group (P=.01), whereas yield strength was highest for LCP constructs (409 N m, P=.004). CRIF had the lowest yield strength (117 N m, P=.004); no differences in yield strength (250 N m) were found between DCP and LC-DCP constructs. Differences were found for maximum angular displacement at the "fracture" line, between groups: LPC相似文献   

Evaluation of Joint Toxicity of Enrofloxacin and Three Antimicrobials on MRC-5 Cells

The aim of this study was to evaluate the combined toxicity of enrofloxacin with each of three antimicrobials (ciprofloxacin,florfenicol and sulfamethazine).MRC-5 cells were used as a cell model to simulate the damage of lung cells caused by mixed contamination of antimicrobials.Multiple concentration gradients and mixing ratios were set.CCK-8 method was used to determine the inhibition rate of cell growth caused by four antimicrobials and the inhibition rate of cell growth caused by enofloxacin mixed with three antimicrobials,respectively.Then Chou-Talalay method was used to fit the median effect plot and to calculate the combination index (CI) value.The results showed that the growth inhibition rates of MCR-5 cells caused by four single drugs went up in a step-like manner with the increase of drug concentration in the tested concentration range,among them,the growth inhibitory rate of MCR-5 cells by florfenicol was low (<4.5%).The combined toxicity of the three binary combinations showed a concentration-dependent and mixing-ratio dependence.Mixing enrofloxacin and ciprofloxacin showed synergistic toxicity (CI<1) on MRC-5 cells at high and middle concentration groups,and antagonistic toxicity (CI>1) at the very-low-concentration groups.Mixing ciprofloxacin and florfenicol mainly showed an inhibited toxicity (CI>1).Binary combination enrofloxacin and sulfamethazine might present either a synergistic joint toxicity (CI<1) or an antagonistic joint toxicity (CI>1) as the concentration and mixing ratio changing.This study showed that it was necessary to assess the combined toxicity of antimicrobials in the toxicity evaluation of antimicrobials.Using Chou-Talalay method,the joint toxicity of multiple antimicrobials could be quickly and efficiently determined at cellular level.     

厄贝沙坦及其复方制剂中痕量杂质N-亚硝基-N-甲基-4-氨基丁酸残留方法学研究

采用超高效液相色谱-三重四级杆质谱(UPLC-MS/MS)建立厄贝沙坦及其复方制剂中N-亚硝基-N-甲基-4-氨基丁酸(NMBA)的测定方法。采用Waters ACQUITY UPLC○RHSS T3色谱柱进行分离,以0.005 mol/L甲酸铵(用甲酸调pH值至3.0)为流动相A,甲醇为流动相B,梯度洗脱,质谱检测器,流速为0.3 mL/min。结果显示NMBA的线性范围为0.156 6~3.132 6 ng/mL,相关系数r>0.99,方法检出限浓度为0.047 0 ng/mL(相当于样品浓度0.01μg/g),定量限浓度为0.156 6 ng/mL(相当于样品浓度0.03μg/g),样品加标回收率在80%~130%。说明该方法可以快速、简便、灵敏、准确地测定厄贝沙坦及其复方制剂中NMBA含量。     

徒手克隆工具自制及改进

徒手克隆技术(handmade somatic cell cloning,HMC)解决了由于昂贵设备对核移植技术应用的制约问题。通过徒手克隆刀的自制,不但进一步节省了成本,且更能符合使用者的习惯,提高总的切割效率。试验结果表明,利用自制克隆刀进行半卵法去核,可以达到每小时切割496枚卵母细胞的切割速度和88.14%的存活率;自制聚集针具有制作简单,可以打磨、效果好等特点,可以进一步简化和降低徒手克隆技术的成本,提高克隆效率。     

蜂胶的挥发性成分及其生物学活性研究进展

蜂胶具有广泛的生物学活性和药理学活性,其中的挥发性成分是蜂胶发挥生物活性的重要组成部分。现对蜂胶挥发性成分的提取方法、化学组成、生物活性的研究作一综述,以期为今后的进一步研究和开发利用提供参考。