模拟氮沉降对杉木人工林(Cunninghamia lanceolata)土壤酶活性及微生物群落功能多样性的影响

在杉木人工林中开展模拟氮沉降试验,设计N0(对照)、N1(N 60 kg/(hm2.a))、N2(N 120 kg/(hm2.a))和N3(N 240 kg/(hm2.a))等4个氮沉降水平。通过连续7年的处理后,研究了外加氮源对土壤酶活性及群落功能多样性的影响。相同氮沉降处理下,参与土壤碳循环的6种主要酶(蔗糖酶、纤维素酶、淀粉酶、β-葡糖苷酶、多酚氧化酶、过氧化物酶)活性、土壤微生物群落碳源利用能力和多样性指数与均匀度指数均随土层加深而降低。氮沉降对纤维素酶和多酚氧化酶具有促进作用,而对淀粉酶和过氧化物酶表现出一定的抑制作用;中?低氮沉降(N1、N2)对蔗糖酶无影响,而对β-葡糖苷酶具有促进作用,高氮沉降(N3)促进了蔗糖酶活性,但抑制了β-葡糖苷酶活性。各土层中,低氮处理(N1)促进了微生物群落碳源利用能力和多样性指数与均匀度指数的增加,而中?高氮处理(N2、N3)则呈抑制作用。主成分分析表明,土壤微生物群落利用的主要碳源为碳水化合物和羧酸,不同氮沉降处理碳源利用类型存在差异。因此,氮沉降促进了表层土壤纤维素酶、多酚氧化酶和蔗糖酶的活性,但在一定程度上抑制了淀粉酶、过氧化物酶和β-葡糖苷酶活性;氮沉降增加改变了杉木人工林土壤微生物群落的功能多样性。     

大豆种质资源叶型和荚粒性状的关系及与SSR标记的关联分析

选用167份国内外大豆品种资源材料,依据叶长/宽比值将其划分为宽叶型和窄叶型, 分析叶型相关性状与荚粒性状的相关性,结果表明叶宽、叶长/宽比均与每荚粒数显著相关(r = –0.69和0.64,P<0.001)。选用均匀分布于大豆20条连锁群上的65个SSR标记分析资源材料的群体结构,并用目标区间内13个SSR标记与叶型相关性状和荚粒性状进行关联分析, 结果显示,标记20-285与每荚粒数显著关联,推测控制每荚粒数的基因可能位于标记20-285附近;标记20-26和20-45间的标记几乎都与叶长/宽比存在显著的关联性,推测控制叶型的基因位于标记20-26和20-45之间。相关分析和关联分析证实大豆叶型与荚粒性状存在密切关系,并缩小了每荚粒数和叶型候选基因的区间。     

北苍术种子质量分级标准研究

对源自不同产地的22份北苍术种子形态大小、含水量、千粒重、净度、生活力、发芽率等指标进行检验。在对试验数据进行收集、整理、分析的基础上,将其分成三个等级,本实验依据各项检测项目对22份北苍术种子进行检验,初步确定北苍术种子分级标准。     

03-19-程旺大-密穗型水稻的研究现状及展望

水稻密穗型品种通过“扩库”使产量水平有了较大提高，其育成和推广在近20a来浙江省晚粳稻品种改良及增产中起了重要作用。分析了密穗型品种的形态学特征及其生理生态特性，从群体小气候环境、物质的生产和分配、产量结构、稻曲病的发生及稻米品质和灌浆特性等方面进行了讨论。在此基础上，对密穗型水稻的研究作了展望，认为应继续加大形态类型创新和育种基础材料的创新，开展不同类型品种源库关系的研究，以及不同类型品种品质差异及其形成机理的研究。     

玉米抗南方型锈病基因共分离分子标记的研究

本文以玉米(Zea mays L.)抗南方型锈病自交系P₂₅和感病自交系F₃₄₉的F₁与F₃₄₉回交,并连续回交所得BC₅代的F₃₄₉抗病近等基因系（nearly isogenic lines,NILs）为材料,以RGA（resistance gene analogs）的方法,在抗病自交系中克隆出一条321 bp的特异性DNA条带。根据序列比对的结果,设计出新的引物作为分子标记,在96株BC₇、BC₄F₅NILs及其亲本和杂种F₁群体上进行鉴定,其中94株的田间抗感结果与分子检测结果一致,选择的有效率达97.9%。此标记扩增效果清晰,可重复性强,在抗玉米南方型锈病的分子标记辅助育种研究中有应用价值。     

磺酰脲类除草剂药害规律的研究

采用作物主根长法测定了常用两种磺酰脲类除草剂对玉米（Zea mays L.)农大1236和豌豆（Pisum sativum L.）中碗6号的相对毒力，玉米试验结果表明，以IC50值比较，氯磺隆、胺苯磺隆对玉米的毒力较高，容易造成药害。豌豆试验结果表明，豌豆对氯磺隆和胺苯磺隆比玉米更敏感。离体玉米和豌豆ALS酶的研究表明，豌豆的ALS对两种磺酰脲类除草剂较玉米更敏感，氯磺隆对两种作物的ALS抑制作用也较胺苯磺隆强。     

Einfluss selektiver mechanischer Fruchtbehangsregulierung auf Ethylensynthese als Stressindikator sowie Ertrag und Fruchtqualität bei Kernobst

The overall objective of this work was to improve fruit quality, break alternate bearing and reduce hand thinning using fewer chemicals in fruit crops. A device was constructed for mechanical thinning, which consisted of three independent horizontal rotors with ropes and freely adjustable angles on a frame, mounted on a front three point hitch and powered by the tractor hydraulics. This can be adapted to any fruit tree trained as spindle, Solaxe, (tall) vertical axis or fruit wall (le mur fruitier) irrespective of rootstock employed. Rotor speed varied from 300 to 460?rpm at either 5 or 7.5?km/h tractor speed. Eight-year-old or twelve-old apple trees cvs. ‘Gala’ and ‘Golden Delicious’ were mechanically thinned in 2007 between pink bud and full bloom (flower bud stages 6–8 or F1–F2) near Bonn, Germany; non-thinned and hand-thinned apple trees of the same block and variety served as control. Mechanically thinned flowering branches showed a similar amount of ethylene efflux (0.4–0.6?ppm C₂H₄/branch) as non-thinned flower branches, preventing potentially unexpected subsequent fruit drop, except for those removed by the rotors. The impact of the horizontal rotors on the branches was from the upper side and removed excessive flowers right to the tree trunk viz. the centre of the tree canopy, where fruits of lesser quality are expected leaving 2–3 flowers per cluster. Leaf damage was less than??10%, even at the fast rotor speed of 420?rpm, which was associated with negligible wood injury. Mechanical thinning induced firmer and sweeter fruit, i.e. tastier apples with longer shelf life, relative to control fruit from non-thinned apple trees. The greatest efficacy in terms of final fruit quality in the grading/sorting was achieved by a rotor speed of 360?rpm at a tractor speed of 5?km/h: Fruit mass increased by up to 20?g and the proportion of fruit larger than 70–75?mm by 10–30% compared with the fruit from non-thinned trees. Mechanical thinning with this newly constructed device led to a 10–20% reduction in yield, but increased returns due to better fruit size and colouration in apple with the potential to overcome alternate bearing.     

不同施肥处理对枳及柠檬容器苗生长的影响

研究9个不同施肥处理对枳及柠檬容器苗生长的影响。结果表明:不同施肥处理对枳容器苗的苗高、地径、分枝高度及嫁接后柠檬苗的发芽率、株高、茎粗、分枝数及生物量都存在显著差异;不同施肥处理对枳及柠檬容器苗综合表现最好的为T4(撒施柠檬专用肥1.6 g)处理,其次是T2(撒施尿素0.6 g)、T3(撒施柠檬专用肥0.8 g)处理,表现最差的是T8(浇施5%柠檬专用肥)和T7(浇施3%柠檬专用肥)处理。在一定施肥浓度范围内,施肥对嫁接后柠檬容器苗的生物量积累有明显促进作用。柠檬容器苗培育时建议采用在基质中撒施柠檬专用肥1.6 g。     

大豆质核互作雄性不育系NJCMS1A与其保持系NJCMS1B的生理生化特性比较分析

以大豆质核互作雄性不育系NJCMS1A及其保持系NJCMS1B的花芽为试验材料,利用试剂盒法和紫外分光光度计测定分析了糖分含量(可溶性糖和淀粉)和总ATPase、蔗糖磷酸合成酶(SPS)、磷酸烯醇式丙酮酸羧激酶(PEPCK)、抗坏血酸氧化酶(AO)、过氧化氢酶(CAT)、超氧化物歧化酶(SOD)以及过氧化物酶(POD)等酶活性的变化情况。结果表明:相较于保持系NJCMS1B,总ATPase、PEPCK、AO和CAT活性在不育系NJCMS1A中显著下降;糖分含量、SPS和SOD活性在不育系NJCMS1A中下降水平不显著;POD活性在不育系NJCMS1A中显著上升。根据结果分析推测,与能量代谢或胁迫响应等相关的物质或酶活性在不育系NJCMS1A中的亏损现象可能是NJCMS1A花粉败育的主要原因。     

Interspecific cross‐hybrids of Nicotiana tabacum L. cv. (gla.) S ‘K326’ with Nicotiana alata

In order to introduce the Tomato Spotted Wilt Virus (TSWV) resistance from Nicotiana alata into Nicotiana tabacum, a cytoplasmic male sterility (CMS) line of N. tabacum (N. tabacum L. cv. (gla.) S ‘K326’), was successfully crossed with N. alata. Despite a high DNA content variability, F₁ hybrids could be classified in two subgroups, a major one encompassing fertile hybrids morphologically similar to their tobacco maternal parent but TSWV sensitive, and a minor one displaying sterile hybrids showing an intermediate phenotype and TSWV resistant. In order to elucidate the unexpected fertility recovery of the fertile F₁ plants, some N. alata fertility restoration ppr genes were cloned and were shown to be differentially expressed between parental lineages as well as between both F₁ subgroups, suggesting that N. alata contains fertility restoring allele able to overcome the CMS of N. tabacum.