青土湖水面形成区土壤颗粒组成与化学特性变化

青土湖输水作为石羊河流域治理的一项关键措施,对保护湖区水资源和生态环境具有重要意义。在距青土湖水面边缘东南方向0-450 m的10个样点中分3层取0-60 cm土样,测定土壤粒径的质量百分比与全氮、全磷、全钾和电导率,分析青土湖水面形成后土壤颗粒组成与化学特性变化。结果表明,随着离水面边缘距离的增加,土壤颗粒与化学特性呈有规律的增减变化,土壤粘粉粒组成与其全磷、全钾之间存在正线性相关。青土湖水面形成加剧了距水面边缘0-150 m处的土壤理化性质变化;土壤细粒及养分出现富集,分别在距水面边缘100-150 m和300 m处达到最大值。因此,土壤养分与土壤细物质的良好相关性表明,土壤粘粉粒变化可作为反映该区域土壤性状变化和评价衡量水面形成后土壤恢复程度的定量指标之一。     

不同叶面肥对狐臭柴叶片生物量和主要生化指标的影响

以三年生狐臭柴为实验材料,设置自然光和遮光两种光照条件,用三种叶面肥进行喷施,分析不同肥料对狐臭柴叶片生物量和主要生化指标的影响。结果表明:喷施氮肥能显著提高狐臭柴叶片生物量,自然光及遮光下分别增加37.30%和15.02%,但果胶的积累减少,分别降低19.78%和17.35%;磷肥能显著提升叶片果胶的含量,分别增加158.08%和239.96%,但叶片生物量显著低于对照,分别降低55.83%和47.40%;复合肥对叶片生物量无明显影响,果胶含量轻微降低。各肥料均使可溶性糖含量降低,且在遮光条件下使叶片内可溶性蛋白含量增加,自然光下使可溶性蛋白含量降低。     

改装机械加工设备解决化工装置检修问题研究

随着我国经济水平不断提高，化工设备检修手段也在不断发展，以改装机械加工设备来解决化工装置检修问题成为了当下提高检修效率的热议话题之一。文章主要分析化工装置检修，阐述了以改装机械加工设备方式解决化工装置检修难题的过程，总结经验以供参考。     

渗灌次数对西北荒漠灌区紫花苜蓿栽培草地土壤化学性质的影响

渗灌是节水农业中最有效的措施之一,有利于作物产量和水分利用率的提高。本研究以甘肃省金昌市杨柳青公司紫花苜蓿‘艾迪娜’(M.sativa L.‘Aidina’)试验地渗灌区土壤为研究对象,通过田间试验与室内分析相结合的方法,研究不同渗灌次数(0次、1次、2次、3次)对苜蓿出苗期不同土层深度及管距位置土壤化学性质的影响。结果表明:在0~10cm和10~20cm土层深度,pH最高值均出现在管上,较CK升高了8.21%和8.68%,最低值都出现在管中,较CK降低了2.70%和3.37%;2水和3水均能显著提高不同土层深度及不同管距位置的pH值(P0.05)。不同渗灌次数,不同土层深度管中的水溶性盐含量均高于管上和管近,且最大值都出现在1水,较CK分别增加了83.26%和96.34%;不同土层深度,2水的水溶性盐含量平均值都低于1水和3水;不同渗灌次数,不同土层深度,钠离子和钾离子含量的最大值均出现在管中。不同渗灌次数,不同土层深度,管中的水解性氮含量均高于管上和管近,最大值都出现在1水管中,较CK分别增加了112.68%和34.48%。随着渗灌次数的增多,0~10cm土层深度不同管距的速效磷含量均呈现下降趋势,速效钾含量均呈现上升趋势。随着灌水次数的增加,不同土层深度及管位的有机质含量均呈现先上升后下降的趋势,2水显著提高了各位置土壤有机质含量(P0.05)。综上所述,渗灌2次比较好,土壤水溶性盐含量较低且有机质含量较高,利于苜蓿幼苗生长。     

皆伐与不同迹地清理方式对杉木土壤化学性质的影响

以福建将乐国有林场杉木人工林为研究对象,按照立地条件相一致的原则,利用空间代替时间的方法设置皆伐前、皆伐1个月、皆伐3个月、整地1 a、整地3 a、炼山1 a、炼山3 a等不同条件下总计21块标准样地,旨在研究皆伐与不同迹地清理方式对杉木林地土壤化学性质的影响。经过对标准地土壤化学性质测定,结合显著性差异法对试验数据进行处理分析。结果表明:皆伐后土壤化学性质趋于恶化,不同迹地清理方式土壤化学性质差异显著,带状整地法在短期1 a内对土壤化学性质的改善显著强于炼山法,并且炼山3 a后土壤化学性质基本恢复至炼山前,总体看来皆伐后带状整地的迹地清理方式优于炼山法。     

Practical use of response surface methodology for optimization of veterinary antibiotic removal using UV/H2O2 process

Three of the most commonly used veterinary antibiotics—enrofloxacin (ENR), sulfamethoxazole (SMX), and oxytetracycline (OTC)—were chosen as representative antibiotics for UV/H₂O₂ treatments. The objective was to determine the optimization of UV/H₂O₂ to remove antibiotics from aquaculture discharge water using response surface methodology. The degradation of the antibiotics was investigated under varying UV/H₂O₂ conditions in environments with different levels of pH, water matrices, humic acid, and constituent ions. The degradation results demonstrated that increasing the H₂O₂ dosage facilitated ENR degradation at a neutral pH while facilitating degradation of SMX and OTC at a slightly acidic pH. The optimum removal conditions for ENR, which was used in all influential effect experiments and the contact tank experiments, was obtained at 10 mM H₂O₂, a pretreated COD of 87.51 mg L⁻¹, and an initial pH of 6.15. Among the tested anions, only the presence of Cl^- showed slight positive effects on ENR degradation, due to the generation of secondary active radicals. During the reaction, the hydroxyl radical (OH) was present at a higher pH while singlet oxygen (¹O₂) was slightly present at a lower pH. The experimental results from H₂O₂ sequential addition indicated that freshly added H₂O₂ could quench the recently generated OH and therefore a high H₂O₂ concentration with frequent adding was not necessary. Our contact system reduced the ENR concentration in both the effluent reservoir and in the UV irradiation zone. The overall results supported the use of the UV/H₂O₂ system to treat remnant antibiotics in the discharge water.     

成都市典型农家乐植物组成特征研究

本文在成都市北湖公园、农科村、三圣乡选取了60个成都市典型农家乐,对植物群落进行了调查和分析。结果表明:成都市典型农家乐植物群落中应用的乔木种类有56种,灌木种类83种,草本种类有118种,共计257种,分属91科184属。在植物种类组成方面,成都北湖公园的乔木种类所占比例最高,达到22.39%;郫县农科村的灌木种类所占的比例是最高的,达到36.55%;而三圣乡"五朵金花"的草本种类所占的比例最高,达到47.92%。农科村主要树木的平均胸径为13.32±9.07?,平均高度为5.53±2.49 m,在3个地方中均为最高。群落外貌方面,三圣乡"五朵金花"和郫县农科村农家乐以常绿阔叶和落叶阔叶的混交林为主,针叶林少。成都北湖公园则以常绿阔叶为主,落叶和针叶林少。60个农家乐平均配置乔木5.1±2.47(N=60)种,平均配置灌木8.77±3.41(N=60)种,平均拥有草本11.83±6.75(N=60)种,超过50%的植物种类为三地或两地共有,植物配置呈现明显的相似性。     

Contribution of incident solar radiation on leaves and pods to soybean seed weight and composition

The weight and composition of soybean seeds (Glycine Max L. Merrill) depend on changes in carbon and nitrogen assimilate supply during grain filling. Soybean pods and seeds are green, evidencing their capacity to capture light. However, the current physiological knowledge does not consider any effect of incident solar radiation reaching the pods on seed weight and composition. The objective of this work was to investigate the response of seed weight and composition to changes in assimilate supply from leaves, to the incident solar radiation reaching the pods and to the combination of both, changes in assimilate supply from the leaves and incident solar radiation on pods of soybean plants. Field experiments were performed during two growing seasons at Balcarce, Argentina. Treatments modified the amount of assimilates supplied by the leaves (plant shading, defoliation), the solar radiation reaching the pods (pod shading) or both (defoliation and pod shading) during seed filling. Plant shading and defoliation reduced seed weight, oil concentration and oil and protein content and increased the concentration of saturated and poli-unsaturated fatty acids while reduced oleic acid percentage. Pod shading increased the concentration of stearic acid and reduced the concentration of linolenic acid. When pods were shaded on defoliated plants, seed weight and oil and protein content decreased while fatty acid composition was similar to values obtained under defoliation treatment. Based on these results, a conceptual model that considers photoheterotrophic nature of reproductive structures of soybean is proposed. Seed weight, oil and protein content and oil fatty acid composition depended on assimilate availability for the seeds. The response of oil and protein content to assimilate supply depended on whether leaves were present or not. The effect of solar radiation incident on pods depended on the amount of assimilates available for the seeds: (i) when carbon allocated was low (defoliation treatments), pods contributed to seed carbon economy but solar radiation incident on them did not affect fatty acid composition; (ii) when carbon allocated to the seeds was high (intact plants), contribution of pods to seed carbon economy was not significant, but the amount of solar radiation incident on pods produced significant changes in fatty acid composition.     

滇朴干基腐朽病发生规律及综合防治

对滇朴干基腐朽病的调查、室内保湿培养、分离鉴定结果表明：引起滇朴干基腐朽的病原为伏革菌科隔孢伏革菌属的乳白隔孢伏革菌。该病害的发生随温度的升高、树龄的增长、降水的减少而逐渐严重，在土壤瘠薄、保水能力差的区域内发病严重。药剂防治80d后，用急救回生丹：金雷：水=1：1：50树干注射、包干的相对防效达86％；枝、干、叶喷70％甲基托布津＋杀毒矾700倍液的相对防效为79％；根部浇灌58％的雷多米尔＋杀毒矾800倍液的相对防效为81％。     

Soil CO2 emission in sugarcane management systems

Sugarcane management systems affect soil attributes such as the carbon cycle. This fact has stimulated the sugar and alcohol industry to refine the sugarcane production systems by replacing the pre-harvest burning (PB) and manual harvest with mechanized harvesting followed by residue deposition. The aim of this study was to evaluate different management systems with respect to C cycling carbon dioxide and soil parameters (chemical, physical and biological) which were determined over the season. Three sugarcane cultivation systems were evaluated at the following periods: (a) PB, (b) 5-year green harvest and (c) 10-year green harvest. The results indicated that CO₂ emission was 36% greater in the 10-year sugarcane green harvest system than in the PB system. The bulk density and macroporosity were the factors that were most affected by the different sugarcane management systems and that significantly influenced soil CO₂ emissions. The principal component analysis showed that soil CO₂ emission was 18% influenced by base saturation (V%) and 14% by pH, especially in the PB area. Additionally, 19% was affected by carbon and macroporosity in the 5- and 10-year green harvest areas, respectively. From our results, it can be concluded that the most CO₂ emissions are in the areas of sugarcane green, this is due to the higher carbon concentration when compared with the area of burning sugarcane. The parameters that most influenced the CO₂ emissions were bulk density, porosity, macroporosity, pH and V%.