Dense planting with less basal nitrogen fertilization might benefit rice cropping for high yield with less environmental impacts

Dense planting and less basal nitrogen (N) fertilization have been recommended to further increase rice (Oryza sativa L.) grain yield and N use efficiency (NUE), respectively. The objective of this study was to evaluate the integrative impacts of dense planting with reduced basal N application (DR) on rice yield, NUE and greenhouse gas (GHG) emissions. Field experiments with one conventional sparse planting (CK) and four treatments of dense planting (increased seedlings per hill) with less basal N application were conducted in northeast China from 2012 to 2013. In addition, a two-factor experiment was conducted to isolate the effect of planting density and basal N rate on CH₄ emission in 2013. Our results show that an increase in planting density by about 50% with a correspondingly reduction in basal N rate by about 30% (DR1 and DR2) enhanced NUE by 14.3–50.6% and rice grain yield by 0.5–7.4% over CK. Meanwhile, DR1 and DR2 reduced GWP by 6.4–12.6% and yield-scaled GWP by 7.0–17.0% over CK. According to the two-factor experiment, soil CH₄ production and oxidation and CH₄ emission were not affected by planting density. However, reduced basal N rate decreased CH₄ emission due to it significantly reduced soil CH₄ production with a smaller reduction in soil CH₄ oxidation. The above results indicate that moderate dense planting with less basal N application might be an environment friendly mode for rice cropping for high yield and NUE with less GHG emissions.     

In-field management of corn cob and residue mix: Effect on soil greenhouse gas emissions

In-field management practices of corn cob and residue mix (CRM) as a feedstock source for ethanol production can have potential effects on soil greenhouse gas (GHG) emissions. The objective of this study was to investigate the effects of CRM piles, storage in-field, and subsequent removal on soil CO₂ and N₂O emissions. The study was conducted in 2010–2012 at the Iowa State University, Agronomy Research Farm located near Ames, Iowa (42.0°′N; 93.8°′W). The soil type at the site is Canisteo silty clay loam (fine-loamy, mixed, superactive, calcareous, mesic Typic Endoaquolls). The treatments for CRM consisted of control (no CRM applied and no residue removed after harvest), early spring complete removal (CR) of CRM after application of 7.5 cm depth of CRM in the fall, 2.5 cm, and 7.5 cm depth of CRM over two tillage systems of no-till (NT) and conventional tillage (CT) and three N rates (0, 180, and 270 kg N ha⁻¹) of 32% liquid UAN (NH₄NO₃) in a randomized complete block design with split–split arrangements. The findings of the study suggest that soil CO₂ and N₂O emissions were affected by tillage, CRM treatments, and N rates. Most N₂O and CO₂ emissions peaks occurred as soil moisture or temperature increased with increase precipitation or air temperature. However, soil CO₂ emissions were increased as the CRM amount increased. On the other hand, soil N₂O emissions increased with high level of CRM as N rate increased. Also, it was observed that NT with 7.5 cm CRM produced higher CO₂ emissions in drought condition as compared to CT. Additionally, no differences in N₂O emissions were observed due to tillage system. In general, dry soil conditions caused a reduction in both CO₂ and N₂O emissions across all tillage, CRM treatments, and N rates.     

淮安区水稻测土配方施肥配方校正与示范对比试验报告

为验证肥料配方的准确性,发挥配方肥料施用的最大效益。通过田间校验,示范对比测土配方施肥的增产效果,进一步验证并完善淮安区的肥料配方,优化测土配方施肥技术参数。     

不同施肥处理对油茶生长及土壤肥力的影响

为探究不同施肥处理对油茶生长及土壤肥力的影响,连续3年在广西柳州市对5年生油茶人工林进行施肥试验研究。结果表明,施肥后,处理Ⅱ的树高、地径和冠幅的增长量明显高于其它处理,即有机—无机复混肥料直接施入油茶林地最有利于营养生长,而处理CK(不施肥)各项生长指标的增长量最低。不同施肥处理对油茶林地土壤养分各指标的影响差异较大,经灰色关联度法分析得出土壤综合肥力的高低顺序,其中处理Ⅲ(即无纺布包装有机—无机复混肥)施肥后对油茶林地土壤综合肥力的提高最显著,其次为处理Ⅰ(即有机栽培肥料),不施肥处理CK的土壤综合肥力则显著降低,土壤质量退化严重。     

桑叶养猪实用技术

桑叶养猪实用技术分为桑树种植技术和桑叶干粉发酵养猪技术两个部分。利用荒地种植桑树,降低生猪养殖饲养成本,桑叶养猪种养结合,成为生态农业典范。桑叶干粉发酵技术,提高了桑叶干粉的可消化率和饲料功能。桑叶干粉发酵料占配方6%~10%,做成桑叶猪饲料,替代3%~5%鱼粉、豆粕等蛋白质饲料,节约了饲料成本。桑叶喂养猪(简称桑叶猪,下同)的猪肉中含有肌苷酸等风味物质,显著提高猪肉胴体品质和猪肉风味。设计猪尿处理,采用红泥膜沼气池降解工程工艺应用后,降解水兑2倍清水对桑树喷灌工艺,减少人工处理劳力和成本费用。设计10%抗非洲猪瘟中药饲料添加剂+桑叶饲料,预期防治非洲猪瘟总效果85%以上。桑叶养猪实用技术可行,供同行参考。     

我国金银花产质量影响因素及轻简化施肥推荐

金银花是我国一种用途广泛的传统大宗中药材，年需求量大，影响其产量和质量的因素也较多。本文通过文献检索，从产地特点、品种特性、土壤性质和施肥管理措施及后期加工等方面对影响金银花产质量的主要因素进行了综述。并通过引入结构方程模型，对不同因素对金银花产量的相对影响程度进行了探索性分析，对于某一产地的具体品种，单株产量的主要影响因素是土壤有机质、pH和速效钾含量等土壤因素，和氮肥用量等施肥因素。在此基础上，针对当前施肥现状，借鉴根区施肥法，进行了以干花重为基准的施肥量推荐,并提出了将全年所需肥料一次性施于根区的轻简施肥法，旨在为金银花的轻简化高产高效优质栽培提供思路与参考。     

淮阴区配方肥料应用的现状、存在问题和对策

配方肥料是"测土配方施肥"的物化载体,是科技转化为生产力的具体表现。如何尽快将通过测土配方技术研制的配方肥料应用到生产实际中,不仅关系到"测土配方施肥"项目的实施效果和效率,同时也关系全区耕地质量的提高和农业可持续发展的顺利实现。当前,由于受市场因素、农技体制、农民素质、流通形式等诸多因素影响,配方肥料的推广工作进展得很不顺利。要真正把配方肥料推广应用到千家万户,发挥其在农业生产中的增效作用,还需要各级政府、农技推广部门、肥料生产企业、经销商等的共同努力和全社会的广泛参与。     

春花生超高产栽培技术模式研究与应用

采取正交旋转回归设计,以播种期、种植密度、施肥量为试验因子,以9000kg/hm2为产量目标函数,进行春花生超高产栽培模式集成研究。结果表明,在鲁西南平原地区,超高产春花生以种植密度和N、P、K施肥量为主要限制因素,播种期为次要限制因素。明确了春花生单产达到9000kg/hm2以上的最佳种植密度、播种期和合理的N、P2O5、K2O施用量为主要指标的栽培技术模式,增产效果显著。     

基于茶籽壳代替木屑栽培茶树菇配方筛选试验

不同比例的茶籽壳和木屑组合成5个试验配方,比较不同配方对菌丝生长、子实体经济性状和生物转化率的影响。试验结果表明,在供试的5个配方中,配方4（棉籽壳50%、茶籽壳15%、木屑5%、麦麸20%、玉米粉7%、石膏1%、磷肥1%、石灰1%）为优选配方。     

有机无机肥配施对冬春烤烟经济性状的影响

在云南梁河县对冬春烤烟开展有机肥和化肥合理配施试验,结果比对照增产62.7%;中上等烟比例增加3.6个百分点;净增产值提高72%。